Preview only show first 10 pages with watermark. For full document please download

Mackie 1604 Simple Flow Diagram

   EMBED

Share

Transcript

MIC LINE INPUT INPUT PREAMP 5/17/06 Mackie 1604 SIMPLE FLOW TRIM for111/212 INSERT 75HZ High Pass Filter AUX SENDS 1 & 2 NORMALIZED TO API FOLDBACK 1 & 2 -20 DB LED (GREEN) PRE EQ POST AUX MASTER OVER LOAD LIGHT (RED) PFL/SOLO AUX SEND 3 NORMALIZED TO M300 INPUT ON/MUTE 5/6 SHIFT AUX SENDS 3&4 AUX SENDS 5&6 FADER PAN AFL/SOLO BUS ASSIGN 1 2 3 4 L R AUX SEND 1 ONLY M300 OUT NORMALIZED TO AUX RETURN 1 WHICH FEEDS AUX SEND 1 SOLO mode SOLO level CR/Phones OUT C/R OUT NORMALIZED TO API MIX MOD SUB FADERS ASSIGN TO L/R SUB 1/2 CR/PHONES SOURCE SUB 3/4 L/R MIX SUB OUTS TO AUX SEND 1 EFX TO MONITOR L/R OUT AUX M300 OUT NORMALIZED TO RETURN 1 AUX RETURN 1 MAIN MIX HEADPHONES / FOLDBACK 1. 2. 3. 4. 5. 6. 1. 2. 3. 4. Assign each channel to L/R. Pull up channel fader. Pan as needed. Pull up Main Mix fader. Assign Control Room section to Main Mix. Turn C/R Phones knob to 12:00. C/R out is normalized to API Mix Mod. REVERB IN HEADPHONES Aux 1 and 2 are normalized to the API Foldback 1 and 2. Assign pre fader button on each channel. Turn up Aux level on each channel used. Turn up Aux 1 and 2 Master knobs. Try to have the loudest signal not go past 12:00 on the Aux sends. 5. Solo Aux 1 and 2 to check levels. It’s easy to distort the Aux sends. 6. On the API Foldback module push the FB MIX on button. 7. Turn the FB 1 and 2 Master gain knobs to around 1:00. 1. Aux send 3 is normalized to the M300 in. The M300 out is normalized to Aux Return 1. 2. Turn up Aux 3 level on each channel used. There is no master for Aux 3. 3. The M300 Mix level should be set to wet (all the way to the right). 4. Set the Multieffect to off and choose a Reverb preset. 5. Set the input level while watching the red clip light. 6. The Aux Return 1 knob will send reverb to the main mix (for control room). 7. The Effects to Monitor knob will send the reverb to Aux send 1(for Foldback 1).