Transcript
NBASS10-20 10” BASS GUITAR WOOFER NEODYMIUM MAGNET STEEL BASKET DRIVER
- 2 INCH VOICECOIL - 96 dB/SPL SENSITIVITY - 300 WATT PROGRAM POWER HANDLING - OVERALL BALANCED AND RICH TONE - SOLID LOW-END AND TIGHT MID-HIGH’S - EXTREMELY LIGHTWEIGHT
GENERAL SPECIFICATIONS
FREQUENCY RESPONCE 250 (10) 8 5,6 300 150
dB 96 Hz 46 ÷ 5200 mm (in.) 50 (2) Steel Neodymium mm 51 x 9 (in.) (2.0 x 0.35) Copper Glass fiber Water Proof Treated Paper Polycotton mm (in.) 6,5 (0.26) mm (in.) 10,7 (0.42) mm (in.) 8,2 (0.32) mm (in.) 17,2 (0.67)
Impedance (Ohm)
mm (in.) Ω Ω W W
SPL (dB) @ 2.83V, 1m, half space
Nominal diameter Nominal impedance Minimum impedance Program power (1) AES Power rating (2) Sensitivity (3) Frequency range Voice coil diameter Chassis material Magnet material Magnet dimensions OD x ID x h Coil material Former material Cone material Surround material Xmax (4) Xmech (5) Gap height Voice coil winding height
Frequency (Hz)
DIMENSIONS mm (in.)
Re Fs Mms Cms BxL Qms Qes Qts Vas Le Sd Eta 0
Ohm Hz g (oz) mm/N N/A
l (ft3) mH cm2 (in.2) %
5,2 46 35 (1.23) 0,34 12,0 6,8 0,37 0,35 59 (2.1) 0,7 353 (139) 1,53
SHIPPING INFORMATION Net weight Multipack size (8) WxDxH Multipack weight
Kg (lb.) mm x mm x mm ( in. x in. x in.) Kg (lb.)
WWW.LAVOCESPEAKERS.COM
1,3 (2.8) 556 x 484 x 288 (22 x 19 x 11.3) 14,48 (31)
(1) Program power is defined as 3 dB greater than AES Power. (2) Tested for two hours using a continuous, band-limited pink noise signal as per AES 2-1984 Rev. 2003. Loudspeaker tested in free air. (3) From T/S parameters, measured with Klippel DA LPM module. (4) The Xmax is calculated as: (Hvc - Hg)/2+ Hg/4. Hvc is the voice coil height and Hg the gap height. (5) The Xmech is calculated as: (Hvc - Hg)/2 +(Hg-2). Hvc is the voice coil height and Hg the gap height. (6) Thiele-Small parameters are measured after preconditioning: a) at 20°C- 22°C, 50% humidity for 2 hours; b) by Klippel LSI measurement.
Lavoce Italiana
[email protected] [email protected]
All specifications subject to change without notice_A.a
SMALL SIGNAL PARAMETERS DC resistance Resonance frequency Moving mass Compliance Force factor Mechanical Q-factor Electrical Q-factor Total Q-factor Equivalent air volume Voice coil Inductance Diaphragm area Reference efficiency
