Preview only show first 10 pages with watermark. For full document please download

It-as411 Series 4x1 Audio Switching With Voice Lift Mixing Audio Products Group

   EMBED


Share

Transcript

4x1 Audio Switching with Voice Lift Mixing Audio Products Group The IT-AS411 Series Audio Switchers are 4x1 audio switchers that have an extra mic/line level input for a voice lift system or direct microphone input. All models have four switched program audio inputs and an independent mic or line level input that is summed (mixed) with the selected active program audio. FEATURES All models have balanced or unbalanced input and output capability. DIP switches are provided to set the voice input level to mic or line, adjust microphone sensitivity, set phantom power and select mono or stereo operation. They also have adjustable volume control buttons and mute for both the program audio and voice inputs. Each individual program audio trim (gain), program audio input select, muting and volume control can be executed locally by front panel pushbuttons, muting by external dry contact closure and additional commands via RS-232 serial control. On board LED’s monitor; program, input select, volume level and mute status. • Terminals for remote muting of voice and/or program audio via dry contact closure The IT-A411-25M70 features a 25W mono internal audio amplifier to drive either a 4 to 8 ohms speaker or a 70V line output, preamp out. • Mic / line level voice lift input • Program audio / voice lift mixing • Program audio inputs and outputs • Serial control with serial pass-through • On board LED’s monitor; input select, volume level and muting status • Current limited remote LED output terminal for program audio and voice (mute) status • Integrated audio amplifiers on A25-M70 and A25-S8 models • Program audio trim (gain) • Preamplifier output DVD/BLU-RAY TUNER ON OFF 1 2 3 4 1 0 POWER 12VDC/0.2A AMPLIFIER MODE P O C P O C SWITCH SEE BOTTOM FOR DETAILS 3 NTELLI- OOLS MODEL: IT-R4 CONTROL INPUTS A B C D E RELAY 4 fsrinc.com 800-332-FSR1 1 RELAY FSR IT-R4S OR OTHER SERIAL CONTROLLED DEVICE 2 P O C P O C Loop Out Tx Rx POWER CORD (INCLUDED) Power + 24VDC 2.5A Function Down/Up SW 'Voice In' Type Mic/Line 1 Mic Sensitivity -60/-45 2 Phantom Power On/Off 3 Audio Output Mono/St. 4 Vo PR Tx Rx Serial In Mute L R L 2 R Audio Program In Preamp Stereo Audio Out + - Sh Options Voice In Select 1 + - Sh + - + - Sh + - 1234 Left Right + - Sh + 3 +L- Sh +R- +L - Sh +R- 4 Model IT-AS411 -25S8 Amplified Stereo Audio Out Left + FSR Right - + - 25W/ch. RMS Max. Bridgeable SATELLITE RECEIVER RS 232 CONTROL The IT-A411-25S8 offers a 25W stereo output internal audio amplifier to drive a either a 4 to 8 ohms speaker, preamp out. MUTE SWITCHES STEREO SPEAKERS PC OR MIC OR VOICE LIFT SYSTEM VCR FSR Inc. 244 Bergen Boulevard, Woodland Park, NJ 07424 Phone: 973.785.4347 · Fax: 973.785.4207 Order Desk: 1-800-332-FSR1 Web: www.fsrinc.com · E-mail: [email protected] LIT1350 IT-AS411 Series IT-AS411 Series IT-AS411 Series IT-AS411 SPECIFICATIONS Program Audio Input Program Inputs: 4, Stereo balanced/unbalanced Microphone Inputs: 1 Connector Type: Pluggable screw terminal Maximum Input Level: 7.5dBV Input Impedance: 20kΩ balanced/unbalanced “Voice-in type” Input Connector Type: Pluggable screw terminal ‘Voice in’ Type: Microphone/Line Maximum input level: 1dBV Microphone Sensitivity: -43dB/-35dB Low cutoff: 200Hz Phantom power: 24V Preamp Audio Output Number of outputs: 1 Stereo or 2 Mono (L + R program audio input summed) Signal output: Balanced/unbalanced Frequency response: 20Hz – 20kHz (+/- 0.5dB) THD + N: <0.09% @ 11dBV with 600Ω load (balanced) Signal to Noise ratio: 80dB Output impedance: 50Ω Power Dimensions: Shipping Weight: 24 VDC 0.5A Half Rack x 1U 3.5 lbs. DEPTH IS APPROXIMATELY 6.00" FSR 1.59 Ext. Override Ext. Override INPUT SELECT PROGRAM MUTE 1 3 2 VOLUME 4 VOICE MUTE VOLUME IT-AS411 8.47 Loop Out Tx Rx Power 24VDC 0.5A + Function 'Voice In' Type Mic Sensitivity Phantom Power Audio Output Vo PR Tx Rx Serial In Mute Down/Up Mic/Line -60/-45 On/Off Mono/St. SW 1 2 3 4 L R L 2 R Audio Program In Preamp Stereo Audio Out 1234 + - Sh Options Voice In Select 1 + - Sh + - + - Sh + - Left Right + - Sh + 3 +L- Sh +R- +L - Sh +R- 4 Model IT-AS411 FSR IT-AS411 Series IT-AS411-25S8 SPECIFICATIONS Program Audio Input Program Inputs: 4, Stereo balanced/unbalanced Connector Type: Pluggable screw terminal Input sensitivity: -20dBV with 8Ω load Input Level: 7.5dBV Input Impedance: 20kΩ balanced/unbalanced Power Dimensions: Shipping Weight: 24 VDC 2.5A Half Rack x 1U 3.5 lbs. “Voice in type” Input Connector type: Pluggable screw terminal ‘Voice in’ type: Microphone/Line Microphone sensitivity: -43/-35dB Maximum input level: 1dBV Low cutoff: 200Hz Phantom power: 24V Preamp Audio Output Connector type: Pluggable screw terminal Number of outputs: 1 Stereo or 2 Mono (L + R program input summed) Signal output: Balanced/unbalanced Frequency response: 20Hz – 20kHz (+/- 0.5dB) THD + N: <0.09% @ 1kHz; 11dBV with 600Ω load (balanced) Signal to Noise ratio: >80dB @ 1 kHz; rated output (unweighted) Output impedance: 50Ω Amplifier Audio Output Connector type: Pluggable screw terminal Number of outputs: Stereo or 2 Mono (L + R program input summed) Frequency response: 20Hz – 20kHz (+0, -1dB) THD + N: <0.7% @ 1kHz; 25Wrms 8Ω Signal to Noise ratio: >80dB @ 1kHz; rated output (unweighted) Load impedance: 4 to 8Ω Power output: 25Wrms @ 4 to 8Ω DEPTH IS APPROXIMATELY 6.00" FSR 1.59 Ext. Override Ext. Override INPUT SELECT PROGRAM MUTE 1 3 2 VOLUME 4 VOICE MUTE VOLUME IT-AS411 8.47 Loop Out Tx Rx Power + 24VDC 2.5A Function 'Voice In' Type Mic Sensitivity Phantom Power Audio Output Vo PR Tx Rx Serial In Mute Down/Up Mic/Line -60/-45 On/Off Mono/St. SW 1 2 3 4 L R L 2 R Audio Program In Preamp Stereo Audio Out Left 1234 +- Options Voice In Select 1 + - Sh + - + - Sh + - Right +- +- Sh Sh 3 +L- Sh +R- +L - Sh +R- 4 Model IT-AS411 -25S8 Amplified Stereo Audio Out Left Right + - + - 25W/ch. RMS Max. Bridgeable FSR IT-AS411 Series IT-AS411-25M70 SPECIFICATIONS Program Audio Input Connector type: Pluggable screw terminal Program Inputs: 4, Stereo balanced/unbalanced Input sensitivity: -20dBV with 8Ω or 70V load Maximum Input Level: 7.5dBV Input impedance: 20kΩ balanced/unbalanced Amplifier Audio Output Connector type: Pluggable screw terminal Number of outputs: 2 Mono1 Frequency response: 100Hz – 20kHz (+0, -1dB) -3dB @ 50Hz THD + N: <0.8% @ 1kHz 25Wrms 70V <0.7% @ 1kHz 25Wrms 8Ω Signal to Noise ratio: 80dB @ 1kHz (unweighted) Load impedance: 4 to 8Ω or 70V Power output: 25Wrms @ 4 to 8Ω 25Wrms @ 70V “Voice in type” Input Connector type: Pluggable screw terminal ‘Voice in type’ mode: Microphone/Line Microphone sensitivity: -43/-35dB Maximum input level: 1dBV Low cutoff: 200Hz Phantom power: 24V Power Dimensions: Shipping Weight: Preamp Audio Output Connector type: Pluggable screw terminal Number of outputs: 1 Stereo or 2 Mono (L + R program audio input summed) Signal output: Balanced/unbalanced Frequency response: 20Hz – 20kHz (+/- 0.05dB) THD + N: <0.09% @ 1kHz 11dBV with 600Ω load (balanced) Signal to Noise ratio: >80dB @ 1kHz (unweighted) Output impedance: 50Ω 1 24 VDC 1.25A Half Rack x 1U 3.5 lbs. Use only one output type (4-8Ω or 70V) in a particular installation. DEPTH IS APPROXIMATELY 6.00" FSR 1.59 Ext. Override Ext. Override INPUT SELECT PROGRAM MUTE 1 3 2 VOLUME 4 VOICE MUTE VOLUME IT-AS411 8.47 Loop Out Tx Rx Power 24VDC 0.5A + 1.25A -25M70 Only Function 'Voice In' Type Mic Sensitivity Phantom Power Audio Output Vo PR Tx Rx Serial In Mute Down/Up Mic/Line -60/-45 On/Off Mono/St. SW 1 2 3 4 L R L 2 R Audio Program In Preamp Stereo Audio Out 1234 + - Sh Options Voice In Select 1 + - Sh + - + - Sh + - Left Right + - Sh + 3 +L- Sh +R- +L - Sh +R- 4 Model IT-AS411 -25M70 Amplified Mono Audio Out 4-8 Ω FSR 70V + - + - 25W/ch. RMS Max. Use only 1 output type FSR Inc. MADE IN THE USA Specifications are subject to change without notice. 244 Bergen Boulevard, Woodland Park, NJ 07424 Phone: 973.785.4347 · Fax: 973.785.4207 Order Desk: 1-800-332-FSR1 Web: www.fsrinc.com · E-mail: [email protected]