Preview only show first 10 pages with watermark. For full document please download

Led Status Table - Cavalry Storage

   EMBED

Share

Transcript

LED Status Table Status Mode Change OK Mode Mismatch USB Detach & Disks Idle LED1 (SATA1) LED2 (SATA2) Blink All 3 mes @1Hz then Green Blink All @1Hz Repeatedly Off Off JBOD: USB A ach & Access Disk1 Blinking in Green Green if Disk2 OK JBOD: USB A ach & Access Disk2 Green if Disk1 OK Blinking in Green Disk1 NG Blinking in Red Green Disk2 NG Green Blinking in Red Disks NG Blinking in Red Blinking in Red Disks Ready at USB Detach Green Green Recovering < 50% Blinking in Green Blinking in Green Recovering > 50% Green Blinking in Green Recovery 100% Green Green Blinking in Red Green Recovery Disk1 NG Recovery Disk2 NG Green Blinking in Red From JBOD to RAID1 & Disk1 Capacity > Disk2 Green Blinking in Red Blinking in Green Blinking in Green From JBOD to RAID1 & Disk2 No Data From JBOD to RAID1 & Disk2 with Data Green Blinking in Red From JBOD to RAID1 & Disk2 with Data then Press DB Bu on 5s Blinking in Green Blinking in Green RAID1: Plug in New Disk2 & No Data Blinking in Green Blinking in Green RAID1: Plug in New Disk2 & with Data Green Blinking in Red RAID1: Plug in New Disk2 & with Data then Press DB Bu on 5s Blinking in Green Blinking in Green JBOD: USB Detach& Press DB Bu on 3s Blinking in Green Blinking in Green Source Target 1. Power Light 2. HD Access Lights x2 3. Duplicate Button (DB) 4. USB 3.0 Port [Also compatible with USB 2.0/1.1] 5. RAID Switch 6. DC Power Input [12V] 7. Power Button “Retriever Pro” DDREU3-BD Under JBOD Mode Under RAID1 Mode With USB Cable Connected If both drives are detected with data, the HD Access lights will begin to to blink red and green repeatedly to indicate that no access and recovery can be implemented. If one blank drive and one drive with data are inserted, it will start the recovery process automatically. It is allowed to access data while the recovery is processing. If both are blank drives, data can be copied onto both at the same time. With No USB Cable Connected If both drives are detected with data, the HD Access lights will begin to blink red and green repeatedly to indicate that no access and recovery can be implemented. Press and hold the DB button for 5 seconds to start the recovery process. If one blank drive and one drive with data are inserted, the recovery process will begin after pressing the DB button. Note: RAID1 Mode is only supported under Windows & MAC OS. When slots are full but device shows only one HDD in JBOD mode. -Please find diskmgmt.msc program in your system to reconnect your device states. Refer to the “LED Status Table” on the front cover of this guide.