Transcript
KNOX ROMAN TUB FAUCET Before installing, read entire Knox Roman Tub Faucet Installation Instructions. Observe all local building and safety codes. For the following installation instructions for your new faucet it is assumed that any old fixtures have been removed and any repairs or modifications to the water supply have been completed. Unpack and inspect the product for any shipping damages. If you find damages, do not install. Contact Customer Service at 1-866-855-2284. If you need assistance or have questions while installing your faucet, contact Customer Service. We recommend consulting a professional if you are unfamiliar with installing bathroom fixtures. Signature Hardware accepts no liability for any damage to the floor, walls, plumbing or for personal injury during installation.
TOOLS AND MATERIALS: Screwdriver
Adjustable Wrench
Allen Wrench
SPECIFICATIONS: 4"
4"
1-1/4" min
1-1/4" min
4-1/4"
1-1/2" max
1/2"
1/2" 1-1/4" min
Knox Roman Tub Faucet Installation Instructions
1
1. Loosen the M5 screws to remove the handle levers, spacing rings, clamp rings, and escutcheons from the inlet valves. Move the locking nut down on the threaded portion of the handle valves.
2. From beneath the tub deck, feed the handle valves through the mounting holes. Thread the handle escutcheons, clamp ring, and lock sleeve onto the valves.
Tub Deck Handle Lever Spacing Ring
M5 Screw
Clamp Ring Lock Sleeve
Outlet
Handle Escutcheon Rubber Washer Locking Washer
Outlet
Locking Nut Inlet Valve 3. Remove locking nut, locking washer and rubber washer from the faucet body.
4. Place the faucet body through the tub deck. Thread the rubber washer, locking washer, and locking nut onto the faucet body and tighten with an adjustable wrench.
Faucet Body Rubber Washer Locking Washer Locking Nut Lagging Fastening Screw
Knox Roman Tub Faucet Installation Instructions
2
5. Attach the tee joint to the faucet body.
6. Connect the inlet valves and tee joint with the connection tubes and tighten the coupling nuts.
1/2" O-ring Tee Joint
7. Tighten the locking nut and fastening screw. Reinstall the plastic spacing ring and handle lever. Tighten the M5 screw to secure.
1/2" O-ring
Washer Coupling Nut
Connection Tube
8. When your faucet installation is complete, turn on the water supply. Check to make sure that all connections are tight (no water should be leaking) and that the hot and cold supplies are working correctly. Turn the water on and allow the water to flow through the spout for approximately 60 seconds.
Fastening Screw
Knox Roman Tub Faucet Installation Instructions
3
