Leaf Master® Assembly Instructions

Transcript

Leaf Master® Assembly Instructions 1. Press bag ring into body as shown until snap is heard. Use firm hand pressure; do not pound. 2. Leaf-Master wheels may be replaced simply by pulling assembly firmly upward. Reverse procedure to install new wheel assembly. 3. Surface Skimming Invert the Leaf-Master allowing the powerful water jets to drive the Leaf-Master to the surface. Surface skimming is accomplished by slightly tilting the unit to the left or right as shown. 4. A full line of replacement parts and accessories including an extra large bag and a fine mesh bag are available at your local pool store. Be sure to ask for genuine Jandy Pro Series replacement parts and accessories by name. Page 2 Jandy® Pro Series Leaf Master® | Assembly Instructions Use of Leaf-Master Attach the Leaf-Master to your pool pole and garden hose, place in pool and turn on water pressure. Leaf-Master is easily maneuvered around the floor of the pool to pick up loose debris. For easier maneuverability, throw excess garden hose into pool. Emptying Collector Bag The collector bag may be emptied by pushing bag back through the Leaf-Master throat. In most cases, there is no need to remove the collector bag from the Leaf-Master to be emptied. However, if emptying the bag is required more than once while cleaning the pool, the bag may be emptied by removing the bag from the Leaf-Master utilizing the tie-release attachment on the bag. Storing When Leaf-Master is not in use, it is best to store it out of direct sunlight. The Brush Model should be stored with the bristles up. Zodiac Pool Systems, Inc. 2620 Commerce Way, Vista, CA 92081 1.800.822.7933 | www.Jandy.com ©2016 Zodiac Pool Systems, Inc. ZODIAC ® is a registered trademark of Zodiac International, S.A.S.U., used under license. All other trademarks referenced herein are the property of their respective owners. 1643 Rev B