Transcript
HI 6050 HI 6051 HI 6052 SUBMERSIBLE ELECTRODE HOLDERS Dear Customer, Thank you for choosing a Hanna product. This sheet will provide you with the necessary information for a correct operation. Please read it carefully before using the holder. If you need additional technical information, do not hesitate to e-mail us at
[email protected]. Examine carefully the holder and if any damage has occurred during shipment, immediately notify your Dealer or the nearest Hanna Customer Service Center. The Hanna submersible electrode holders are available in three models: HI 6050 HI 6051 HI 6052 605 mm 1105 mm 1735 mm (23.8") (43.5") (68.3") SUBMERSION LENGTH 475 mm 975 mm 1605 mm (18.7") (38.4") (73.4") WEIGHT 0.8 kg (26 oz.) 1.2 kg (44 oz.) 1.7 kg (54 oz.) TOTAL LENGTH
FIGURE 1
DIA 120mm 4.75" MOUNTING HOLES
The mounting flange (FIG. 1) is a rugged PVC piece that mounts directly to the stainless steel bracket on your tank. FIG. 2 illustrates the suggested bracket dimensions used for mounting. Once mounted, the electrode holder becomes a protective housing that will extend the life of your pH and ORP electrodes. The electrode should be slid into the holder (FIG. 3) and hand tightened. The cable from the electrode will lead up through the holder and out through the cap on top. The cable is also shielded inside the holder to prevent any damage to the insulation. The protective cap is removable to allow for quick and simple electrode maintenance and replacement (FIG. 4 and 5).
FIGURE 3
FIGURE 2 *
45mm 1.77" 200mm 7.90" 45mm 1.77"
100mm 3.94"
MOUNTING FLANGE FOR ELECTRODE HOLDER FIGURE 4 REMOVABLE ELECTRODE HOLDER CAN SLIDE IN AND OUT OF MOUNTING FLANGE WITHOUT NEEDING TOOLS.
3mm .12"
SUGGESTED MOUNTING BRACKETS TO MOUNT THE FLANGE (LEFT) ONTO THE TANK. MATERIAL: STAINLESS STEEL (*not included).
FIGURE 5 REMOVABLE ELECTRODE HOLDER
DIA 120mm 4.75"
FIXED FLANGE
130mm 5.12"
475mm 19" IMMERSION LENGTH
LEVEL
DIA 50mm 2"
www.hannainst.com
