Transcript
DOCUMENT HISTORY REV
GENERAL NOTES
DATE OF ORIGIN/RELEASE
05/22/2015
DESCRIPTION OF REVISION
DATE
and installed to be in strict compliance with the UL 325 Safety Standard and the ASTM F2200 Construction Standard.
requirements of these standards shall not be allowed.
gate operator foot-print and location, photo beam coverage and placement, and vehicular loop dimensions and placement. Drawings are not all inclusive or guaranteed to scale.
Layout 1 PAMS SYSTEM - OVERVIEW TYPICAL 3-LANE LAYOUT WITH DUAL-LEAF SWING GATES Layout 2 PAMS SYSTEM TYPICAL EXIT LANE Layout 3 PAMS SYSTEM TYPICAL VISITOR ENTRANCE LANE (w/ Optional Card Reader for Residents)
existing public utilities, landscape, drainage, site peculiarities, or requirements by the authority having jurisdiction, ie; Fire Marshall, Building Inspector, Street and Alley Departments.
highly visible upon both entry and exit of the property, and must remain in place for the life of the gate operating system.
direction signs should be highly visible upon entry onto the property.
beams, reversing edges, hinges, and other gate hardware may vary in size, dimension, and placement and should not be used as an exact reference.
indicated are solely intended for reference only, and not intended to be the final criterion for determining the loop sizing and placement on any automated vehicular gate project. DoorKing, Inc does not assume responsibility or liability for any installation with regard to equipment/system malfunction, vehicle detector loop sizing and placement, or consequent damages or injuries caused thereby.
or liability for the installation and unauthorized changes to the design and operation of equipment, or alterations to the final site plan.
CONTENTS
Layout 4 TYPICAL RESIDENTS ONLY ENTRANCE LANE 120 Glasgow Avenue Inglewood, California 90301 Toll Free: 1-866-400-3600 Website: www.doorking.com Email:
[email protected]
COMPONENTS SL
ROLL-OVER
Slide Gate Operator:
SW
Swing Gate Operator: Model 6100/6300/6500/6524
PK
Parking Barrier Operator: DoorKing Model 1601
RO
6'
EXIT LANE
OPEN / EXIT LOOP 4' x 8'
4'
PB
Photo Beam: DoorKing Model 8080-031
RE
Reversing Edge: DoorKing Model 8080-0xx
VL
Vehicle Detecting Loop - DoorKing - Type 9402-xxx
OD1
Opening Device 1: DoorKing DKProx Card Reader
OD2
Opening Device 2: DoorKing Visitor Phone
OD3
Opening Device 3:
MP
Mounting Post: DoorKing Model 1200-xxx
SP
Slide Gate Panel
SWP
Swing Gate Panel
VL
8' 14'
14'
14' VL
VL PK
3' SHADOW LOOP 4' x 8'
DOWN & SHADOW
4'
LOOP 4' x 8'
3'
SW
4'
3' 4'
3' SHADOW LOOP 4' x 8'
VL
4'
PB
GT 4'
SW
Gate Travel
TS
Tail Section
RO
Roll-Over
GENERAL NOTES and installed to be in strict compliance with the UL 325 Safety Standard and the ASTM F2200 Construction Standard.
requirements of these standards shall not be allowed.
gate operator foot-print and location, photo beam coverage and placement, and vehicular loop dimensions and placement. Drawings are not all inclusive or guaranteed to scale.
existing public utilities, landscape, drainage, site peculiarities, or requirements by the authority having jurisdiction, ie; Fire Marshall, Building Inspector, Street and Alley Departments.
highly visible upon both entry and exit of the property, and must remain in place for the life of the gate operating system.
4'
PB SW
4'
4'
4'
PB
direction signs should be highly visible upon entry onto the property.
PB
SW
SHADOW LOOP 4' x 8'
4' 3'
DOWN & SHADOW
SW
LOOP 4' x 8'
3'
DOWN & SHADOW
4'
LOOP 4' x 8'
PK
4'
beams, reversing edges, hinges, and other gate hardware may vary in size, dimension, and placement and should not be used as an exact reference.
PK
GT VL
8'
VL
8'
VL
OD1
VL
indicated are solely intended for reference only, and not intended to be the final criterion for determining the loop sizing and placement on any automated vehicular gate project. DoorKing, Inc does not assume responsibility or liability for any installation with regard to equipment/system malfunction, vehicle detector loop sizing and placement, or consequent damages or injuries caused thereby.
12'
20' ARMING (RF transmitters ) & SHADOW LOOP (for steel gate)
8'
4' x 8'
4'
ARMING & SHADOW LOOP 4' x 8'
MP
8'
4'
8' VL
RO
20'
TURN-AROUND shown as a example only. Actual distances, dimensions, and exact location of curbing and visitor phone island to be determined by "Local Authoity Having Jurisdiction."
ROLL-OVER
ROLL-OVER
VISITOR & RESIDENT ENTRANCE LANE
RESIDENT ONLY ENTRANCE LANE
or liability for the installation and unauthorized changes to the design and operation of equipment, or alterations to the final site plan. RO
LAYOUT_DESCRIPTION LAYOUT 1
VL
OD2
MP
NOT TO SCALE
ARMING & SHADOW LOOP 4' x 8'
OD1
Layout 1 PAMS SYSTEM OVERALL TYPICAL 3-LANE LAYOUT
120 Glasgow Avenue Inglewood, California 90301 Toll Free: 1-866-400-3600 Website: www.doorking.com Email:
[email protected]
COMPONENTS
14'
SL
ROLL-OVER RO
6'
SW
Swing Gate Operator: Model 6100/6300/6500/6524
PK
Parking Barrier Operator: DoorKing Model 1601
PB
Photo Beam: DoorKing Model 8080-031
RE
Reversing Edge: DoorKing Model 8080-0xx
VL
Vehicle Detecting Loop - DoorKing - Type 9402-xxx
OD1
Opening Device 1: DoorKing DKProx Card Reader
OD2
Opening Device 2: DoorKing Visitor Phone
OD3
Opening Device 3:
MP
Mounting Post: DoorKing Model 1200-xxx
SP
Slide Gate Panel
SWP
Swing Gate Panel
GT
OPEN / EXIT LOOP 4' x 8'
4'
Slide Gate Operator:
Gate Travel
TS
Tail Section
RO
Roll-Over
GENERAL NOTES and installed to be in strict compliance with the UL 325 Safety Standard and the ASTM F2200 Construction Standard.
requirements of these standards shall not be allowed.
gate operator foot-print and location, photo beam coverage and placement, and vehicular loop dimensions and placement. Drawings are not all inclusive or guaranteed to scale.
existing public utilities, landscape, drainage, site peculiarities, or requirements by the authority having jurisdiction, ie; Fire Marshall, Building Inspector, Street and Alley Departments.
highly visible upon both entry and exit of the property, and must remain in place for the life of the gate operating system.
direction signs should be highly visible upon entry onto the property.
VL
beams, reversing edges, hinges, and other gate hardware may vary in size, dimension, and placement and should not be used as an exact reference.
8'
indicated are solely intended for reference only, and not intended to be the final criterion for determining the loop sizing and placement on any automated vehicular gate project. DoorKing, Inc does not assume responsibility or liability for any installation with regard to equipment/system malfunction, vehicle detector loop sizing and placement, or consequent damages or injuries caused thereby.
VL PK
DOWN & SHADOW
4'
LOOP 4' x 8'
or liability for the installation and unauthorized changes to the design and operation of equipment, or alterations to the final site plan.
4' PB
PB
LAYOUT_DESCRIPTION LAYOUT 2
4' NOT TO SCALE
SW
SW
SHADOW LOOP 4' x 8'
4' 3'
3'
GT
EXIT LANE
VL
Layout 2 PAMS SYSTEM TYPICAL EXIT LANE
120 Glasgow Avenue Inglewood, California 90301 Toll Free: 1-866-400-3600 Website: www.doorking.com Email:
[email protected]
COMPONENTS SL
14' 3'
3' SHADOW LOOP 4' x 8'
SW
4'
VL
4' PB
4' PB
SW
Swing Gate Operator: Model 6100/6300/6500/6524
PK
Parking Barrier Operator: DoorKing Model 1601
PB
Photo Beam: DoorKing Model 8080-031
RE
Reversing Edge: DoorKing Model 8080-0xx
VL
Vehicle Detecting Loop - DoorKing - Type 9402-xxx
OD1
Opening Device 1: DoorKing DKProx Card Reader
OD2
Opening Device 2: DoorKing Visitor Phone
OD3
Opening Device 3:
MP
Mounting Post: DoorKing Model 1200-xxx
SP
Slide Gate Panel
SWP
Swing Gate Panel
GT
DOWN & SHADOW LOOP 4' x 8'
4'
(optional)
existing public utilities, landscape, drainage, site peculiarities, or requirements by the authority having jurisdiction, ie; Fire Marshall, Building Inspector, Street and Alley Departments.
indicated are solely intended for reference only, and not intended to be the final criterion for determining the loop sizing and placement on any automated vehicular gate project. DoorKing, Inc does not assume responsibility or liability for any installation with regard to equipment/system malfunction, vehicle detector loop sizing and placement, or consequent damages or injuries caused thereby.
4' x 8'
RO
ROLL-OVER
TURN-AROUND shown as a example only. Actual distances, dimensions, and exact location of curbing and visitor phone island to be determined by "Local Authoity Having Jurisdiction."
gate operator foot-print and location, photo beam coverage and placement, and vehicular loop dimensions and placement. Drawings are not all inclusive or guaranteed to scale.
4'
(for steel gate)
20'
Roll-Over
requirements of these standards shall not be allowed.
beams, reversing edges, hinges, and other gate hardware may vary in size, dimension, and placement and should not be used as an exact reference.
VL
ARMING (RF transmitters ) & SHADOW LOOP
Tail Section
RO
and installed to be in strict compliance with the UL 325 Safety Standard and the ASTM F2200 Construction Standard.
direction signs should be highly visible upon entry onto the property.
8'
20'
Gate Travel
TS
GENERAL NOTES
highly visible upon both entry and exit of the property, and must remain in place for the life of the gate operating system.
PK
VL
Slide Gate Operator:
or liability for the installation and unauthorized changes to the design and operation of equipment, or alterations to the final site plan.
VISITOR & RESIDENT ENTRANCE LANE LAYOUT_DESCRIPTION LAYOUT 3
NOT TO SCALE
Layout 3
VL
OD2
MP
OD1
ARMING & SHADOW LOOP 4' x 8'
PAMS SYSTEM TYPICAL VISITOR ENTRANCE LANE (w/ Optional Card Reader for Residents)
120 Glasgow Avenue Inglewood, California 90301 Toll Free: 1-866-400-3600 Website: www.doorking.com Email:
[email protected]
COMPONENTS
3'
14' SHADOW LOOP 4' x 8'
SL
3' 4'
SW
Swing Gate Operator: Model 6100/6300/6500/6524
VL
PK
Parking Barrier Operator: DoorKing Model 1601
PB
Photo Beam: DoorKing Model 8080-031
SW
RE
Reversing Edge: DoorKing Model 8080-0xx
VL
Vehicle Detecting Loop - DoorKing - Type 9402-xxx
4' SW
OD1
Opening Device 1: DoorKing DKProx Card Reader
OD2
Opening Device 2: DoorKing Visitor Phone
OD3
Opening Device 3:
MP
Mounting Post: DoorKing Model 1200-xxx
SP
Slide Gate Panel
SWP
Swing Gate Panel
GT
4'
Slide Gate Operator:
PB
Gate Travel
TS
Tail Section
RO
Roll-Over
GENERAL NOTES and installed to be in strict compliance with the UL 325 Safety Standard and the ASTM F2200 Construction Standard.
requirements of these standards shall not be allowed.
gate operator foot-print and location, photo beam coverage and placement, and vehicular loop dimensions and placement. Drawings are not all inclusive or guaranteed to scale.
existing public utilities, landscape, drainage, site peculiarities, or requirements by the authority having jurisdiction, ie; Fire Marshall, Building Inspector, Street and Alley Departments.
highly visible upon both entry and exit of the property, and must remain in place for the life of the gate operating system.
DOWN & SHADOW LOOP 4' x 8'
PK
direction signs should be highly visible upon entry onto the property.
4'
beams, reversing edges, hinges, and other gate hardware may vary in size, dimension, and placement and should not be used as an exact reference.
4' indicated are solely intended for reference only, and not intended to be the final criterion for determining the loop sizing and placement on any automated vehicular gate project. DoorKing, Inc does not assume responsibility or liability for any installation with regard to equipment/system malfunction, vehicle detector loop sizing and placement, or consequent damages or injuries caused thereby.
VL
OD1
4'
12' ARMING & SHADOW LOOP 4' x 8'
MP
or liability for the installation and unauthorized changes to the design and operation of equipment, or alterations to the final site plan.
4'
LAYOUT_DESCRIPTION LAYOUT 4
8' 6'
VL NOT TO SCALE
Layout 4 ROLL - OVER
RESIDENT ONLY ENTRANCE LANE
RO
PAMS SYSTEM TYPICAL RESIDENTS ONLY ENTRANCE LANE
120 Glasgow Avenue Inglewood, California 90301 Toll Free: 1-866-400-3600 Website: www.doorking.com Email:
[email protected]
