Light Switch Kit Instructions Includes 1. 3 Way Switch High Beam – Off

Transcript

Light switch kit instructions Includes 1. 3 way switch high beam – off - low beam 2. 2 way on-off safety switch for remote 3. wire harness 4. keyed ignition power wire 5. switch brackets 6. Connectors Installation Instructions – 2 prong onoff switch 3 prong high / low beam switch Scotch lock Black Green White Keyed ignition red power wire Red Figure 1 Inside cab harness end SEE FIGURE 1 FOR STEPS 1-7 Dielectric grease is recommended at all wire connections. 1. Route the wiring harness thru vehicle grill, engine compartment and thru the firewall with the 6 prong plug coming out the vehicles grill and the other end of the harness into the vehicle cab. 2. Find a convenient location inside the truck cab to mount the switch bracket(s) and switches. 3. Connect the white wire to the bottom spade terminal of the 3 prong switch. This will control the plow low beam lights. 4. Connect the green wire to the center spade terminal of the 3 prong switch. This will be the off position. 5. Connect the black wire to the top spade terminal of the 3 prong switch. This will control the plow high beam lights. 6. Using a test light find a wire under the dash or at the fuse box that only has power when the ignition is on. (DO NOT TAP INTO ANY AIR BAG WIRES) Connect the bare end of the red keyed ignition wire (see FIG 1) to the keyed ignition source wire by use of the scotch lock (provided). 7. Connect the other end of the keyed ignition source wire to one of the spades on the 2 prong on-off switch (see FIG 1). 8. Connect the remaining red wire from the light harness to the other spade of the 2 prong on-off switch. Lt green wire to passenger turn signal Grill end plug Brown wire to parking lamp Dk green wire with eyelet to battery ground Yellow wire to drivers turn signal FIGURE 2 vehicle grill end wiring SEE FIGURE 2 FOR STEPS 8-13 9. Connect the dark green wire with the eyelet to the battery ground 10. Using a test light locate the drivers side turn signal wire and the drivers side parking lamp wire. 11. Using a scotch lock connect the yellow wire to the drivers side turn signal wire. 12. Using a scotch lock connect the brown wire to the drivers side parking lamp wire. 13. Using a test light locate the passengers side turn signal wire. 14. Using a scotch lock connect the light green wire to the passengers side turn signal wire. OPERATION – In order for the plow lights to be activated the truck parking lamp switch must be on and the plow harness switch must be in the down position for low beam plow lights and in the up position for high beam plow lights. The middle position is off. The plow light harness and switch does not control any of the vehicles headlamp functions. It is recommended that the vehicle headlamps stay off when the plow lights are on to preserve the battery. On vehicles with auto lamps it may be necessary to turn the auto lamps off or see your dealer about disconnecting the auto lamp function.