Transcript
MK - Splash Hood for MK-370/470
Part Number 158281
This instruction sheet contains instructions for the MK-370/470 Splash Hood and the MK-770 Splash Hood. The Splash Hood is designed to reduce water spray generated during the operation of the tile saw.
1. MK370/470 Splash Hood Installation Procedure: Saw
Water Pan
Saw
Splash Hood Base
(A) Remove the saw from the Water Pan
Splash Hood Cover
(D) Place the Splash Hood cover over the motor and seat the cover on the Splash Hood base
Seating Point
(B) Seat the base of the Splash Hood inside the Water Pan
Splash Hood Base
Water Pan
(C) Seat the saw in the Water Pan/ Splash Hood base assembly (Ensure the saw is securely seated)
Cutting Distance
(D) Cutting Distance from the blade to either side is approximately 7-inches
NOTE: Due to tolerances in design, Step B may be performed by placing the Saw into the Splash Hood base, and then placing the Saw/Splash Hood Base assembly into the Water Pan. If problems arise during installation, contact the MK Diamond Service Center at (800) 421-5830. MK Diamond, Products, Inc, 1315 Storm Parkway, Torrance, CA 90509-2803, (310) 539-5158 Manual Part Number 157292
Revision 06/01, Effective Date: June 1, 2001
Page 1
MK - Splash Hood for MK-770
Part Number 151924
This instruction sheet contains instructions for the MK-370/470 Splash Hood and the MK-770 Splash Hood. The Splash Hood is designed to reduce water spray generated during the operation of the tile saw.
2. MK770 Splash Hood Installation Procedure: Removal Direction
Seating Point
Cutting Head
Rotate Up
Removal Direction
(A) Remove the Cutting Head
(B) Remove the Water Pan
Cutting Head Post
Rear Bar
(C) Slide the left side of the Splash Hood base over the rear bar of the saw frame
Splash Hood Base
Guide Bar
Installation Direction
(D) Slide the left side of the Splash Hood base under the inside of the Cutting Head Post and behind The Guide Bar Cutting Head
Splash Hood Base
Installation Direction
Rotate Down
(G) Install the Cutting Head and seat
Seating Point
(E) Install the Water Pan into the saw and under the Splash Hood base
Splash Hood Cover
Splash Hood Base
(F) Verify the Splash Hood base is seated inside the Water Pan
Motor
Seating Point
(H) Install the Splash Hood cover over the Cutting Head motor and seat it inside the Splash Hood base
NOTE: If problems arise during installation, contact the MK Diamond Service Center at (800) 421-5830. MK Diamond, Products, Inc, 1315 Storm Parkway, Torrance, CA 90509-2803, (310) 539-5158 Manual Part Number 157292
Revision 06/01, Effective Date: June 1, 2001
Page 2
