Transcript
Quick Start Guide TeleEye MX151E-HD Network Camera This Quick Start Guide will guide you how to install and configure the TeleEye MX151E-HD Network Camera for remote video monitoring.
1. Camera Installation Step 1
After mounting the camera on the wall or ceiling, connect the Ethernet cable to the LAN adapter. If PoE is not available, connect the 12VDC power supply to the power cable.
[Reference] Please refer to the section 2 for connecting the cable to RJ45 plug. Power Cable (12V DC)
Ethernet Cable
12V DC Power Adapter (Optional)
Alarm Cable
Step 2
Network switch / Router
Start sureSIGHT or a web browser to start a remote video monitoring in order to adjust the camera.
[Reference] Please refer to the following sections to understand how to start video monitoring.
Step 3
Loosen the bolts to adjust the vertical angle and rotational view of the camera
Rotational View
Vertical Angle
1
2. RJ45 Wiring Step 1
Make sure whether Type A or Type B wiring scheme is used for the Ethernet cable (Type B is more common).
Step 2
The two colour codes indicated on the plug represent the wiring scheme for Type A and Type B cables. Type A Wiring Scheme Type B Wiring Scheme
Step 3
Open the tab of the plug
Step 4
According to the wiring scheme of the cable, follow the corresponding colour code on the plug to arrange the 8 wires. Close the tab after inserting the 8 wires into the wire holders.
Insert the 8 wires
Close the tab
3. Default User Name and Password Default user name is “admin” while default password is “0” + “digits of serial number”. Here is an example:
Serial Number : MXC10210 User Name : admin Password : 010210 2
4. IP Setup Utility Step 1
After installing sureSIGHT and turning on the Network Camera, select “Run TeleEye IP Setup Utility” from the windows start menu.
Step 2
Search the target camera by its serial number, highlight the corresponding row from the list on the left side of the window to select it. If the camera cannot be found, click the [Refresh] button.
Step 3
Press [Edit] button to change the network settings of the camera, including IP, ports, mask, etc.
Step 4
Enter user name and password to save the information when prompted.
[Reference] Please refer to section 3 for the default user name and password.
5. Live Monitoring with Web-Browser Step 1
Type the IP address of the Network Camera in a web browser.
Step 2
Input the user name and password.
[Reference] Please refer to section 3 for the default user name and password.
Step 3
Click the [Connect] button to connect the selected video stream. Video will then be displayed on the browser as follow. 3
6. Live Monitoring with sureSIGHT Step 1
After installing sureSIGHT and turning on the Network Camera, select “Run sureSIGHT Lite” from the windows start menu. Input the user name and password to log-in to the sureSIGHT. [Reference] Please refer to section 3 for the default user name and password.
Step 2
Click the [
Step 3
Search the target camera by its serial name and click its corresponding box on the left. you may choose more than one camera. Click [Next] after selection.
] button on the top of the sureSIGHT.
4
Step 4 Input the user name and the password. Then, click [Next].
[Reference] Please refer to section 3 for the default user name and password.
Step 5 You may click [Details] to change the site name and IP/sureLINK. After setting, click [Finish].
Step 6 The video will be displayed on sureSIGHT by double clicking the site on the left panel.
[Reference] For detail operations, please refer to sureSIGHT user manual.
5
