Transcript
Breakout Kit Installation Instructions
In:llN'\ Block for Flbtul 1.,8
Inltrt Bbel( for Flbtr. 7·12
fiber ktton!>tl
,
s.
Cable Preparation:
Slide the bu shing and nut up to the back of the hou sing and thread the nut into the housing. Tighten with adjustable wrench or pliers .
Crimp
, ..... A""
....
"~J
1. Slide the nut, 12 or 6 fiber bushing and crimp ring onto the
..
cable, leaving 60" of cable exposed. Note that only one end of
~-
the crimp ring will fit onto the crimp. That larger end must be positioned towards the end of the cable. Plug Screw(lI'2l
O-R.tng
2. Remove the ca ble jacketing, exposing 60" of the inner fibers. 3. Trim the Kevlar to approximately X" from the end of the
6. Thread the fibers through the appropriately colored furcation tubes in the insert block(s) .
jacket ing.
4. Using a utility knife, make a X" slit in both sides of the jacket as
HoUSlI"Ig
shown above .
----
-
Breakout Kit Assembly:
7. Install the insert blocks into the housing as shown
This procedure describes how to install the FIS breakout kit
above. C,. . R. .
c....
for 6 and 12 fiber cables. Tools Required:
1. Push the crimp into the jacket, fanning the Kevlar out around
Kit Contents: • Insert Block Assemblies (1 for 6 fiber, 2 for 12 fiber kits)
• Outer Shell • Housing • Plug (for 6 fiber use only) • Nut • Crimp • Crimp Ring
the flange . The slits cut in the jacket will allow the crimp to slide
• • • • • •
into the outer jacket.
Kevla r Sh ea rs Utility Knife
2. Slide the crimp ring up towa rds the crimp, wedging the Kevlar and cable jacketing in between the ring and the crimp.
Tape Measure
8. For 6 fiber use only. Install the plug into the unused side of the housing as shown above.
Buffer Tube Stripper Small Phillips Screwdriver
. . ." BIod..
Adjustable Wrench or Pliers
-.... 3.
In stall the G-ring onto the housing, being sure that it fully seats in th e groove .
Oueer .,..
9. Slide the outer she ll over the furcation tubing and over the housing as shown above. Align the
• Screw (x2)
notches and screw holes in the housing and shell.
• 12 Fiber Bushing • 6 Fiber Bushing Housing
• O-Ring
4. Slide the housing over the exposed fibers, being sure to split fiber 1-6 and 7- 12 to each side for a 12 fiber kit, and all 6 to one side for a 6 fib er kit. 10.
Insert the 2 screws and tighten .
