Preview only show first 10 pages with watermark. For full document please download

Manual - Bogen Communications

   EMBED


Share

Transcript

54-2202-01A_WMT1AS Manual:Layout 1 7/21/11 2:29 PM Page 1 Line Input / Line Output Matching Transformer Model WMT1AS The WMT1AS is a balanced and isolated impedance matching transformer with additional features that allow adapting of signal levels between various audio source and input types. Typical uses are to provide a 600-ohm balanced input adapter for unbalanced AUX inputs. WMT1AS can also be used to drive long, balanced, twisted pair cable. This improves noise rejection and the maximum run length. The WMT1AS can adapt speaker level signals (25V/70V systems) to a level suitable for the AUX input of an amplifier, adapt line-level signals down to levels suitable for MIC inputs and can adapt speaker level signals to MIC level as well. See the drawing below for setting the Operating Modes. APPLICATION SETTINGS SCREW TERMINALS RCA PLUG LINE 600Ω BAL INPUT* TO AUX LEVEL INPUT LINE TO SPEAKER LINE** TO AUX LEVEL INPUT MIC TO LINE LEVEL SOURCE TO MIC LEVEL INPUT SWITCH JUMPER ADAPT HI-Z AUX INPUT TO 600Ω BALANCED INPUT LINE ADAPT SPEAKER LEVEL TO HI-Z AUX INPUT SPK ADAPT LINE LEVEL TO MIC LEVEL INPUT LINE ADAPT SPEAKER LEVEL TO MIC LEVEL INPUT SPK MIC TO SPEAKER LINE** TO MIC LEVEL INPUT DRIVE 600Ω BALANCED LINE LINE LINE TO 600Ω BALANCED LINE FROM DRIVE SOURCE * SHIELD CAN BE CONNECTED TO CENTER TAP, MIDDLE SCREW **70V OR 25V SPEAKER SYSTEMS LINE SPEAKER SWITCH DOWN OPERATING MODE SELECTION SWITCH UP PIN Screw Terminal Mode Select JUMPER RCA Plug Mode Select JUMPER Specifications are subject to change without notice. ©2010 Bogen Communications, Inc. 54-2202-01A 1107 PIN LINE INPUT MIC INPUT 54-2202-01A_WMT1AS Manual:Layout 1 7/21/11 2:29 PM Page 2 LINE SPK AUX Level Signal to Amp Input 600 (Jumper in LINE Position.) 24kΩ 600Ω Input or Output (Switch in LINE Position.) 15kΩ CT RCA PLUG LINE MIC 25V/70V Speaker Connections MIC Level Signal to MIC Input (Switch in SPK Position.) (Jumper in MIC Position. Use suitable adapter for MIC connector style.) 150Ω 600 24kΩ TYPICAL PERFORMANCE SIGNAL FLOW OPTION SETTINGS NOMINAL IMPEDANCE 20 SW: LINE JMP: LINE 600Ω 10KΩ SW: LINE JMP: LINE 600Ω 10KΩ SW: SPK JMP: LINE 48KΩ 10KΩ SW: LINE JMP: MIC 600Ω 150Ω SW: SPK JMP: MIC 48KΩ 150Ω VOLTAGE GAIN* (dBr) 10 0 -10 -20 -30 -60 -70 60 100 1K * SOURCE IMP= 40Ω, LOAD IMP = 100KΩ 10K 20K FREQUENCY (Hz) L I M I T E D W A R R A N T Y The WMT1AS is warranted to be free from defects in material or workmanship for two (2) years from the date of sale to the original purchaser. This warranty does not extend to any of our products that have been subjected to abuse, misuse, improper storage, neglect, accident, improper installation or have been modified or repaired or altered in any manner whatsoever, or where the serial number or date code has been removed or defaced. 50 Spring Street, Ramsey, NJ USA Tel.: 201-934-8500 • Fax: 201-934-9832 • www.bogen.com