Lifeguard Networks` Sy-mtip Ip Network System Controller Is The

Transcript

LifeGuard Networks’ SY-MTIP IP network system controller is the gateway for your microprocessor based Life Safety/Building Automation System onto the peer-to-peer world of total system integration. The SY-MTIP supports the network connection for up to two separate building systems, connections for 6 CCTV cameras, built-in DVR with optional Hard Drive, Ethernet connection, Emergency Audio inputs and outputs as well as ample power with battery backup. When tied into the NetView software, new and existing systems, connected thru their RS-232 ports, can be monitored and/ or controlled by the LifeGuard Network for maximum integration, flexibility and compatibility. S TA N DA R D F E ATURES • Durable 16 ga steel cabinet w/silver vein powder coat with removable secure key locked door. Dimensions: 13 ½” x 13 ½” x 3 ½” deep. • System Configuration Information Reference. • Expansion for relay and IO boards on an i2C bus. • PC based interface control software - Blowfish 128 bit encrypted. • 2g flash memory w/ expandable hard drive for video storage. • 6 channels integrated video and control. • Serial communication: 2 RS-232 (RJ11 port and cable.) & 2 RS-485. • Integral Charger for backup batteries with power input 12/24VDC. • Ethernet Port. • Common Speaker and Microphone. • Quickstart manual and out of box installation. PART NUMBER INFORMATION: SY-MTIP The IP based building control system shall be a LifeGuard Networks MTip control panel. The panel will be constructed of 16 ga steel and finished with a silver vein powder coat. The unit will have a removable door with key lock. MTip components and expansion boards shall be mounted to a removable back plane. The MTip Internet Protocol (IP) shall provide remote access connectivity. System shall provide visual led confirmation of status. The MTip will provide programming functions of the main processor and control system components. The system will provide system diagnostic and access integral system reports and status. The MTip shall provide expansion for relay control boards and provide the ability to interface to auxiliary modules via a I2C interface bus. The MTip provides Ethernet interface for communication to a monitoring station for the transmission of events. The MTip Shall provide two RS232 interfaces, two RS485 interfaces, with a console microphone input and common speaker output. Integrated battery charging system capable of charging 35amp hour battery. MTip shall provide integrated video inputs. System shall include video recording capabilities to on board flash memory with expansion of digital storage capability. Integrated Video Inputs I2C Bus Input rom PSD1 Communication with FServer Established Communication Heartbeat RS-485 Comm Ports Common Speaker Circuit Console Mic.rophone Input RS232 Serial Ports Ethernet Battery Charging Circuit Removable Backplate 24Vdc Input Door Grounding Strap System Conf iguration Information Reference Aux. Relay And Input Modules Location. 16Ga Powder Coat Steel Construction 13.5” 13.5” 3.5” PART NUMBER SY-MTIP DESCRIPTION MT IP Multi Gateway 12/24 Input. 13” Sq. Silver Vein Cabinet. PRODUCT SHEET P/N: LT10522 Rev A Disclaimer Information: This document is subject to change without notice, see doc # ED0479 for legal disclaimer