Transcript
Operation Manual
www.megatech.com Entire contents © Megatech 2007
MegaBotz.indd 1
Rev. 200707191449
7/19/2007 3:21:51 PM
If you have questions about operating or assembling your new Megatech product... Please Call Megatech First!
DO NOT RETURN THIS PRODUCT TO THE STORE Call our Service Department at: (888) MEGA-911 or (201)662-8500 or email:
[email protected] 9:30am - 5:30pm, EST Monday through Friday (except holidays)
Technical assistance is also available on the web at www.megatech.com
READ ENTIRE MANUAL BEFORE ATTEMPTING TO USE TABLE OF CONTENTS
Safety Precautions......................................................................... 3 Package Contents........................................................................... 4 Getting Acquanted ....................................................................... 4 Installing the Batteries ................................................................ 5 Modes of Play................................................................................... 6 Assembling the Arena.................................................................. 6 Controlling your MegaBotz........................................................ 7 Trimming your MegaBotz............................................................ 8 Troubleshooting............................................................................. 8 Replacement Parts......................................................................... 9 Warranty..........................................................................................10
2 MegaBotz.indd 2-3
Important! Before you begin, please read all safety precautions and warnings. Failure to comply with any of the following could lead to bodily harm or injury. The Megatech MegaBotz are not intended for those under 10-years of age without proper adult supervision.
SAFETY PRECAUTIONS TRANSMITTER SAFETY Caution: changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. NOTE: This equipment has been tested and found to comply with the limits for a class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try correcting the interference by one or more of the following measures: - Reorient or relocate the receiving antenna. - Increase the separation between the equipment and receiver. - Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. - Consult the dealer or experienced radio/TV technician for help. - Since this model is controlled by an Optic link, it is very important to always keep a fresh alkaline battery in the transmitter. SAFETY GUIDELINES • You alone are responsible for operating your MegaBotz in a safe manner. You are responsible for your own safety and the safety of others around you. Follow these basic safety guidelines at all times. • Do not attempt to disassemble any of the MegaBotz components or allow them to get wet, electrical damage may occur. • Never use solvents or liquid cleaners to clean this model. Doing so may damage the unit or electronics. Only use a dry, soft cloth for cleaning. • MegaBotz are intended for indoor use only. • Use only fresh alkaline batteries for the transmitter and MegaBotz tanks. • Never leave the MegaBotz unattended when switched on. • Remove batteries from both the transmitter and MegaBotz Tanks when not in use or if you are going to store your MegaBotz for any length of time. • Keep the MegaBotz away from heat or fire. Never leave the model or transmitter in direct sunlight or heat for any length of time.
3 7/19/2007 3:21:56 PM
PACKAGE CONTENTS
MEGABOTZ TANK
1) Power and Mode Selection Switch - Selects the operating mode of your MegaBotz (See page 6)
Before getting started you will need (sold separately): • 12 - “AA” 1.5V Alkaline Batteries (six in each MegaBotz Tank) • 2 - “9V” Alkaline Batteries (one for each transmitter)
2) Laser Canon - This is the MegaBotz Tank onboard weapon. This cannon must be aimed at the target to score a hit when pressing the firing button.
First make sure the contents of your package are complete: • Blue MegaBotz Tank • Green MegaBotz Tank • Blue MegaBotz Transmitter • Green MegaBotz Transmitter • 14 Horizon Barriers • 14 Horizon Barrier Support Posts
3) Sensors - These sensors pickup the Laser Cannon fire and allow the MegaBotz Tank, while in AI mode, to identify surrounding objects and detect the other MegaBotz Tank during a battle.
NOTE: Keep the box and packaging to safely store your MegaBotz in-between uses.
4) Life Status Lights - Indicates how many remaining lives you hold. Each time a hit is scored, one of the five (5) status lights will flash and when there is another hit the light will go out. When all lights are off, all lives are used up.
GETTING ACQUAINTED WITH YOUR MEGABOTZ
INSTALLING THE BATTERIES
TRANSMITTER
1) Power Button - Press the power switch to power ON the transmitter. Press the button again to power OFF the transmitter.) 2) Power Indicator Light - The red light will illuminate on the front of the transmitter when the power is on. If the red LED dims or goes out, change the battery in the Transmitter with a fresh 9 volt alkaline battery.
INSTALLING THE TRANSMITTER BATTERIES
IMPORTANT! For proper battery placement, pay close attention to the diagram etched on the inside of the battery compartment and pay close attention to the proper (+ and -) polarity. The battery must be installed properly or your transmitter or vehicle will not function.
3) Left Stick - Forward and reverse throttle control stick. 4) Right Stick - Right and left steering control stick. 5) Steering Trim - When properly adjusted, the MegaBotz Tank will move straight ahead when no steering (right stick) control input is given. 6) Throttle Trim - When properly adjusted, the MegaBotz Tank will remain stationary when no throttle (left stick) control input is given. 7) Optic Control Emitters - must be kept facing your MegaBotz Tank at all times for proper control. 8) Right Button - Fires the laser cannon. MegaBotz Tank must be aimed at target to score a hit.
Each transmitter requires a fresh 9 Volt Alkaline battery. 1) Remove the rear transmitter battery hatch using a Philips screwdriver. (Not included) 2) Install the battery into the compartment. 3) Reattach battery hatch & secure with a Philips screwdriver. (DO NOT OVER TIGHTEN) INSTALLING THE MEGABOTZ TANK BATTERIES
Each MegaBotz Tank requires six (6) fresh 1.5 volt “AA” alkaline batteries. 1) Remove the rear transmitter battery hatch on the bottom of the vehicle using a Philips screwdriver. (Not included) 2) Install the battery into the compartment. 3)Reattach battery hatch and secure with a Philips screwdriver. (DO NOT OVER TIGHTEN)
9) Left Button - Activates the shields. The shields will only stay on for 4 seconds at one time. All incoming lasers are blocked and outgoing firing is suspended until the shield is down.
4 MegaBotz.indd 4-5
5 7/19/2007 3:22:03 PM
MODES OF PLAY
CONTROLLING YOUR MEGABOTZ
Your MegaBotz Tanks have three (3) modes of play competition. NOTE: Each time a hit is scored, one of the five (5) status lights will flash and when there is another hit the light will go out. When the hit takes place on a MegaBotz Tank, it will shudder for 4-seconds and cannot be controlled. When shuddering stops, normal control is restored. MODE-1: Mode 1 is designed so you and a friend can play. In this mode, both MegaBotz Tanks are switched to MAN (manual) and both transmitters are used. The player to score 10 hits on his opponent wins the match. MODE-2: In Mode 2 you battle against the on-board computer of the other MegaBotz Tank. The MegaBotz Tank you are controlling is switched to MAN (manual), and the other MegaBotz Tank is switched to AI (Artificial Intelligent). The MegaBotz Tank switched to AI mode will now continue to battle until the game is over. Remember that the MegaBotz Tank switched to AI mode does not need the transmitter to play.
MOVE MEGABOTZ FORWARD
Push the left-hand stick forward
MODE 1 MOVE MEGABOTZ BACKWARDS
Push the left-hand stick back.
MODE 2 TURN MEGABOTZ LEFT
Push the right-hand stick left.
NOTE: Before operating the MegaBotz, make sure your trim adjustments are properly set as noted on page 8. MODE-3: In Mode 3 both MegaBotz Tanks are switched to the AI (Artificial Intelligent) mode. Both MegaBotz Tanks will battle each other on MODE 3 there own, without any control input by the transmitter. The Tanks will battle each other until the game is over. The first MegaBotz Tank to score all 10 hits will win the battle. Remember that both transmitters are not required for this type of battle. IMPORTANT NOTE: In Mode 2 and Mode 3 the Horizon Barrier Arena must be used. In mode 1 you can operate the MegaBotz with, or without the Horizon Barrier Arena. Please follow assembly instructions for the Arena below.
TURN MEGABOTZ RIGHT
Push the right-hand stick right.
FIRE THE MEGABOTZ LAZER
Press the right-hand button.
ASSEMBLING THE ARENA Follow the instructions below and repeat until the entire circular arena is built. NOTE: It is suggested to setup the arena indoors away from direct sunlight as it may affect the performance of the sensors. TURN ON PROTECTIVE SHIELD
Press the left-hand button.
Take a barrier panel and Place a barrier panel Overlap a second barrier two halfs of the plastic over the support, lining panel and position the support. up the holes in it with the other half of the support pegs in the support. as shown.
6
MegaBotz.indd 6-7
Close the support, making sure the pegs and bottom snap shut
NOTE: Shields will activate for 4 seconds. Your MegaBot will be protected during this time, but you will also not be able to fire your lazer.
7 7/19/2007 3:22:10 PM
TRIMMING YOUR MEGABOTZ
REPLACEMENT PARTS
Your MegaBotz should come from the factory pre-adjusted for proper control. If for some reason you find your vehicle moving or turning without any input from you, follow these simple steps to correct your trims.
Spare, repair and replacement parts are readily available for your MegaBotz should you need, visit your local hobby dealer first. If unavailable, you may order directly from Megatech. Use this sheet as a guide.
1) Turn the MegaBotz tank upside down so you can see the wheels moving.
PART#
2) While pointing the controller at the tank, adjust the steering trim (top dial) on the transmitter until both wheels are spinning in the same direction, at approximately the same speed.
MTC900301 Complete Replacement Transmitter (BLUE)
3) Continue pointing the controller at the tank and adjust the Speed Trim (bottom dial) on the transmitter until both wheels stop spinning. Your MegaBotz tank is now accurately trimmed.
MTC900304 MegaBotz Complete Replacement Tank (GREEN)
TROUBLESHOOTING
Always make sure your transmitter and MegaBotz tanks batteries are fresh, as this can be the cause of many operational issues. CAUSE Battery is incorrectly installed.
Make sure battery is installed in the correct direction.
MegaBotz Tanks are not following the transmitter commands.
You are not aiming directly at the MegaBotz Tank with the Transmitter.
Aim the Optic-Control Emitters at the vehicle. They must be facing your vehicle at all times.
The game is over and all status lights have gone out.
Both MegaBotz Tanks must be switched OFF and back ON again to start a new game.
MegaBotz Tank will not power up or the game will not start.
Mode selection switch is still Reset the mode by moving the active from prior game. mode selector switch to OFF first then reselect the correct mode again.
MegaBotz Tank starts moving or turning without any control input.
Trim is not adjusted on the transmitter.
MegaBotz.indd 8-9
MTC900303 MegaBotz Complete Replacement Tank (BLUE) MTC900305 Horizon Arena with Support Posts MTC900306 Battery Hatch with Screw for MegaBotz Tank
Telephone Orders: (201) 662-2800 www.megatech.com
Fax Orders: (201) 662-1450 email:
[email protected]
SOLUTION
No power to Transmitter
8
MTC900302 Complete Replacement Transmitter (GREEN)
MTC900307 Battery Hatch with Screw for Transmitter
If you are experiencing trouble, please follow these guidelines or call one of our Technicians at 1-888-634-2911. We will have you up and running in no time!
PROBLEM
DESCRIPTION
Adjust the trim settings as indicated in the section above.
9 7/19/2007 3:22:14 PM
WARRANTY
NOTES
Megatech® Limited Warranty Megatech® International guarantees this item to be free from defects for a period of 30 days from date of purchase. This warranty does not extend beyond the initial testing. Carefully check parts and operation BEFORE you operate your MegaBotz. Damage incurred because of misuse or modification is not covered under the warranty. If you discover defects during the very first operation during this 30 day period, please call our Support Team toll free at 1-888-634-2911 for Return Authorization. If in our opinion after inspecting the product, we determine it to be defective; we will repair or replace it at our discretion. Contact the Megatech® International Service Department before returning any item that is defective according to the limitations listed above. If you are issued return authorization and asked to send the item to our Service Department please follow these steps: • Remove all alkaline batteries from the Transmitters and MegaBotz Tanks. • Pack the returned item(s) carefully and place in a sturdy shipping carton. • Return the product along with proof of purchase. • IMPORTANT!! Include a letter describing the problem. • Include your Name, address and telephone number in the letter. • Include $7.99 for return shipping & handling. (AK, HI & PR add $10; for international shipments actual shipping charges apply) Megatech International ATTN: Service Department 8300 Tonnelle Avenue North Bergen, NJ 07047 (201) 662-8500 This warranty does not cover any damage caused by use, misuse, alteration, accident, or neglect, nor does it cover normal wear and tear of the product. Product returned to us that falls under this category will be submitted to our service department for repair. We reserve the right to charge any service and parts fees incurred when repairing the item. Although this warranty does not cover any damage caused to the product after the initial testing, spare parts and service are available. Please see the parts section of this manual. Under no circumstances will Megatech® International or any of its representatives be held liable for injury to persons or property damage resulting from assembly or use of the product. Megatech® is not liable if any outside frequencies interfere with the product’s frequency causing loss of control. Megatech® International will not be held liable for any personal injury or property damage resulting from an out-of-control model caused by use or misuse of the product. This warranty is void if the product in question has been altered or repaired by anyone other than Megatech International or an authorized agent.
10 MegaBotz.indd 10-11
11 7/19/2007 3:22:19 PM
Megatech® International 8300 Tonnelle Avenue North Bergen, NJ 07047 (201) 662-8500 www.megatech.com Email:
[email protected]
MegaBotz.indd 12
7/19/2007 3:22:19 PM
