Transcript
Installation
Specifications
Place the lead from the antenna into the input of the amplifier; connect the television outlets to the four outputs. This unit can take the place of an existing passive splitter. The bracket that has been included is mounted to the rear of the Splitter Amplifier with the two screws provided. The unit should then be placed in a weatherproof location. An optional MHB001 outdoor housing is available if the unit is to be placed outside. The Power Adaptor is then placed behind any one, or all, of the television outlets with the power then feeding back up the coaxial cable.
Frequency Range
VHF: 44 - 470 MHz UHF: 470 - 820 MHz
Max Gain
VHF: 12 dB UHF: 16 dB
Noise Figure Output Figure Return Loss Gain Controls Supply Voltage
INSTALLATION MANUAL
< 3.5 dB
MODEL SA164R
100 dB DIN45004B 2ch (-60 dB IMR)
Thank you for selecting an Australian designed and built Splitter Amplifier.
14 VOLT DC INPUT
PSK06F
VHF Tilt Control, 8 dB PSK06 14 V DC @ 80 mA
Please Note: An F Type Adaptor has been included to fit an F Type wall plate. However, the insert from the wall plate can be removed and the Power Injector may be fitted directly with the locking nut provided.
The SA164R is a low noise F Type Splitter Amplifier that is ideal for all digital and analogue installations. •
T he unit can be powered to any of the four outputs or all four outlets if you use DC power supplies (The same function as the SAM224). This is ideal if there is no common power.
•
There is a power pass link that when activated can pass power through to a Masthead Amplifier, if required.
•
A low band tilt control and LED have been included to assist with the installation and a regulator to ensure optimal performance.
LED
1. C heck there is no earth braid touching the centre conductor on the coaxial cable. 2. Is the LED on inside the amplifier? If not check the cable run up to the unit to ensure nothing is stopping the voltage from reaching the amplifier. (A Voltmetre may assist with this.)
14 V DC TO
Splitter Amplifier
> 10 dB
Technical advice
PSK06F
Optimised for both Digital and Analogue TV Signal Amplification
3. Is there now too much signal causing an overload effect to the VCR? Try turning down the tilt control on the unit.
For maximum VHF tilt turn control anti-clockwise.
WARRANTY Standard Communications PTY. LTD. warrants this Kingray product to be free from defects in material and workmanship for a period of 3 years from the A Division of
date of installation and reserves the right to void warranty if unit was misused, improperly installed or damaged by claimant.
Standard Communications PTY. LTD.
Head Office: Locked Bag 2086, North Ryde N.S.W. 1670 P: (02) 9844 6666, F: (02) 9844 6600
Drawing No: 42259-3 Part No: 310225
Sydney P: (02) 9879 8888 F: (02) 9816 4722 E:
[email protected]
Melbourne P: (03) 9798 0988 F: (03) 9798 0177 E:
[email protected]
Brisbane P: (07) 3278 6444 F: (07) 3278 6555 E:
[email protected]
Adelaide P: (08) 8234 2633 F: (08) 8234 5138 E:
[email protected]
Perth P: (08) 9455 5744 F: (08) 9455 3110 E:
[email protected]
www.gme.net.au Auckland P: (09) 274 0955 F: (09) 274 0959 E:
[email protected]
