Transcript
Pin Out for the IR: RECEIVER 1. Signal Input 2. + 5.6V 3. GND
Warning : Using a mono connector will damage the UNIT.
CE labs can support many areas of your audio and video distribution needs. We manufacture: • Digital Signage software and Media Players • HD Matrix Switchers • RF amplifiers • HDMI and Component HD distribution amplifiers • CAT 5 Signal Extenders • VGA Extenders and Splitters • and cables of all types. See our full product line at www.celabs.net
WARRANTY
Cable Electronics, Inc. warrants this product to be free from defects in material and workmanship, under normal use and service, for a period of one year from the purchase by the original purchaser. If this product is defective or malfunctions, Cable Electronics Inc. will replace or repair this unit (at their option) within a reasonable time. No expressed or implied warranty is made for any defects caused by immersion or exposure to liquids, abuse, neglect, improper operation of unit, excess wear and tear, act of nature, including, but not limted to, fire, flood or lightning, and defects resulting from unauthorized disassembly and or modification.
3209 Wood Drive Garland, TX 75041 Phone: (469) 429-9200 Toll free: (800) 767-6189 Fax: (469) 429-9205 www.celabs.net
Document: HM1CK-3_manual.pdf 930-5065-01_ Rev.B00
INSTRUCTION MA NUA L
EMITTER(Blaster ) 1. Signal Output 2. + 5.6V 3. GND
HM1CK-3
HDMI™ UTP Extender Series
Key Features:
• Uses only one CAT5e/6/6a/7 cable • HDMI™ 1.3 and HDCP compliant • 3D ready • Extend signal up to 328ft(CAT5e and CAT6a/7) at 1080p/60Hz/48 bit • Bi-Directional control signal RS-232 allowing status request and control of the destination unit • Bi-Directional IR control signal (30 - 60 KHz maximum) • Uncompressed high definition video up to 1080p/60Hz/48bits • Maximum data rate 3.4 Gbps • Audio transmission supports Dolby TrueHD, DTS-HD MA • No adjustment required • 4K x 2K Supported
PANEL VIEW
INSTALLATION VIEW
Transmitter
HDMI display
328 ft CAT5e/6/6a/7 Cable
HDMI source
receiver
HDMI output
HDMI input
transmitter
LED INDICATION
Receiver
Green Blue Red RJ-45 Green
Power IR Reveive IR Transmit Link
CAUTION CABLE
CE labs recommendation: TIA/EIA-568-B. High quality CAT 5e, CAT6, CAT6a, and CAT7 UTP (Unshielded Twisted Pair )/STP (Shielded Twisted Pair ) or FTP (Foiled Twisted Pair) cables.
RJ45 Define: Video Link (TIA/EIA-568-B) 1. Orange/White 2. Orange 3. Green/White 4. Blue 5. Blue/White 6. Green 7. Brown/White 8. Brown
Data0 + Data0 Data1 + Data2 + Data2 Data1 Data3 + Data3 -
SPECIFICATIONS
TRANSMISSION DISTANCE
The maximum tarnsmission distance is up to 328 ft, lower resolutions will not allow longer distances. Cable length should be less than 5 meters (15 ft) between the HM1CK and wall jack. Max 328 ft Transmitter
Max 5M Power
Wall Jack
• Cable length must be less that 15 ft between HDMI extender and wall connectors (RJ45 jacks). • CAT5e/6/6a/7 cable must be away from any device, wire, cable, etc. that generate EMI (electromagnetic interference). Examples: Microwave, cellular phones, radio equipment, fluorescent lamps, high-voltage power lines. • DO NOT USE regular CAT5 cable. It does not have enough bandwidth. • DO NOT connect to any network. • DO NOT USE stranded cable. • DO NOT place the IR emitter and IR pickup facing each other. This could cause interference. • DO NOT connect the transmitter or receiver to an AC source shared with a motor device • There must be a power supply to both the transmitter and receiver
Wall Jack
Receiver
Max 5M Power
Resolution Distance HDMI Connector RS-232 Baud Rate RS-232 Connector IR Carrier Power Supply Power Consumption Temperature Humidity Dimensions Weight
Transmitter Receiver 4K x 2K/1080P/60Hz/48 bit 328 ft/100M (max) Type A Up to 115200 bps/Full Duplex DB9 Female DB9 Male 30 - 60Khz/±10°/30 ft max Regulated 5V/2Amp 600mA (Max) 1200mA (Max) Operation: 0 to 55°C, Storage: -20 to 85°C Up to 95% 5 1/8” x 3 1/2” x 1 1/8” 10 oz. 10 oz.
A
