Intellifin Water Heater Startup Forms

Transcript

INTELLI-FIN INSTALLATION AND START-UP CHECKLIST Model Number: Job Name: Serial Number: Address: Start-up Date: Neuron ID # (located on rear of unit adjacent to terminal connections): _______________________________ How many units are Retrofit: Nat. Gas: installed at this location? ________ New: Propane: Water Boiler(s): ______ Htr(s): _______ City: State: Zip: Type of building: Total Btu/hr reqm’t of all gas equipment at this location? Btu/hr: If gas pipe, regulator and meter are not sized correctly, list the discrepancies: Inspect gas pipe, regulator and meter sizing. Is it sized correctly for the Btu/Hr requirement? Yes or No: _________ Gas Supply Incoming Incoming Dynamic Pressure: (record values in Static Pressure: inches of water column) (no units operating) Supply Voltage VAC: (all units operating) Bleed air from the by-pass piping by opening bleed valve in pump housing. (unit operating) Comments: Is the bleed valve and tubing properly installed? Yes or No: Disconnect the by-pass valve wire harness. Depress clutch release on valve actuator. Manually move valve to CLOSED position. (Arrow pointer on valve handle indicates closed at 0o and full open at 90o.) NEVER MOVE HANDLE WHILE POWER IS APPLIED TO THE VALVE. water - At 100% fire, read and record: Inlet Temp: Outlet Temp: Comments: Delta T: Reconnect by-pass wire harness and observe the cold start-up process by-pass synchronization process. Yes or No: ___________ venting Vertical Flue: Flue dia. (in.): Horizontal Flue: Flue material: Equivalent Flue length (ft.): Drain T installed with trap loop? Yes or No: Drain T piped to - Drain: (check one) Neutralizer tank: Corrections needed for flue venting: AIR INLET Vertical Pipe (ft.): Pipe dia. (in.): Pipe material: Horizontal Pipe (ft.): Combustion and ven- tilation air openings: Clearance between air inlet and flue outlet (in.): Corrections needed to air inlet piping or openings: (direct vent installation) Heat exchanger piped to - Neutralizer tank: (check one) Drain: Equivalent Pipe length (ft.): Louver openings (total sq. in.): Modem phone number: List all remote mounted control devices installed: clearances - Measure and record (inches) the service clearances from the nearest obstruction (min. 24” required for service): Front: Rear: Top: Construction filter in place Removed before upon arrival? Yes or No: departing? Yes or No: List any corrections req’d for service clearances: Final Settings Set Point (oF): Max. Set Point: O.A. Min: Command display password? Operating sensor: Sequencing type: Heater ID: Unit operating when you left jobsite? Yes or No: Start-up performed by: Start-up approved by: Company: Company: Name: Name: Phone: Phone: Send completed form to: Internal Use: Email: [email protected] S/O #: Fax: (615)882-2963 Routed: Mail: Service Dept/Lochinvar 300 Maddox Simpson Pkwy. Lebanon, TN 37090 Tech: App: Denied: Save then Submit Form