Transcript
MCS-D 3643 System Unit Order # 724.270
FEATURES
DESCRIPTION
• Shielded fully metal housing for “under the table installations” • Use as chairman or delegate microphone unit possible • Connections for buttons, gooseneck microphone, headphone and loudspeaker via Phoenix connectors and 5-pin XLR • Input select switch to select between microphone or line level • Low bus power LED
The MCS-D 3643 system unit has been designed for “under the table installations” in conference rooms. The MCS-D 3643 provides different connections to connect external components such as buttons, a gooseneck microphone and loudspeaker via 5-pin or 7-pin Phoenix terminals and a 5-pin XLR connector. By using the Lemo sockets the MCS-D 3643 is connected to the MCS-D 200 control unit or an external CA 4146 power supply unit. The MCS-D 3643 can be used as a chairman unit with microphone, clear and priority buttons or as a delegate unit with one microphone button. The microphone button is used to turn the microphone on or off. By using the priority button the chairman can interrupt the discussion and mute all activated delegate microphone units. By using the clear button the chairman can turn off all activated delegate microphone units. The system unit is powered via the bus cable and can be placed anywhere in the bus network. The operating mode of the microphone unit is configured via the MCS-D 200 control unit or the iCNS software. In the standard mode (free switching on) the participant can use the microphone button to switch the microphone on or off. In the request-to-speak mode the microphone button is used to enter a request-to-speak. The delegate can deactivate the requestto-speak by pressing the microphone button once more. In the automatic mode, the participant’s request is registered once the maximum number of active microphones has been exceeded. If a participant switches off his/her microphone, the microphone unit is switched on automatically. In the FiFo (first in - first out) mode, the delegates speak in succession. The delegate can use the microphone button to switch on the microphone. If the maximum number of open microphones is exceeded, the microphone of the speaker who has been speaking the longest is switched off.
OPTIONAL ACCESSORIES CA 1241
Piezo button without labelling . . . . . . . . . Order # 546.658 CA 1241 P Piezo button with “Prior” labelling. . . . . . Order # 546.666 CA 1241 C Piezo button with “Clear” labelling . . . . . Order # 546.674 Classis GM 314 E Gooseneck microphone with 5-pin male XLR connector, 400 mm, LED ring, without pre-amp, incl. wind shield. . . . . . . . . . Order # 489.581 Classis GM 315 E Gooseneck microphone with 5-pin male XLR connector, 500 mm, LED ring, without pre-amp, incl. wind shield. . . . . . . . . . Order # 489.565 MPR 211 Revoluto tabletop microphone, stone-grey Nextel® coating, microphone button, controlled by microprocessor, bare-ended connecting cable, length 3 m . . . . . . . . . . . . . Order # 488.429 MPR 211 B same as above, but painted black. . . . . . . . . . . . Order # 723.223
1 of 5 beyerdynamic GmbH & Co. KG Theresienstr. 8 | 74072 Heilbronn – Germany Tel. +49 (0) 71 31 / 617 - 0 | Fax +49 (0) 71 31 / 617 - 204
[email protected] | www.beyerdynamic.com For further distributors worldwide, please go to www.beyerdynamic.com Non-contractual illustrations. Contents subject to change without notice. E1/MCS-D 3643 (06.12)
MCS-D 3643 TECHNICAL SPECIFICATIONS
CONNECTIONS
General Dimensions (W x H x D) . . . . . . . 181 x 49 x 96 mm Weight. . . . . . . . . . . . . . . . . . . . approx. 600 g Temperature range. . . . . . . . . . . 0 °C - +40 °C System connections . . . . . . . . . . 2 x Push-Pull
Lemo connectors The MCS-D 3643 is connected to the MCS-D 200 control unit or CA 4146 power supply unit via the Lemo sockets. Furthermore, the Lemo sockets are used to connect the MCS-D 3643 with one another or other microphone units.
Power supply Power supply . . . . . . . . . . . . . . . via bus system (48 V) Power consumption . . . . . . . . . max. 5 watt (105 mA at 48 V)
Phoenix connectors
Analogue input Line In Input level . . . . . . . . . . . . . . . . . 500 mV maximal (-6 dBV) Input impedance . . . . . . . . . . . . 47 kΩ Frequency response . . . . . . . . . . 20 Hz to 20 kHz (±3 dB) Noise level . . . . . . . . . . . . . . . . . -100 dBV (A-weighted) Microphone input Phantom Power Supply voltage . . . . . . . . . . . . . . 48 V Input impedance . . . . . . . . . . . . 5.5 kΩ Level . . . . . . . . . . . . . . . . . . . . . 140 mV maximal (-17 dBV) Frequency response . . . . . . . . . . 60 Hz to 20 kHz (±3 dB) Noise level . . . . . . . . . . . . . . . . . -96 dBV (A-weighted) Microphone input Electret Power Optimised frequency response for beyerdynamic microphone series GM31xE, GM31xQ Supply voltage . . . . . . . . . . . . . . 4.5 V (6.81kΩ) Noise level . . . . . . . . . . . . . . . . . -100 dBV (A-weighted) Loudspeaker output Minimum impedance . . . . . . . . . 8 Ω Frequency response . . . . . . . . . . 20 Hz to 20 kHz Headphone output Minimum impedance . . . . . . . . . 16 Ω Frequency response . . . . . . . . . . 20 Hz to 20 kHz Output power . . . . . . . . . . . . . . 40 mW at 16 Ω Noise level . . . . . . . . . . . . . . . . . -86 dBV (A-weighted)
CONTROLS AND INDICATORS Input Select Switch To select the input source (microphone or line). Mic-Phantom 48 V Phantom power e.g. for a connected MPR 211 microphone Mic-Electret AB-powering e.g. for Classis GM 314 E / GM 315 E Line Line level e.g. for laptop Low Bus Power LED The Low Bus Power LED will illuminate red, when the power in the bus system is too low.
2 of 5 beyerdynamic GmbH & Co. KG Theresienstr. 8 | 74072 Heilbronn – Germany Tel. +49 (0) 71 31 / 617 - 0 | Fax +49 (0) 71 31 / 617 - 204
[email protected] | www.beyerdynamic.com For further distributors worldwide, please go to www.beyerdynamic.com Non-contractual illustrations. Contents subject to change without notice. E1/MCS-D 3643 (06.12)
5-pin connector You can connect a headphone or loudspeaker to the 5-pin Phoenix connector of the MCS-D 3643 system unit. LS + and LS - : connectors for a loudspeaker HP-L, HP-R and Com : connector for a headphone 7-pin connector You can connect e.g. the MPR 211 microphone or a microphone button and external indicators to the 7-pin Phoenix connector. Mic Button : to connect a microphone button LED-: to connect an external LED, which displays an active microphone +24 V : voltage source for the external LED GND: ground Audio + and Audio - : balanced microphone signal Shield: shield 2 x 5-pin connector You can connect individual buttons to the 2 x 5-pin Phoenix connector. Ch+ and Ch- : to adjust the language channel of a connected headphone Vol+ and Vol- : to adjust the volume of a connected headphone Prev : to allow the previous speaker of a request-to-speak list to speak, if the conference system is operated in the request-to-speak mode Next : to allow the next speaker of a request-to-speak list to speak, if the conference system is operated in the request-to-speak mode Clear : to turn on the chairman microphone unit while turning off the switched on or registered delegate microphone units. Depending on the operating mode the requests to speak are cleared or not. Prior : for prior turning on of a switched off chairman microphone unit, while muting the delegate microphone units temporarily GND: ground 5-pin XLR You can connect a microphone with LED ring such as Classis GM 314 E to the 5-pin XLR connector. Mini jack input You can use the line input (mini stereo jack 3.5 mm) to connect e.g. a laptop.
MCS-D 3643 CONNECTIONS Phoenix, XLR, mini Jack and Lemo
2x5-pin Phoenix terminal strip
5-pin XLR socket
7-pin Phoenix terminal strip
5-pin Phoenix terminal strip
Mini jack socket (3.5 mm)
3 of 5 beyerdynamic GmbH & Co. KG Theresienstr. 8 | 74072 Heilbronn – Germany Tel. +49 (0) 71 31 / 617 - 0 | Fax +49 (0) 71 31 / 617 - 204
[email protected] | www.beyerdynamic.com For further distributors worldwide, please go to www.beyerdynamic.com Non-contractual illustrations. Contents subject to change without notice. E1/MCS-D 3643 (06.12)
MCS-D 3643 DIMENSIONS
ARCHITECT’S SPECIFICATIONS The digitally controlled system unit shall be used as a chairman or delegate unit within the MCS-Digital conference network. Brackets shall be mounted for a remote installation. The system unit shall provide the following connections: terminal strip for external buttons for microphone switching on, priority switching and clear function; 5-pin XLR for external condenser (back electret) gooseneck microphones or phantom powered microphones, mini jack socket (3.5 mm) as line input and connections for external loudspeaker and headphone. The unit shall provide a direct connection for MPR 211 via 7-pin Phoenix terminal strip. The programmable priority function as a chairman unit shall provide functions such as turning on or turning on and clearing or muting of the turned on delegate microphone units. The system unit shall provide 2 x 6-pin LEMO sockets and a shielded fully metal housing. The dimensions shall be (W x H x D) 181 x 49 x 96 mm; the weight shall be approx. 600 g and the temperature range shall be 0 °C - +40 °C Manufacturer: Type:
beyerdynamic MCS-D 3643
4 of 5 beyerdynamic GmbH & Co. KG Theresienstr. 8 | 74072 Heilbronn – Germany Tel. +49 (0) 71 31 / 617 - 0 | Fax +49 (0) 71 31 / 617 - 204
[email protected] | www.beyerdynamic.com For further distributors worldwide, please go to www.beyerdynamic.com Non-contractual illustrations. Contents subject to change without notice. E1/MCS-D 3643 (06.12)
MCS-D 3643 INSTALLATION EXAMPLES Installation with external components and MCS-D 200 control unit
DT 1 S Classis GM 314 E button
Classis GM 314 E button
button
MCS-D 3643
DT 1 S
DT 1 S Classis GM 314 E
CA 43xx cable
max. 15 microphone units
CA 43xx cable
MCS-D 200
max. 30 microphone units (with second internal power supply in MCS-D 200)
+ CA 4100 internal power supply
Installation with external components, MCS-D 200 control unit and external CA 4146 power supply unit
DT 1 S
Classis GM 314 E button
DT 1 S
DT 1 S
Classis GM 314 E button
Classis GM 314 E button
MCS-D 3643
max. 45 microphone units; redundant cabling recommended for more than 40 microphone units
CA 43xx cable
CA 4146 external power supply
CA 4146 external power supply
5 of 5 beyerdynamic GmbH & Co. KG Theresienstr. 8 | 74072 Heilbronn – Germany Tel. +49 (0) 71 31 / 617 - 0 | Fax +49 (0) 71 31 / 617 - 204
[email protected] | www.beyerdynamic.com For further distributors worldwide, please go to www.beyerdynamic.com Non-contractual illustrations. Contents subject to change without notice. E1/MCS-D 3643 (06.12)
MCS-D 200
