Preview only show first 10 pages with watermark. For full document please download

Introduction Cable Connection I Wiring Direct Drive Iris Installation

   EMBED

Share

Transcript

Thank you very much for purchasing this CCTV lens. Before using the lens, please read this manual carefuliy to avoid usage mistake. Introduction Cable Connection I Wiring .This lens connector and its cable connection are standard for mono-focal and van-focal lenses. Refer to Figure 1 and 2. Improper connection of the lens to a camera may cause malfunction or even damage to the lens or camera and is not covered by the warranty. This lens is designed forCCD cameras. Please refer to the label(s) on lens body and box for Image Format and Mount of the lens. Make sure that the lens mount type matches the camera mount type. Direct Drive Iris This lens is designed to be used with a camera with a built-in auto ins amplifier. The Auto Ins in the lens is operated by DC signal from camera. 8 Gatvanometer 8 Cable . . Focus Lock Pin Installation To instali the lens, face the mount point on the CCTV camera towards you. Screw the lens clockwise into the mount point to its mechanical stop position. Refer to Figure 1. Plug the cable into the corresponding socket on the camera. Figure 1 To remove the lens, pull out the cable from the socket on the camera, and turn the lens counterclockwise. Lens Focusing (Van-focal models)The lens can be adjusted within its specified focal length range. Re-focusing is required after adjustments to the focal length. Fasten the two focus lock pins after focusing. (Mono-focal models) Make focusing to the lens and fasten the lock pin. :;:ell -:J$ Damping Coil Yellow --.EB J Driving Coil Black