Isidore Roman Tub Faucet Installation Instructions

Transcript

ISIDORE ROMAN TUB FAUCET INSTALLATION INSTRUCTIONS Before installing, read entire Roman Tub Faucet Installation Instructions. Observe all local building and safety codes. For the following installation instructions for your new Roman Tub Faucet it is assumed that any old fixtures have been removed and any repairs or modifications to the water supply have been completed. Unpack and inspect the product for any shipping damages. If you find damages, do not install. Contact Customer Service at 1-866-855-2284. If you need assistance or have questions while installing your faucet, contact Customer Service. We recommend consulting a professional if you are unfamiliar with installing plumbing fixtures. Signature Hardware accepts no liability for any damage to the floor, walls, plumbing or for personal injury during installation. Turn off the water supply at the faucet installation location. TOOLS AND MATERIALS: Adjustable Wrench Basin Wrench INSTALLATION 1. Disassemble each handle by removing the handle lever (2) and handle base (3) from the handle bolt (4). 2. Insert the handle bolts (4) up through the mounting holes. Thread the handle bases (3) and handle levers (2) onto the handle bolts. 3. With both handles in the OFF position, tighten the lock nut (5) on the bottom of the handle bolts with a basin wrench. 4. Disassemble the faucet body (1) by removing the faucet body lock nut (7), and washer (6). 5. Thread the tap body (1) through the center mounting hole. Thread the deck seal washer (6), and faucet body lock nut (7) onto the threaded bolt beneath the counter top to secure. 6. Attach the hot and cold water feed hoses (8) to the outlets on the handle bolts (4). (Hot water is always on the left and cold water is always on the right.) 7. Connect the main water supply to the inlets on the handle bolts (4). 8. Follow steps 1-7 listed above to install the diverter (9) and hand shower (10). Attach the water feed hoses (8) accordingly. 9. After all connections have been made, turn on the water supply, check to make sure that all connections are tight (no water should be leaking) and that the hot and cold supplies are working correctly. Turn the faucet on and allow the water to flow through the spout for approximately 60 seconds. Divert the water to the hand shower and allow the water to flow through the hose for an additional 60 seconds Isidore Roman Tub Faucet Installation Instructions 1 (11 ) Aerator Tool (2) Handle Lever (1) Faucet Body (3) Handle Base (4) Handle Bolt (5) Lock Nut (9) Diverter (6) Washer (7) Faucet Body Nut (10) Hand Shower (8) Hoses Isidore Roman Tub Faucet Installation Instructions 2