Transcript
IP Pro™ Access Control Solution Single Door Electric
Strike Application
1 Access Control
AC Mains
IP Network
IP Controller
IPDCE
1
2
2 Power Supply 12 and 24VDC Output OPTIONAL BATTERY BACKUP RB12V4-2
602RFX12VR
3
3 Wiegand Reader Options
(Choose one):
Prox Reader or Keypad-Prox Combo
4
OPTIONAL CREDENTIALS Fobs - HID1346-10 Cards - HID1326-25
920PW
IPRW
923PW
4 Electric Strike
(Choose one):
Centerline Latch Entry or No Center Line Relocation*
*
45-A
25-4U
(800) 413-8783
55-ABCU
■
SYSTEM OPERATION Door is normally closed and secured by an electrified lockset.
Emergency Override: The door may be accessed by key override.
Authorized Access: Presenting a valid card or entering a valid user code on the reader will momentarily unlock the door for access. The unlock time will be configured by the access control programming. The door may also be programmed for maintained access.
Low Voltage: System is powered by a regulated & filtered power supply with 12VDC output for access control equipment and 24VDC output for locking hardware to maximize efficiency. Loss of power will result in unsecure door, unless equipped with optional battery back-up.
Authorized Egress: Free egress is available at all times by turning the inside lever, retracting the latchbolt, and opening the door.
IP-based Access Control: User-friendly programming interface via a built-in web server, accessible from any networked PC.
www.SDCsecurity.com
SDC P/N: 602RFX12VR
AC Mains
IP Network
Cat5 (or better)
(3) COND
602RF
12VR
IP Pro Door Controller
602RF Power Supply x 12VR
(2) 18/2C
-+
-+
18/4C
TO 120VAC PRIMARY VOLTAGE CONNECTION
24
Battery Input Terminals
SDC P/N: IPRW 12VDC
+
22/6C
-
12
DC Voltage Output Terminals
+
VOLTAGE SELECTION SWITCHES (SET FOR 24VDC)
-
FACTORY INSTALLED JUMPER (REMOVE ONLY IF FIRE ALARM INTERFACE IS CONNECTED)
C
24VDC
-
SENSE CLOCK/D1 DATA/D0 +12V 0V RED GREEN
Electric Strike
SDC P/N: 923PW
MAINS PRESENT
2-16 DOORS 17-32
B/GL TAMP
A B 0V A B 0V
OP3 OP2 0V AUX 1 DC PB
Entry Card Reader
0V +12V
+ SDC P/N: 920PW
RB12V4 5 AMP HOUR BATTERY
+
-
RB12V4 5 AMP HOUR BATTERY
SDC P/N: RB12V4-2 SDC P/N: IPDCE
IP Pro™ Door Controller (Door #1)
Ethernet
AUX RELAY MAIN RELAY
RJ-45
1 2
OFF
NC C NO NC C NO
DHCP
To PC or Local Network
DEFAULT
System Components: (1) 602RFX12VR – 1 Amp Regulated Power Supply w/ Fire Alarm Interface & 12VDC Output Module. (1) IPDCE – IP Pro™ Single Door Controller 55 Series Strike (Fail-secure)
SDC P/N: 45-A (Fail-secure, 24VDC Configuration)
BLU RED (+)
24VDC Pigtail (included)
SDC P/N: 55-AU (Fail-secure, 24VDC Configuration)
Power Connector
BLK
MOV *
WHT(-)
RED WHT
BLK
Power Connector
MOV *
GRN(-)
© 2015 Security Door Controls Printed in U.S.A
801 Avenida Acaso Camarillo, CA 93012 t 805.494.0622 ~ f 805.494.8861 www.sdcsecurity.com
Choose (1) Electric Strike: 45-A – Universal Electric Strike for use with locksets having up to 3/8" latchbolts, UL Listed, 630 55-AU – Universal Heavy-duty Grade 1 Strike for cylindrical locks, mortise locks without deadbolts and mortise exit devices 25-4U – Low-Profile Electric Strike, 630
SDC P/N: 25-4U (Fail-secure, 24VDC Configuration)
MOV*
RED (+) BLU
Choose (1) Card Reader: IPRW – Indoor/Outdoor Proximity Card Reader 920PW – Single Gang Indoor/Outdoor Proximity Card Reader w/ integral Keypad 923PW – Frame mount Indoor/Outdoor Proximity Card Reader w/ integral Keypad
*To protect against inductive kickback, MOV must be installed as close to strike as possible. MOV included with IPDCE and strike. NOTE: ALL WIRING MUST BE REVIEWED AND APPROVED BY THE PROJECT ENGINEER ASSIGNED TO THE LOCATION FOR ITS CORRECTNESS AND SUITABILITY FOR THE APPLICATION IN WHICH THE EQUIPMENT IS INSTALLED AND OPERATED. ALL WIRING MUST CONFORM TO NATIONAL, STATE, AND LOCAL CODES FOR CLASS 2 FIRE PROTECTION AND CONTROL DEVICES.
(1) RB12V4-2 – Two 5Ah 12VDC Backup Batteries (Optional) (1) HID1346-10 – Ten Proximity Key Fobs (Optional) PROJECT NAME:
TITLE: DIST.:
LOCATION.:
--
SO NO.:
IP Pro™ 1-Door System with Electric Strike
IP Pro Single Door Applications
CONTACT:
-
[email protected]
DATE:
07/2015
DRAWN BY:
-
-
DWG. NO.:
IPPRO Apps
REV
-
Page 11 of 11
