Preview only show first 10 pages with watermark. For full document please download

Lb2200 Descaling Procedure

   EMBED


Share

Transcript

LB2200 Descaling Procedure SERVICE INFORMATION NO: 007 DATE OF ISSUE: 24/03/2011 **Please ensure you are using the correct instructions, if you have LB2300 please see overleaf** 1. Turn off the machine at main plug or rear switch 2. Remove and empty the dreg drawer of pods and water and reinsert 3. Pour exactly 1.5 litres of warm water into the water tank. Do not fill 4. Carefully add 1 sachet of Expressokleen to the water and stir, make sure the powder dissolves fully . While pressing, turn the machine back on 5. Press and hold 6. The machine will say ‘Date & Time’. Now release 7. Press until ‘4. Descale’ is displayed 8. Press to display ‘4.1 Qty to Descale’ 9. Press until ‘4.3 Do it now’ is displayed 10. Press sequentially followed by and finally 11. The machine may display ‘Cooling’ or ‘Warming’ 12. When ‘Insert descaler’ is displayed, press 13. ‘Ventilate fill with water’ will appear 14. Empty water from dreg drawer then replace in machine 15. Empty and rinse the water tank. Fill with plain cold water to at least ¾ full and replace 16. Press 17. Wait approx 5 minutes for ‘Descale executed’ to display 18. Turn the machine off and on at the switch 19. Follow any onscreen prompts if necessary 20. Finally remove drawer and empty rinse water then replace in machine 21. Your machine is ready for use - Enjoy a cup of coffee! to start. This stage takes approx 30 minutes to begin rinse process BLUEPOD TECHNICAL SERVICE Tel: 1800 800 255 Copyright Bluepod Coffee Co Pty Ltd Email: [email protected] LB2300 Descaling Procedure SERVICE INFORMATION NO: 007 DATE OF ISSUE: 24/03/2011 **Please ensure you are using the correct instructions, if you have LB2200 please see overleaf** 1. Place exactly 1.5 litres of warm tap water in the tank. Do not fill 2. Add to the tank 1 sachet of EXPRESSOKLEAN powder and stir until dissolved 3. Ensure machine is on and ready for use then touch MENU to access the user menu 4. Touch UP until the display reads 'Descaling' 5. Touch ENTER, the display will read 'Do it now' 6. Touch ENTER, the word 'No' will appear in the lower section of the display 7. Touch UP and ‘No’ will change to 'Yes'. Touch ENTER to confirm 8. Follow the instructions on the display. Remove and empty coffee grounds drawer, reinsert only when prompted 9. The machine may display 'Cooling' or ‘Heating’. Wait for this message to clear 10. Follow display prompts, remove the cup grill and point the steam wand into the grounds drawer. 11. Touch ENTER until the display shows 'Insert descale' 12. Touch ENTER once again to begin. This part of the process will take approx 20-25mins 13. The next message to appear will read ‘Descale in progress – fill water tank’ 14. Rinse then fill the water tank with plain cold tap water. 15. The display will read 'Rinsing - Enter to start'. Touch ENTER 16. Follow the prompts, empty the grounds drawer, reinsert only when directed. The machine will now rinse. 17. You may be prompted to add more fresh water or empty grounds drawer during the rinse 18. Wait for 'Descale executed' message. Touch ENTER 19. The machine will restart, heat up and rinse. Empty the grounds drawer when prompted. Insert only when prompted 20. Your machine is ready for use. Enjoy a cup of coffee! BLUEPOD TECHNICAL SERVICE Tel: 1800 800 255 Copyright Bluepod Coffee Co Pty Ltd Email: [email protected]