Transcript
Catalog Number Notes
Type
FEATURES & SPECIFICATIONS INTENDED USE
6" Housing
Recessed housing rated IC for new construction only.
LI6F
Approved for all ceiling and wiring types. CONSTRUCTION Pre-painted steel housing. Galvanized bar hangers span up to 24” o.c. and feature built in nailer and Tbar clips. Galvanized steel junction box with four built in romex clamps; two 1/2" and four 3/4" knockouts with slots for pryout. Rated for through branch wiring.
FLUORESCENT
Maximum 6 (3in 3out) No 12 AWG conductors. Rated for 90° C.
IC Vertical Lamp New Construction
Ground wire provided. Removable J-box doors for easy access. Poke-home connectors standard. ELECTRICAL SYSTEM Thermally protected. MVOLT 120 through 277 electronic ballast standard (4-pin lamp). INSTALLATION 2 x 8 wood joist or T-bar installation.
12-1/2 (31.8)
Specifications
Expandable bar hangers allow for off center mounting in wood joist or Tbar ceilings. Length of 25-1/4” maximum 13-1/4” minimum. Socket attaches to reflector to ensure proper and consistent lamp position.
12-1/4 (31.1)
Height: 7-1/2 (19.1) Length: 11 (27.9) Width: 12-1/2 (31.8) 11 (27.9)
Maximum ceiling thickness determined by finishing trim. See specific trim page.
13 (33)
Ceiling cutout 6-7/8”. LISTING 7 (17.8) 7-1/2 (19.1)
U.L. listed to US and Canadian safety standards. Damp location listed. (See trim selection for wet location listed.)
6-7/8 (17.5) All dimensions are inches (centimeters).
Example: LI6F 26/32TRT MVOLT
ORDERING INFORMATION Choose the boldface catalog nomenclature that best suits your needs and write it on the appropriate line. Order accessories as separate catalog number.
LI6F
MVOLT
Series
Lamps
Volt
Options
LI6F
18DTT/TRT 26/32TRT
MVOLT
Shipped installed in fixture GMF Single slow-blow fuse. A T Sealed airtight housing to minimize air flow through rough-in. Complies with WSEC and certified per ASTM E283. ADEZ Advance Mark 10™ electronic dimming ballast. Minimum dimming level 5%.
Accessories: Order as separate catalog number.
LSMC
T-bar mounting clips, set of four
NOTES: 1 Metal flange standard. For plastic flange add suffix PF. 2 Flush glass lens - 18/26TRT lamps only. See reflector specification sheets for maximum wattages. Not all wattages available for reflectors.
Reflector 6O2 White open 6O2A 6O2GZ 6O2SA 6O2SG 6C3BL 6B3
Clear specular open Gold specular open Clear diffuse open Gold diffuse open Black specular cone Black metal baffle
6B3W White metal baffle 6B4 Black baffle 6B4W White baffle 6SO1 White open slope 6SB1 Black baffle slope 6SB1W 6SB1C 6W1 6W2 6W2W
White baffle slope Clear baffle slope White wallwash Black baffled wallwash White baffled wallwash
6LD2 6LF1 6LF2 6LD3 6LDB3 6LF3 6LFB3 6L4 6L4B 6O8AZ
Drop prismatic Flush opal plastic1, 2 Flush prismatic2 Drop opal white splay Drop opal black baffle Flat white white splay2 Flat white black baffle2 Fresnel white splay2 Fresnel black baffle2 Clear specular open, integral flange 6O8A Clear diffuse open, integral flange 6C3A Clear specular cone 6C3G Gold clear specular cone
6LD1 Drop opal plastic1
Downlighting and Track
Sheet #: LI6F-COM
CCFL-135
6" Fluorescent LI6F Photometrics Distribution curve
Distribution data
Output data
Coefficient of utilization
Single luminaire data 30" above floor
6O8A, (1) Philips PL-C 18W/27SH lamp, 1.2 s/mh, 1200 rated lumens, Test no. LTL12660 cp
90˚
0 5 15 25 35 45 55 65 75 85 90
70˚
100 200
50˚ 300 400 500 10˚
30˚
Lumens
514 526 489 443 365 178 32 0 0 0 0
50 138 203 225 141 34 0 0 0
Zone
Lumens % Lamp
0˚ - 30˚ 391.1 32.6 0˚ - 40˚ 616.3 51.4 0˚ - 60˚ 792.2 66.0 0˚ - 90˚ 792.7 66.1 90˚ - 180˚ 0.0 0.0 0˚ - 180˚ 792.7 *66.1 *Total Eff iciency
pf 20% pc 80% 70% 50% pw 50% 30% 50% 30% 50% 30% 0 79 79 77 77 73 73 1 72 71 71 69 68 67 2 66 63 65 62 63 61 3 61 57 60 56 58 55 4 56 52 55 51 54 50 5 51 47 51 46 49 46 6 47 43 47 42 46 42 7 44 39 43 39 42 38 8 40 36 40 36 39 35 9 38 33 37 33 37 33 10 35 31 35 31 34 30
Task Height: 2.5ft. 50% beam Inital FC Mounting Center Beam Diameter Height 6.6 17.0 8.0 9.0 9.1 10.0 11.4 5.7 12.0 13.8 3.9 14.0 16.2 2.8 16.0
- 61.8˚ 10% beam - 92.6˚
FC 8.5 4.6 2.8 1.9 1.4
Diameter 11.5 15.7 19.9 24.1 28.2
FC 1.7 0.9 0.6 0.4 0.3
6O8A, (1) Philips PL-C 32W/27SH lamp, 1.2 s/mh, 2400 rated lumens, Test no. LTL12661 cp
90˚ 100
0 5 15 25 35 45 55 65 75 85 90
70˚
200 300
50˚
400 500 600 700
10˚
Energy
30˚
Lumens
681 697 675 630 563 428 279 149 7 0 0
67 190 290 350 329 251 141 14 1
Zone
Lumens % Lamp
0˚ - 30˚ 546.8 22.8 0˚ - 40˚ 897.2 37.4 0˚ - 60˚ 1477.5 61.6 0˚ - 90˚ 1633.6 68.1 90˚ - 180˚ 0.0 0.0 0˚ - 180˚ 1633.6 *68.1 *Total Eff iciency
pf 20% pc 80% 70% 50% pw 50% 30% 50% 30% 50% 30% 0 81 81 79 79 76 76 1 73 71 71 69 69 67 2 65 61 64 60 61 58 3 58 53 57 52 55 51 4 52 46 51 46 49 45 5 47 41 46 41 44 40 6 42 37 42 36 40 36 7 38 33 38 33 37 32 8 35 30 35 29 34 29 9 32 27 32 27 31 26 10 30 25 29 25 29 24
Task Height: 2.5ft. 50% beam - 66.3˚ Inital FC Mounting Center Beam Diameter Height 7.2 22.5 8.0 9.8 12.1 10.0 12.4 7.5 12.0 15.0 5.1 14.0 17.6 3.7 16.0
FC 11.3 6.1 3.8 2.6 1.9
10% beam 105.7˚
Diameter 14.5 19.8 25.1 30.3 35.6
FC 2.2 1.2 0.8 0.5 0.4
(Calculated in accordance with NEMA standard LE-5.)
Fixture/ LER Annual* Lamps Lamp Ballast Input Reflector Energy Cost Lumens Factor Watts LI6F 26/32TRT/6O8A 48.04 $7.128 (1) 32W TRT 2400 .97 33 LI6F 18TRT/6O8A 36.05 $4.75 (1) 18W TRT 1200 1.00 22 *Comparative yearly lighting energy cost per 1000 lumens
Electrical Characteristics Lamp
120 Volt HPF 277 Volt HPF Maximum Input Maximum Input current watts current watts
(1) 32TRT 0.570
36.0
0.250
36.0
(1) 18TRT 0.170
20.0
0.080
20.0
Tested to current IES and NEMA standards under stabilized laboratory conditions. Various operating factors can cause differences between laboratory data and actual field measurements. Dimensions and specifications are based on the most current available data and are subject to change without notice.
Lithonia Lighting
Sheet #: LI6F-COM
©2001 Acuity Lighting Group, Inc., Rev. 07/06
Recessed Downlighting One Lithonia Way, Conyers, GA 30012 Phone: 800-315-4935 Fax: 770-860-3106 www.lithonia.com
