Transcript
3 x 4096 pixels
16KHz
CL
3CMOS
LT-400 CL
3 CMOS RGB Line Scan Camera
www.jai.com
W W W. S T E M M E R- I M A G I N G . C O M
Ser
Interf ial e ac
rs 232c on trol Too
l
3 CMOS line scan camera with Camera Link output Dichroic RGB beam splitter prism with 3 sensors 3 sensors with 4096 pixels, 7 µm x 7 µm Low-noise operation (S/N: 55 dB) providing superior image quality 28.672 mm sensor scan width 3 x 8 bits or 3 x 10 bits output through Camera Link interface Line rate up to 16180 lines per second at 80 MHz pixel clock One-push auto white balance Flat field correction and color shading correction Knee and binning functions for extended dynamic range and sensivity Sub-sampling and windowing readout Set-up and installation aid with built-in test generator Available with M52 mount (standard) or Nikon F-mount Short ASCII commands for set-up via RS 232C or Camera Link Setup by Windows XP software
C
4-M3 depth5 (depth0.20)
28.672 mm
S/N ratio
55 dB on green with gain = 0 dB 24 bit (3 x 8) in CL base configuration 30 bit (3 x 10) in CL medium configuration
Individual mode
Master: 0 dB to +8 dB R/B: –4 dB to +14 dB Analog gain= Low (0dB) or High (+6dB) R/G/B: –4 dB to +14 dB Analog gain= Low (0dB) or High (+6dB)
White balance
Manual, fixed or one-push Adjustable range 4000 K to 9000 K Fixed: 4000 K, 4600 K or 5600 K
Knee function
Individual RGB knee point and slope
Shading correction
Individual RGB flat or RB to G
Flat-field correction
Two point pixel-to-pixel correction
Synchronization
Pin 1 2 3 4 5 6 7 8 9 10 11 12 13
Internal X-tal or external trigger
Trigger modes
No-shutter, shutter-select and pulse width control
Programmable exposure
60µs to 14.9 msec. in 12.5 ns increments
Functions controlled by RS 232C or CL
Trigger modes, scan rate, exposure time, gain/ black level, shading correction, flat-field correction, white balance, knee-function, diagnostics
Diagnostics
Test pattern generator. (Color bar, gray pattern and white) LED for power
Lens mount
M-52 mount. (Standard) Nikon F-mount. (Factory option) Better than ±0.1 pixel
Operating temperature
-5°C to +45°C/20 – 80% non-condensing
Storage temp./humidity
-25°C to +60°C/20 – 80% non-condensing
Vibration
50G
Regulations
Emission: CE CISPR Pub. 22 (EN55022) Immunity: CISPR Pub. 24 4 ×6 depth3.5 IEC61000-4-2 Conforming level 4 4-M3 depth3.5 (depth0.14) FCC Part15 Class B (depth0.14) 90 RoHS (3.54)
830 g
Bottom view 32.5
40 (1.57) 6.3 (0.25) 6.3 (0.25)
Camera Link connector Part 1
80 70 60
POWER/ TRIG
Gch Gch Bch Bch Rch Rch
40
W.B. DC IN / TRIG
30 SW1
20
Ordering Information
10
3 CMOS RGB Line Scan Camera. F-mount
500
600
700
800
Camera Link connector Part 2
wavelength (nm)
32.5 (1.28) (7) 25.5 (0.28) (1.00)
60 (2.36)
FCC seal
LT-400 CL -F
0 400
×6 depth3.5 (M52) (depth0.14)
Serial No.
3 CMOS RGB Line Scan Camera. P-mount
M52 Mount
40 (1.57)
LT-400 CL-M52
4
+0.012 0
32.5 (1.28) 25.5 (1.00)
Camera Link conn
Camera Link conn
HIROSE 12-pin Connector
Asia Pacific Phone +81 45 440 0154 Fax +81 45 440 0166
Americas Phone (Toll-Free) 1 800 445 5444 Phone +1 408 383 0300
Visit our web site on www.jai.com
Imaging is our passion. www.stemmer-imaging.com
STEMMER IMAGI NG Head Office Gutenbergstraße 9 - 13, D-82178 Puchheim Phone: +49 89 80902-0,
[email protected]
August 2011
4-M3 depth5 (depth0.20)
Europe, Middle East & Africa Phone +45 4457 8888 Fax +45 4491 3252
POWER/ TRIG W.B. POWER/ TRIG W.B. SW1
SW1
Camer
HIROSE 12-pin Co
Rear view 6.3 (0.25)
50
4(d
HIROSE 12-pin Co Camer
4-M3 depth5 (depth0.20) 4-M3 depth5 (depth0.20)
90
7 (0.28)
(7) (0.28)
60 (2.36) 60 (2.36)
(1.28) 32.5 (7) 25.5 (0.28) (1.28) (1.00) (7) 25.5 (0.28) (1.00)
60 (2.36)
(3.54) LT-400 CL(0.28) Spectral response Sensor LT-400CL Spectral(incl. response (incl.sensitivity) Sensor sensitivity)
32.5 (1.28 25.5 25.5 (1.00) (1.00 32.5 (1.28)
(7) (7) (0.28) (0.28)
4-M3 depth5 (depth0.20)
90
50 (1.97)
Weight
Nikon F-mount
100
90 (3.54)
90 mm x 90 mm x 90 mm (without connector and lens mount protrusion)
25.5 (1.00) 32.5 Response (1.28) 7
70 (2.76)
70 (2.76)
Dimensions (H x W x D)
Spectral
transmittance (%)
12V DC to 24V DC ± 10%.
16 X1-/X1+ CL Data 17 X2-/X2+ CL Data 18 Xclk-/Xclk+ CL Clk 19 X3-/X3+ CL Data 20 SerTC+/SerTC- Serial in * 21 SerTFG-/SerTFG+ Serial out * 22 CC1-/CC1+ Trigger * M52 Mount +0.012 23 CC2-/CC2+ Reserved 4 0 ×6 depth3.5 Mount +0.012 24 CC3-/CC3+ used (depth0.14)NotM52 4 0 ×6 depth3.5 25 4-M3 CC4-/CC4+ depth5 (depth0.14)Not used 26 (depth0.20) GND
(7) (0.28)
+0.012 0
Power
+0.012 0
*) In Camera Link or 12 pin Hirose Note: Camera Link base configuration shown. For medium configuration refer to Camera Link specifications or operation manual.
3G (20Hz to 200Hz, XYZ direction)
Shock
+0.012 0
4
+0.012 0
×6 depth3.5 25.5 (depth0.14) (1.00) 25.5 32.5 60 (1.00) (2.36) Side view(1.28) 32.5 60 (2.36) (1.28) 7 90 (0.28) (3.54) 7 90 (0.28) (3.54) (7) (0.28) (7) (0.28)
40 (1.57)
Sensor alignment
+0.012
×6 depth3.5 (depth0.14) 4-M3 depth3.5 ×6 depth3.5 (depth0.14) (depth0.14)90 4-M3 depth3.5 Signal Function (3.54) (depth0.14) 14 GND 90 70 (2.76) (3.54) 15 Xo-/Xo+ 70 CL Data (2.76) 4
×6 depth3.5 (depth0.14)
φ4 0 depth3.5 4-M3 depth3.5 (depth0.14) (depth0.14) 90 (3.54) 70 (2.76) 4-M3 depth5 (depth0.20) 4-M3 depth5 (depth0.20)
Camera Link Interface
4
M52 Mount
+0.012 0
DIGITAL I / O - 1
Master tracking
4
Ground +12V to +24V DC Ground Reserved Ground RXD RS 232C* TXD RS 232C* Ground XEEN output Trigger input (TTL)* NC Ground
50 50 (1.97) (1.97) 90 90 (3.54) (3.54)
Video output
1 2 3 4 5 6 7 8 9 10 11 12
90 (3.54)
Pin
2800 Lux (7800K, gain=low, shutter=OFF, 100% video)
50 (1.97)
Sensitivity on sensor
HIROSE HR10A-10R-12PB-71
FCC seal FCC seal
Sensor sensitivity
40 (1.57)
3 x 4096 (h) 3 x 2048 (h) with 2:1 binning Radiometric: 64V(µJ/cm2)
70 40 40 (2.76) (1.57) (1.57)
Active pixels
50 (1.97)
7 (h) x 7 (v) µm
40 40 (1.57) (1.57)
Cell size
7 (0.28) 4-M3 depth5 (depth0.20)
90 (3.54)
3 CMOS line sensors mounted on RGB beam splitter prism
Sensor scanning width
Gain
4-M3 depth3.5 (depth0.14) 90 (3.54) 70 (2.76)
61.8µs (Full resolution/binning/internal trigger) 61.8µs~15.02ms, 12.5ns increments
25.5 (1.00 32.5 (1.28)
×6 depth3.5 (depth0.14)
70 (2.76)
Sensor
(7) (0.28)
+0.012 0
DIGITAL I / O - 2
Standard Programmable
4
40 (1.57)
80.00 MHz
70 70 (2.76) (2.76)
Line rate
Front view
DC In / Trigger
Line sensor with internal clock
Pixel clock
Serial No. Serial No.
Scanning system
Dimensions
Connection Pin-out
K-JAIO1-02/2015 ∙ Subject to technical change without notice. No liability is accepted for errors which may be contained in this document.
LT-400 CL
Company and product names mentioned in this datasheet are trademarks or registered trademarks of their respective owners. JAI A·S cannot be held responsible for any technical or typographical errors and reserves the right to make changes to products and documentation without prior notification.
Specifications
40 (1.57)
Specifications for LT-400 CL
