Preview only show first 10 pages with watermark. For full document please download

Nextiva S19x0e Rackmount Plate Installation Guide

   EMBED

Share

Transcript

Nextiva S19X0e Rackmount Plate The S19X0e rackmount plate can accomodate up to eight Nextiva S1900e series devices. Installation Guide 2. Install the device on the rackmount plate with the supplied screws the following way: Dimension: 3U, for 19-inch racks. The required screwdriver is a Torx T-8. To install the rackmount plate: 1. On the back of the S19X0e device, carefully remove the two screws. Opening for the wires Mounting hole 3. Put the I/O and power wires in one of the two horizontal openings at the bottom of the rackmount plate. Note: The two horizontal openings may not be present on all plates. Note: Ensure that the plastic molding does not fall apart. 4. After all the devices are properly installed, install the rackmount plate in the rack using the four mounting holes located at the corners of the plate. The screws are not supplied. © 2007-2009 Verint Systems Inc. All Rights Reserved Worldwide. March 12, 2009 www.verint.com/manuals 23-500-0021-002