Transcript
Micro Imaging Devices Modular Mini Camera Installation Guide
Document 920.0105 – 02/05 – Rev 2.00
Unpacking Check that the items received match those listed on the order form and packing slip. The Micro Imaging Devices (MID) Modular Mini Camera packing box should include, in addition to this Installation Guide: • One MID Modular Mini Camera
•
One Swivel mount
• One Wall/desk mount
•
Hardware kit
•
VA 100 Video adapter
• One Product Warranty Card Optional items •
RCA to BNC adapter
•
Power supply
Overview The CMOS camera is a complete video camera product that requires only a power supply to produce a video output signal. If you have a TV or VCR with a video input connector (typically an ‘RCA’ style jack with a yellow inner plastic connector) you may connect the output of the camera directly into your TV or VCR. Figure 3 shows typical installation of the video camera product with a TV, VCR, Security monitor, and PC system. Most cables and cable adapter accessories, including A/B switches, are available in the electronics/home theater department at most electronic/ video retail outlets. Note
Rev 2.00
The RCA to BNC adapter is supplied with the optional VA 100 video adapter for BNC-style cables.
1
Document 920.0105 02/05
Connectors Power Pack Barrel Connector Specifications
I.D.
O.D.
Figure 1
Barrel length Inner Barrel (+) 6 - 12 VDC unregulated, 2.1 mm I.D. Outer Barrel (-), 5.5 mm O.D. Barrel Length, 12 mm
Figure 2
RJ-11 Modular Connector Pin Assignments
Pin 1
Pin
Color
Function
1
Red
VCC (+6 VDC)
2
Black
Ground
3
Blue
Video Ground
4
White
Video Out
Camera Power Input Requirements Voltage 6.0 VDC recommended a 5.35 VDC minimum (including ripple)a 12 VDC maximum Current 33 ma typical at 6.0 VDC a. Voltage above 6.0 VDC increases power and heat which degrades camera SIGNAL-to-NOISE RATIO.
Rev 2.00
2
Document 920.0105 02/05
Installation Caution
Always turn power off to all devices before making connections.
Install the camera type (NTSC or PAL) that matches the display format of your television or video display. Figure 3
System Installation
** security monitor
* Power supply
* RCA to BNC ** BNC to BNC cable adapter
Camera
** VCR with RCA video input jack
** Video cable
* VA 100
** Television
** “Frame Grabber” or video capture card ** Laptop or PC * Optional items that can be purchased at time of camera purchase or through your distributor: • RCA to BNC adapter • VA 100 Video adapter • Power supply ** Not supplied
Rev 2.00
3
Document 920.0105 02/05
Warranty and Service Subject to the terms and conditions listed on the Product Warranty card, Honeywell will repair or replace, at its sole option, free of charge, any defective product returned prepaid. In the event you have a problem with any Honeywell product, please call Customer Service for assistance or to request a Return Authorization (RA) number. In the U.S.A. and Canada, call 1.800.796.2288. Be sure to have the model number, serial number, and the nature of the problem available for the technical service representative. Prior authorization must be obtained for all returns, exchanges, or credits. Items shipped to Honeywell without a clearly identified Return Authorization (RA) number may be refused.
Rev 2.00
4
Document 920.0105 02/05
Regulatory Notices FCC Statement (U.S.A.) IThis equipment has been tested and found to comply with part 15 of the FCC Rules. Operation is subject to the following conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
Industry Canada Notice This Class B digital apparatus meets all requirements of the Canadian Interference-Causing Equipment Regulations. Cet appareil numérique de la Classe B respecte toutes les exigences du Réglement sur la matériel brouilleur du Canada.
ΠThis Πmark on the product indicates that the system has been tested to and conforms with the provisions noted within the 89/336/EEC Electromagnet Compatibility Directive.
Safety Warning Any connection of this device to any equipment other than the intended application may result in a safety hazard, and/or defective operation, and/or equipment damage.
Rev 2.00
iv
Document 920.0105 02/05
Honeywell Video Systems www.honeywellvideo.com +1.800.796.CCTV (North America only) © 2005 Honeywell International Inc. All rights reserved. No part of this publication may be reproduced by any means without written permission from Honeywell Video Systems. The information in this publication is believed to be accurate in all respects. However, Honeywell Video Systems cannot assume responsibility for any consequences resulting from the use thereof. The information contained herein is subject to change without notice. Revisions or new editions to this publication may be issued to incorporate such changes.
