Transcript
I NTRODUCTION
FEATURES
At "WITEC'' we have made a committment to providing the finest car audio loudspeakers in the world. Completely designed in the United States, '' WITEC" amplifiers have become some of the most demanded car audio products in the U.S. and abroad. This same committment has now been implemented with '' WITEC ''amplifiers. Our complete in-house technology and support team will always be ready and waiting to assist you in any way.
Pulse Width Modulated Power Supply
I would like to thank you and congratulate you on your purchase of America's Best Car Amplifiers. With this purchase, you are assured of our ample support direct from your '' WITEC ''authorized dealer and from qualified factory personnel.
High performance into 2 Ohm loads
MOSFET circuitry Tightly regulated power supply Full amplifier protection against shorts, D.C.
Complementary amplifier design Wide input sensitivity range
Again, let me thank you for helping make '' WITEC ''
Gold-plated RCA sockets Advanced radial fin heatsink design Thump-free on/off function Time-delayed turn-on
&
thermal
SPECIFICATION BUILT-IN ELECTRONIC TREBLE AND BASS
Output Power 4ohm
50W/Ch
Output Power 2ohm
75W/Ch
Output Power 1 ohm
N/A
Output POWER 0.5ohm
N/A
Bridged 4ohm
150W
Bridged 2ohm
N/A
Bridged 1 ohm
N/A
THD 4 Ohm load
l ess than 0.5%
I MD 4 ohm load
l ess than 0.5%
Noise below rated Output (db)
The BASS is adjustable from 0-18dB Boost at 60Hz
90 BASS FREQUENCY
Frequency response @ rated power
10Hz - 30KHz
I nput sensitivity
100mv - 1 V
I nput impedance
10 Kilo Ohms
Protection
All units are protected against reverse polarity Thermal overload, D.C. and shorts leads.
Maximun current 4 ohm loads (amps)
17
Fuse(amps)
20
Dimensions
The TREBLE is adjustable from 0-12dB Boost at 10KHz
All units are 10.433 inches wide, 2.362 inches high
Length (inches)
8.23
Weight(1 bs.)
1.3
TREBLE FREQUENCY
I NSTALLATION PROCEDURES STEREO MODE Normal Stereo Operation
Mount the amplifier in a suitable location, preferably in the trunk or under one of the front seats. Bolt the supplied fuse holder within 12" of the car's battery (this protects the vehicle's electrical system against overload should the amplifier fail or the 12 volt lead should short against ground). Use only the correct fuse type for that amplifier. Connect the black power wire of the amplifier to a good rust-free ground as close to the amplifier's location as possible. Extend the 12 volt positive cable to the amplifier's location using #8 wire or larger only. Connect the RCA inputs of the amplifier to the signal source using high quality RCA cables. Connect the remote turn-on wire to the head unit's 1 2 volt output. Connect the speakers as shown in the diagram. If no module has been plugged in, then the line outputs on the front panel have no signal output.
