Transcript
just slightly ahead of our timt
Your new TV
Monitor/Receiver
features a solid
Television
Location
state chassis that is designed to give you many years of enjoyment, tt was thoroughly tested and tuned at the factory for best performance.
This unit is intended to be used with an optional stand or entertainment center. Consult your dealer
Customer
for available options. [3 Avoid excessive
Record
sunlight or
bright lights,
including reflections.
The model and serial number of this product may be found on the back of the unit. You should note the model and serial number in the space provided and retain as a permanent record of your purchase. This will aid in identification in the event of theft or loss. Productregistrationis availablefor U.S. customersat: www.prodreg.com/panasonlo
{3
Keep away from excessive heat or moisture. Inadequate ventilation may cause internal component failure.
{3
Fluorescent lighting may Control transmitting range.
[3
Avoid magnetic equipment, including motors, fans, or external speakers.
reduce
Remote
Optional Cable Connections Model Number
Shielded audio and video cables should be used between components. For best results: Use 75-ohm coaxial shielded cables.
Serial Number
Use
appropriate
input
and
output
connectors that match your component connectors.
Care
Avoid long interference.
and Cleaning Screen (Turn TV Off)
to
minimize
AC Power Supply Cord
Use a mild soap solution or window cleaner with a soft clean cloth. DO NOT USE ABRASIVE CLEANERS.
CAUTION:
TO
PREVENT
ELECTRIC SHOCK, MATCH WIDE BLADE OF PLUG TO WIDE SLOT OF AC OUTLET
Avoid excessive moisture and wipe dry.
Cabinet and Remote Control
Polarizedplug
AND FULLY INSERT. DO NOT USE A PLUG WITH A
Use a soft cloth dampened with water or a mild detergent solution. Do not use benzene, thinner, or other petroleum based cleaners. Wipe dry with a soft clean cloth. excessive moisture.
cables
RECEPTACLE OR OTHER Non-Polarizedplug, OUTLET UNLESS THE BLADE CAN BE FULLY INSERTED TO PREVENT BLADE EXPOSURE. FOR SOME MODELS THAT ARE NbN-POLARIZED, THE USE OF AN AC ADAPTOR CONNECTOR MAY BE NECESSARY.
Avoid
Specifications Power Source
Batteries Replace batteries in pairs.
CT-13R4 CT-13R30 CT-13R40 CT-20G4 CT-20G14
CT-20G24 CT-20G34 CT-20R16 CT-2Ol 3S
120V AC, 60Hz
CT-Z1427Z CT-Z2127Z
CT-Z2147Z
Auto (t10Vca220Vca); 5_6OHz
Channel
Capability - 181
Do not mix battery types (zinc carbon with alkaline). Do not disassemble, battehes,
recharge, heat, or
shod-circuit, burn used
Cable / Antenna For proper reception, either a cable or antenna connection are required.
VHFo12; UHF-56; Cable-113
Cable Connection Connect the cable supplied by your local cable company.
1V, p.l.p,
Video Input Jacks (some models)
75 Ohm, Phono Jack Type
Audio Input Jacks (some models)
500mV RMS 47K Ohm
To Audio AMP Jack (some models)
0-2.0V RMS 4.7K Ohm
I
Incoming Cable from Cable Company
75 Ohms VHF/UHF on backof TV
No_: Specifications are subject to chan or obligation.
_ without notice
-2-
A cable converter box may be required for proper reception. Check with your local Cable company for compatibility requirements.
Antenna Connection For
proper
reception
of
VHF/UHF
For best reception an outdoor antenna recommended. channels, an externalantenna is required, recommended. is Antenna Antenna Mode Mode must must be be set set to to TV. TV.
VHF/UHF Antenna
_
A VHF/UHF
antenna and transformer are supplied
_
Connection). in some until models. Attach'is to the TV, the antenna the picture clear. (Seeadjust Antenna
__
_i!
O
mi_l "_
laB_
Incoming Cable from Home Antenna Incoming Cab
_
l!
I Cable Cable Mode Mode is is presetat preset at the the factory, factor_ Antennausers Anti
w
_
must must changeto change to AntennaMode Antenna Mode in in the the Set Sel Up Menu.
_
_i
Helpful
Hints:
rt Home Ant(
Cable
Preset
II1
Optional lal Equipment
To Audio'Amplifier Audi
Connections
models)
_
VCR's, video disc players. VCR's, players, TV game consoles, consoles, and DSS equipment can also be connected to the your equipment antenna input connection. (See your
Connect to an Connect _ external audio amplifier input for listening to sound sc from a stereo system, Note: TO TOAUDICLAMPtenninalscannotbeused
_
directly for external speakers. dir,
manual),
Audio Adjustments Audio 1, Adj Prs Press TV SPEAKERS
Procedure 1, Connect
equipment as shown to front or equipment rear rear Audio/Video AudioNidec input input jacks, jacks, Note:
2.
Front and rear Audio/Video connections cannot be operated at the operated the same same time. time.
Note:
ON button located
_
AUDIO menu. 2.
as instructed instructed
3.
in equipment in equipment manual. manual.
• 4. 5.
_ J _i
L
ff your If yc TV does not have a TV SPE SPEAKERS ON/OFF button, sele select TV SPEAKERS ON from
Select the Video Select Video mode mode by by pressing TV/ "IV/ Operate optional Operate optional equipment
_
on back of set.
VIDEO button. 3.
(AMP, some
_,.J _
amplifier volume vo]um_ toor minimum. Set amplifier Adjust TV volume Adjust volume to tc desired le_ level.
_
Adjust amplifier volume Adjust volu le to match the TV. PressTV SPEAKEF ;COFF button located Press TV SPEAKERS on back of set. Note: Ifset. your TV your Tt does do not have a TV on back offf SPEAKE/ SPEAKERS ON/OFF button, select OFF&VAO from AUDIO
_
m
_
menu,
6. Note:
Terminalson Terminals on back of "IV (some models)
'I
Voluma and and mute mute are a _n_ Volume now selected using the TV "IV controls. controls. In OFF&FAO _tr is controlled OFF&FAO the the w volume the external amplifier. VCR or Video Disc Di_ the external ampfifi_
by
!
I
'/,,-,.--,- | ; VIDEO
¢ L-AUDIO-
.rm,r,,so° ,t, 0 Terminals on back of VCR R
T, inalso, front Terminalson ontofTV(somemo of TV (some models) els)
STEREO MODELS
STEREO MODELS C_o__"_•)
_'_
us,
VIDEO
_
AUDIO
MONO MODELS VIDEO DEC
"O"OMODELS (• .
LL.-1 -AUDIO-1- R
STEREO"OOELS • •
(some m0de_s) t/8" eatphoneJaCk usedfOrlug Jackusedfor (somemodels) 1/8"headphoneplug
• ) • _
3
Timer
ACTION Button
Sleep Timer
Press the ACTION button to display the Main Menu and Sub Menus. Press the ACTION button
In TIMER menu, program to turn TV OFF in 30, 60, or 90 minutes. Select NO to turn off timer.
repeatedly to exit. Note:
Models with no audio
features will not TIMER CONTROL
display AUDIO icon in the Main Menu.
PROGRAM
Main Menu
TIMER ON OFF CHANNEL SET
--
: __ 3 TIME FIRST
Program Timer In 33mer menu, programTV to automaticallyturn on and offat selected timeon a selectedchannel,dailyor one day.
IW.4|II
TIMER CONTROL
CH / VOL Buttons
SLEEP TIMER
Press the CH (channel) or VOL (volume) buttons to select an icon, Use the CH buttons to highlight the desired features. Use VOL buttons to select and adjust features.
NO
ON OFF CHANNEL SET
Remote Navigation Buttons
Note:
3 TIME FIRST
TIME must be entered in the SET UP menu to operate PROGRAM
TIMER.
Helpful Hints: PROGRAM Activation
Remote The
The PROGRAM TIMER is active when the TV is OFF or ON. The TV will switch to the selected channel at the selected time set by the PROGRAM TIMER.
Control
Remote
Control
Quick
Reference
Guide
TIMER
is
Iccated in the package provided with the TV.
Helpful Minutes
In SET UP menu, select ENGLISH, ESPAI_IOL,OR FRAN(_AIS.
MODE
Turn
Off
After
90
The TV automatically turns OFF after 90 minutes when turned on by the PROGRAM TIMER. If the OFF time is programmed or if a key is pressed, the automatic OFF after 90 minutes will be cancelled.
Languages
SET-UP SET TIME ANT AUTO PROG MANUALPROG
Hints:
OH CAP (Channei
AM CABLE NO NO
Caption)
Program channel captions (station labels) stations using up to four characters.
OFF
CHA_INEL
I_ for 30
CAPTION
ENTER CAPTION • TO MOVE • CURSOR
Note:
-4-
