Transcript
LEC-BASE R1
SMARC® Reference Carrier Board Features SMARC compliant carrier board with MXM3 connector
LEC-BASE R1
Compatible with both short and full size SMARC modules Supports parallel RGB, LVDS and HDMI displays Two mini PCIe slots for expansion cards (e.g. Wifi, 3G, ...) (not included) and two SIM card slots 2 camera connectors 4x UART, 2x CAN USB hub
*LEC = Low Energy Computer-on-Module
Specifications
PCI Express
Interfaces Display
Camera SDIO SPI
I2S
I2C
Asynchronous Serial Port
CAN Bus
USB
Combined HDMI, DP LVDS 18/24-bit or eDP Panel support signals (I2C, Power Enables, PWM) Combined HDMI, 18/24-bit RGB Camera input 0: CSI-2 Camera input 1: RGB or CSI-4 4-bit SD/SDIO card interfaces 8-bit eMMC/SD/SDIO interfaces Off module boot use (optional) G-sensor ADXL345 BCCZ 2x SPI interface 3x I2S interface - Audio codec TLV320AIC23BPW - Line-in, Line-out, Mic - Optional with HDA 4x I2C - Power Management - HDMI - Camera 0 - Camera 1 or GP 4x asynchronous serial ports (UART) - Two with 2 wire handshake (RXD, TXD, RTS#, CTS#) - Two with data only (RXD, TXD) - Logic level interface 1x CAN bus interface - Logic level signals from Module based CAN bus protocol controllers - RXD, TXD only 5x USB - One with USB 2.0 OTG - 4x USB 2.0 Host operation (full speed and high speed)
SATA
One PCIe x1 link connector Two mini PCIe x1 slots PCIe Gen1 or Gen 2 (module dependent) Reference clock pair Full set of PCIe support signals PCIe wake signal One SATA with power interface
Ethernet RJ-45 10/100/1000 Ethernet (by LAN transformer)
S/PDIF S/PDIF out for audio
Boot Source Select Module: SPI/eMMC/NOR/NAND Carrier: SPI/eMMC/SD Card/SATA DIP Switch (4)
GPIO 12-pin header (including fan control and HDA reset)
Alternate Function Blocks (AFB) Dedicated AFB connector Pinout is module dependent (See SMARC specification)
Mechanical and Environmental Dimension Board Connector
http://www.adlinktech.com/Computer-on-Module
330 mm x 175 mm (L x W) MXM 314 pins
Functional Diagram GbE
LAN
RJ45
Transformer
10/100/1000
Line IN Line OUT MIC
UART1 (4-pin)
UART3 (2-pin)
Codec
I2S1
TLV320AI C23BPW
CAN1 (2-pin)
I2S3 / HDA I2S4
CAM0 : Camera Input CSI 2-lane
Header
I2C CAM0 CAM1 : RGB Camera Input (or CSI 4-lane)
Header
I2C
Combined
HDMI / (or DP)
HDMI / DP
I2C HDMI_CTRL
Header
Header
18/24-bit RGB TTL
HDMI-RGB SIL9022
Level Shift buffers
Vdd, BKL_EN, BKL_CTRL
Control Signals
Power Powerenable enable//disable disablejumper jumper
Ordering Information Modules Model Number
Description/Configuration
LEC-BASE-R01
SMARC Reference Carrier Board, MXM 314 pins, 330 x 175 mm
SATA Connector
USB0
USB OTG
USB2 USB1
GPS
USB1_D
USB USB
USB1_C
USB HUB SMSC USB2514i
Neo6
USB1_A USB1_A USB1_B USB1_B
PCIE_A (x1)
PCIE_WAKE#
Boot Select / Force Recovery
Management Pins RGB 18/24-bit
SDMMC
SATA1
EEPROM 4K
I2C LCD
SDIO
eMMC/SD/SDIO 8-bit
LVDS 18/24-bit (or eDP)
Header
24-bit LVDS
HDMI
CAM1 or GP
314-pin Connector
SPI2
Header
Header
SD/SDIO 4-bit
SPI1
Header
DB9
GPIO (12-pin) includes FAN control & HDA_Reset
SPDIF
SPDIF
DB9 DB9
UART4 (2-pin)
I2S2
Header
DB9 DB9
UART2 (4-pin)
Watchdog Time Out
miniPCIe x1 A Slot miniPCIe x1 B Slot PCIe x1 Slot
DIP switch (4) Test point Header
Motion Detector MMA7660FCT
I2C General Purpose
Header
Mouser Electronics Authorized Distributor
Click to View Pricing, Inventory, Delivery & Lifecycle Information:
ADLINK Technology: LEC-BASE
