Transcript
148(L)mm
148(L)mm
2000W HAIR DRYER
210(H)mm
User Manual
Model No.: KMD3817 *Before operating the unit, please read this manual thoroughly and retain it for future reference.
Fortress_MD3817 (Eng)_Cover_Date: 17.4.13
148.5(L)mm
148.5(L)mm
CONTENT
PAGE
SAFETY INSTRUCTION
3-4
OPERATION INSTRUCTION
5-6
MAINTENANCE INSTRUCTION
6
SPECIFICATION
7
210(H)mm
WARRANTY
8-9
2
Fortress_MD3817 (Eng)_Blank
Fortress_MD3817 (Eng)_Index_Date: 17.4.13
148.5(L)mm
148.5(L)mm
2000W HAIR DRYER SAFETY INSTRUCTION
22. Do not place in or drop into water or other liquids. If an appliance falls into water unplug appliance at mains socket immediately. Do not reach into the water.
1. To avoid electric shock, risk of fire or injury, please read the user manual carefully before using the appliance and keep it for future reference.
23. An appliance should never be left unattended when plugged in.
2. Please use suitable power source (220-240V~/50Hz). 3. Do not use the appliance under direct sunshine. 4. Please turn off and unplug the appliance before cleaning or maintenance. 5. When the appliance is not in use for a prolonged period, please turn it off, unplug it and pack it well. Then store it in dry cool place. 6. Forbid to put flammable and explosive objects around the appliance, and do not use the appliance in an environment full of flammable gas and powder. 7. Do not put any objects on the appliance and do not put the appliance immediately below a socket-outlet. 8. Do not touch the air outlet when operating. 9. Please keep the air inlet and outlet unblocked to minimize the risk of fire and malfunction. 210(H)mm
2000W HAIR DRYER
10. Do not let power cord touch and near air outlet. It will damage the insulation layer of wires. 11. Ensure no water or raindrop into the appliance in order to avoid electric shock. Do not put flammable objects or wet cloths on the air outlet in order to avoid short circuit or fire. 12. Please do not place air inlet or outlet near to curtain or wall when operating because it will block air current and cause a risk of fire. The appliance should be installed at minimum distant of 10 cm from the wall or other obstacle. 13. Please do not insert any objects into air inlet or outlet in order to avoid electric shock. 14. After a period of operation, there may be abnormal noise and uneven air volume because of dust blocking airflow. It will disappear after cleaning the dustproof filter. 15. WARNING: In order to avoid overheating, do not cover the appliance with flammable materials, such as cloths or paper. 16. CAUTION: In order to avoid a hazard due to inadvertent resetting of the thermal cutout, this appliance must not be supplied through an external switching device, such as a timer, or connected to a circuit that is regularly switched on and off by the utility. 17. Always unplug appliance immediately after use. 18. Never use in a damp room, or near a sink or other vessel filled with water. 19. When the hairdryer is used in a bathroom, unplug it after use since the proximity of water presents a hazard even when the hairdryer is switched off. 20. Always dry your hands before use. 21. For additional protection, the installation of a residual current device (RCD) having a rated residual operating current not exceeding 30mA is advisable in the electrical circuit supplying the bathroom. Ask your installer for advice.
3
Fortress_MD3817 (Eng)_P3_Date: 18.4.13
24. Close supervision is necessary when using this appliance on children or infirm persons. Children should always be supervised to ensure they do not play with the appliance. 25. This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety. 26. Use this appliance only for its intended use as described in this manual. Only use the attachments supplied by the manufacturer. 27. Never operate this appliance if it has a damaged cord or plug, if it is not working properly, or if it has been dropped, damaged, or immersed in water. 28. For safety reasons, broken or damaged mains cord may only be replaced or repaired by an equivalent cord from the manufacturer or qualified technician. Please do not repair or replaced by yourself. 29. Keep the cord away from heated surfaces. Do not wrap the cord around the appliance. 30. Do not use outdoors or operate where aerosol (spray) products are being used or where oxygen is being administered. 31. Do not use an extension cord with this appliance. 32. This product’s attachments will become hot during use. Do not let the heated surfaces come into contact with bare skin and eyes. Always hold the appliance by the handle and not by the cable. 33. Do not place the appliance directly on any surface while it is hot or plugged in. 34. Attachments may become hot during use. Allow them to cool before handling and storing. 35. Do not operate this appliance with a voltage converter. 36. Do not operate the machine without supervision. If you should leave the work place, always switch the machine off or remove the plug from the socket (pull the plug itself, not the lead). 37. This appliance is designed for household use only. 38. Never block the air suction openings or place in on soft surface (bed, couch or towel, etc.). WARNING: Do not use this appliance near bathtubs, showers, basins or other vessels containing water. “Caution!! Do not use this appliance near bathtubs, showers, basins or other vessels containing waters.”
4
Fortress_MD3817 (Eng)_P4_Date: 18.4.13
148.5(L)mm
148.5(L)mm
2000W HAIR DRYER
2000W HAIR DRYER
OPERATION INSTRUCTION
MAINTENANCE INSTRUCTION
When using electrical appliances, especially when children are present, basic safety precautions should always be followed, including the following:
Cleaning and caring
Initial and General Use
Recommend to clean the air suction opening from time to time with a fine brush. Clean the housing with a soft, dry cloth without additives.
Fit on a nozzle. You can dry single hair locks by concentrating the flow of hot air with the hairdressing nozzle. The diffuser is the ideal solution to dry curly hair without losing volume. Only connect the machine to a properly installed safety socket. Ensure that the voltage indicated on the identification plate corresponds with the mains voltage. ):
Removing the air suction cover Remove the cover after turning the cap through approximately 30 degrees against anticlockwise direction. Remove the intake filter and clean under running water. Dry the filter well before mounting again.
Position 1: low temperature
Fix the air suction cover
Position 2: medium temperature for gentle drying and shaping
Move the arrow “
▼
210(H)mm
Setting the Temperature Level (left switch
Ensure that the unit is switched off and unplugged before cleaning and storage. Leave the appliance until it turns to cool before putting it away.
” on the suction cover to match the arrow “
▼
Fully unwind the mains cable.
” on the hair dryer.
Position 3: high temperature for rapid drying Setting the desired air stream strength (right switch
):
Position 0: OFF Position 1: gentle steam of air Position 2: strong stream of air Cool shot function (
COOL ):
With this switch it is possible to interrupt the heating process so it is ideal for styling and shaping your hair. You can still adjust the air stream strength. Protect function (
This device has been tested according to all relevant current CE guidelines, such as electromagnetic compatibility and low voltage directives, and has been constructed in accordance with the latest safety regulations.
):
With this switch you can keep the constant caring temperature allows you to quickly dry your hair without over drying, the constant caring temperature is around 55oC ~ 62oC. You can have further cooler air by pressing COOL button. There is no obvious effect when adjusting the temperature level and air stream strength. Normal function (
Note : Turn off and unplug the appliance before cleaning or maintenance.
Subject to technical changes without prior notice!
):
With this switch stop the constant temperature function and return to a normal level.
5
Fortress_MD3817 (Eng)_P5_Date: 18.4.13
6
Fortress_MD3817 (Eng)_P6_Date: 17.4.13
148.5(L)mm
SPECIFICATION
148.5(L)mm
WARRANTY 1. The product has 1 year warranty from the date of purchase.
Model No. Product name
KMD3817
2. The warranty shall not apply: a.
to any Product subjected to accident, misuse, neglect, alteration, Acts of- God, improper handling, improper transport, improper use, improper testing or unauthorized repair;
b.
to cosmetic problems or defects which result from normal wear and tear under ordinary use, and do not affect the performance or use of the product. All warranties are void if the product is opened, altered, and/or damaged;
c.
to any packing, transportation, export / import tax or any related expenses.
2000W Hair Dryer 220 – 240V
Power
2000W
Dimension (W x H x D)
195(W) x 265(H) x 82(D)mm
210(H)mm
Voltage/Frequency
3. CUSTOMER MUST PRESENT THE SALES INVOICE OR RECEIPT FOR 1 YEAR WARRANTY SERVICES. 4. Please bring along the product and sales invoice or receipt to our services center for warranty services during office hour:. Address
: Unit A, 20/F, Yip Shing Industrial Centre, No.19, Yip Shing Street, Kwai Chung.
Service Hotline
: (852) 2428 1500
Service Hours Monday-Friday
: 9:00am - 6:00pm
Saturday
: 9:00am - 4:00pm
Sunday & Public Holiday : Closed 5. To prevent circuit overload and fire, no more than one adaptor or one extension unit should be inserted into a socket outlet. (Do not connect other appliances to the socket outlet supplying an electric heater.) No adaptor should be inserted into any extension unit or vice versa. 6. Stop using an adaptor or extension unit or socket if its socket holes cannot firmly hold a plug or if it is too hard to insert a plug into it. 7. This appliance must be plugged into a specific socket for 220V with no less than 10A provided. Please make sure the plug is fully plugged-in before use. Do not use any adapter or extension cord; Never use the same supply socket for this appliance and other appliances at the same time, in order to avoid damage to this appliance. 8. THE APPLIANCE IS FOR HOUSEHOLD USE ONLY.
7
Fortress_MD3817 (Eng)_P7_Date: 17.4.13
8
Fortress_MD3817 (Eng)_P8_Date: 09.4.13
148.5(L)mm
148.5(L)mm
IMPORTANT NOTICES IN NO EVENT SHALL OUR COMPANY OR THE SUPPLIER BE LIABLE TO YOU OR ANY OTHER PARTY FOR ANY DIRECT, INDIRECT, GENERAL SPECIAL, INCIDENTAL, CONSEQUENTIAL, EXEMPLARY OR OTHER DAMAGES ARISING OUT OF THE USE OR INABILITY TO USE THE PRODUCT (INCLUDING, WITHOUT LIMITATION, DAMAGES FOR INJURY, LOSS OF PROPERTY, BUSINESS PROFITS, BUSINESS INTERRUPTION) OR FROM ANY BREACH OF WARRANTY, EVEN IF OUR COMPANY OR SUPPLIER HAS BEEN ADVISED OF THE POSSIBILITY OF SUCH DAMAGES. IN NO CASE SHALL OUR COMPANY OR SUPPLIER’S LIABILITY EXCEED THE AMOUNT YOU PAID FOR THE PRODUCT.
210(H)mm
Specifications, designs and dimensions subject to change without prior notice.
9
Fortress_MD3817 (Eng)_P9_Date: 09.4.13
Fortress_MD3817 (Eng)_Blank_Date: 09.4.13
