Transcript
FRONT
BACK
LCD TRAVEL ALARM CLOCK
ACTIVATING THE ALARM AND SNOOZE To turn the alarm ON press the AL. ON/OFF button. The alarm icon will appear on the display.
Thank you for your purchase of this quality clock
MONTH/DATE TEMPERATURE DAY TIME ALARM TIME
When the alarm activates you may: - Press the SNOOZE/LIGHT button and the alarm will stop and sound again approximately 5 minutes later. The symboll Zz will will appear on the display. - Press any button to stop the alarm until the next day. The alarm icon will remain on the display. - Or press the AL. ON/OFF button twice to fully shut off the alarm. The alarm icon will disappear from the display. TO USE THE LIGHT Press the SNOOZE/LIGHT button to light the display for a few seconds. 12/24 HOUR FORMAT Press the 12/24 button to select between 12/24hr format.
SNOOZE/LIGHT BUTTON
C/F BUTTON Press to select between Celsius and Fahrenheit - To do this push a pin through the C/F hole. RESET BUTTON Press to reset the clock - To do this push a pin through the RESET hole. CHANGING THE BATTERIES It is recommended that you replace the batteries annually, even if the product is still running. Only use 2 x CR2025 (3V) button cell batteries in this clock. Do not mix old and new batteries. Insert the batteries with the correct polarity. Remove exhausted batteries from the clock. Remove the batteries if the clock is stored or not in use. Warning: Button cell batteries are dangerous if swallowed. Always keep them out of reach of children and pets. Please dispose of used batteries in a responsible manner. For more information please contact your local authority.
REQUIRES 2 X 3V BUTTON CELL BATTERIES (INCLUDED). REMOVE THE ISOLATOR TABS TO ACTIVATE THE CLOCK AND PRESS 'RESET' BUTTON FOR USING.
TO SET THE TIME AND DATE Press and hold the Time set button for 3 seconds, the Hour will start to flash. Press the UP & DOWN button to adjust the hour. Press the Time set button once again, the Minute will start to flash. Press the UP & DOWN button to adjust the minute. Press the Time set button once again, the Year will start to flash. Press the UP & DOWN button to adjust the year. Press the Time set button once again, the Month will start to flash. Press the UP & DOWN button to adjust the month. Press the Time set button once again, the Date will start to flash. Press the UP & DOWN button to adjust the date. Press the Time set button once again to complete. Note: PM indicator (P) will display for PM time (12HR display only). TO SET THE ALARM Press and hold the Alarm set button for 3 seconds, the Hour will start to flash. Press the UP & DOWN button to adjust the hour. Press the Alarm set button once again, the Minute will start to flash. Press the UP & DOWN button to adjust the minute. Press the Alarm set button once again to complete. Note: PM indicator (P) will display for PM time (12HR display only).
MAINTENANCE A soft paper towel may be used to clean the clock. Do not use any corrosive cleaners or chemical solutions on the clock. Keep the clock clean and dry to avoid any problems. YOUR GUARANTEE Your clock is guaranteed for 12 months from the date of purchase against any faults arising from defective materials or manufacture. Damage caused through careless handling, misuse or in transit is expressly excluded. Should this clock fail within 12 months please return it in the first instance to your retailer. If you have any queries, problems or do not understand any . part of these instructions please contact: Customer Help Line (01908) 449208 or Locall 0845 1207208 Mon - Fri 9.00am - 4.30pm. Email for service:
[email protected] or visit www.acctim.com Environmental Protection Disposal of electrical & electronic equipment Do not dispose of this product with household waste. For the proper treatment, recovery and recycling please take this product to the appropriate collection point. If you are unsure of where this is contact your local authority. Improper disposal may be harmful to the environment. V. 2
