Transcript
© COPYRIGHT 2010 BY INDUSTRIAL FIBER OPTICS, INC. ALL RIGHTS RESERVED.
REVISIONS REV
DESCRIPTION
A
Initial release
ECO
DATE
DWN
APVD
5/26/2011
BB
AR
16 .6 " GH4001 STRIP LENGTH
NOTES: 1. RoHS COMPLIANT 2. -40_C TO 80_C OPERATING TEMPERATURE
40 1.6 "
3. SUITABLE FOR POF WITH n2.2mm JACKET AND n1.0mm OPTICAL FIBER 4. NICKEL PLATED BRASS BODY AND NUT WITH STAINLESS STEEL FERRULE AND POLYETHYLENE DUST CAP 5. TIA 604.4 (FOCIS 4) 6. INCLUDES BLACK BOOT, OTHER COLORS AVAILABLE UPON REQUEST
CRIMP HERE
EXPLODED VIEW 1:2
n10 n.4 "
INSTRUCTIONS: 1. DISASSEMBLE CONNECTOR BY UNTHREADING BACK HALF OF BODY FROM FRONT HALF. 2. STRIP FIBER JACKET ACCORDING TO ABOVE DIAGRAM. 3. SLIP BOOT, BACK HALF OF BODY AND SPRING OVER CABLE. RECOMMENDED EPOXY: 4. APPLY EPOXY TO INSIDE OF FERRULE EPO-TEK 301 AND TO BARE FIBER. INSERT FIBER INTO FERRULE. CRIMP TOOL: IF 370046 5. CRIMP FERRULE TO FIBER JACKET. USE 2.5 [.10] HEX 6. ALLOW EPOXY TO CURE. 7. ASSEMBLE NUT AND FRONT HALF OF BODY TO THE REST OF THE CONNECTOR. UNLESS OTHERWISE SPECIFIED ENSURE THAT TANGS ON BACK HALF OF DIMENSIONS MILLIMETERS [IN.] CONNECTOR BODY LINE UP WITH NOTCHES IN FERRULE. TOLERANCES SURFACE 3.2 0 PLC: ± 1 8. SLIP BOOT OVER CONNECTOR AND TEXTURE: 1 PLC: ± .25 POLISH END 2 PLC: ± .127 3 PLC: ± .025 4 PLC: ± .013 ANGLE: ± 1/2°
METRIC
REMOVE BURRS AND SHARP EDGES FLATNESS .005mm PER mm ALL DIMENSIONS AFTER FINISH
60 2.4 "
PRODUCT MATERIAL
Industrial Fiber Optics NAME
FINISH DRAWN BY DATE CHECKED BY DATE
TEMPE, AZ 85281
51 0250
B. Bidwell 5/26/2011 A. Reyes 5/26/2011
FC Connector 1.0mm POF SIZE
A
SCALE
1:1
REV
PART NUMBER
51 0255
DO NOT SCALE DRAWING
A Sheet 1 of 1
