Transcript
OB36, OB52, OBS36, OBS52, OBSB162 Document # PG13-001
Revised 05/06/10 Page 1/3
PLANNING GUIDE
36”, 52” Wide Outdoor Grills 16” Wide Side Burner All tolerances: +1/16”, -0, (+1.6mm, -0) unless otherwise stated
warning 25 1/8" (638mm)
•
Observe all governing codes and ordinances during planning and installation. Contact your local building department for further information.
•
This appliance must be installed in accordance with the accompanying installation instructions.
9 1/8" (232mm)
36" (914mm)
23 3/4" (603mm)
25 1/8" (638mm)
26 1/2" (673mm) 27” * (686mm)
oB/OBS36 overall dimensions
9 1/8" (232mm) 52" (1321mm)
23 3/4" (603mm) 26 1/2" (673mm) 27" * (686mm)
9 1/8" *** (232mm)
oB/OBS52 overall dimensions
23 3/4" (603mm) 26 1/2" (673mm) 27" ** (686mm)
16" (406mm)
*Total depth with handle: 30” (762mm) **Total depth with knobs: 28 5/8” (753mm) ***Total height with cover: 12” (305mm)
OBSB162 overall dimensions Model Type
Electrical Circuit Required
Total Connected Load
Gas Type
Manifold Pressure
Minimum Gas Supply Pressure
Natural Gas
120 Vac, 60 Hz, 15 Amp.
2.9 Amps (0.35 kW)
Natural
4” Water Column
5” Water Column
LP Gas
120 Vac, 60 Hz, 15 Amp.
2.9 Amps (0.35 kW)
Propane
11” Water Column
12” Water Column
Note: Supply access for the rotisserie power or an alternate 120 Vac duplex outlet location. Specifications subject to change without notice. Install all appliances according to accompanying installation instructions.
www.Dacor.com
Phone: (800) 793-0093
13.1
OB36, OB52, OBS36, OBS52, OBSB162 Document # PG13-001
Revised 05/06/10 Page 2/3
PLANNING GUIDE
36”, 52” Wide Outdoor Grills 16” Wide Side Burner OBSB162 16 1/8" (410mm)
OB(S)36 - 36 1/2" (927mm) OB(S)52 - 52 1/2" (1334mm) 9" (228mm) Max.
3/4" (19mm) Min. to any material for ventilation
36" (914mm)
OBSB162 & OB/OBS/36/52 cUTOUT DIMENSIONS, FRONT VIEW (OBAD 36” Accessory Door Shown) Specifications
Cut-Out for Outdoor Grill
Measurements
Overall Width
OBAD20 - 19 1/2” (495mm) OBAD36 - 35 7/8” (911mm)
Overall Height
21” (533mm)
Overall Depth
1/4” (6mm) deep return on frame edge
Cutout Width
OBAD20 - 16 3/4” (425mm) OBAD36 - 33 1/8” (841mm)
Cutout Height
18 3/4” (476mm)
Cutout Depth
3” (76mm) Minimum
Number of doors
OBAD20 - 1 OBAD36 - 2
Overall Height
Overall width
OBADXX ACCESSORY DOOR DIMENSIONS, FRONT VIEW (OBAD36 Shown)
Accessory Door Cutout Dimensions 6" x 6" (152mm x 152mm) utility cutout for OBSB162
6" x 7" (152mm x 178mm) utility cutout
12 1/4" (311mm) Coutertop 25" (635mm)
24" (610mm) 3/8" (10mm)ø Both sides OB(S)36 - 33 1/2" (851mm) OB(S)52 - 49 1/2" (1257mm)
8" (203mm) Min. to combustibles above the countertop surface, both sides
2" (51mm)
OBSB162 & OB/OBS/36/52 cUTOUT DIMENSIONS, TOP VIEW Specifications subject to change without notice. Install all appliances according to accompanying installation instructions.
1 1/2" (38mm)
All tolerances: +1/16”, -0, (+1.6mm, -0) unless otherwise stated
www.Dacor.com
Phone: (800) 793-0093
13.2
OB36, OB52, OBS36, OBS52, OBSB162 Document # PG13-001
Revised 05/06/10 Page 3/3
PLANNING GUIDE
36”, 52” Wide Outdoor Grills 16” Wide Side Burner
All tolerances: +1/16”, -0, (+1.6mm, -0) unless otherwise stated
10" (254mm) Min. to combustibles 1 1/4" (32mm) Min. to non-combustible 1 1/4" (32mm)
28 1/2" (724mm) To finished countertop
Junction Box
1/4" Rotisserie mounting bracket (factory installed) (6mm)
3/4" (19mm) min. to any material*
Trim frame (accessory)
23 3/4" (603mm) 24" (610mm)
OB36, obs36, ob52 AND obs52 cUTOUT DIMENSIONS, SIDE VIEW
10" (254mm) Min. to combustibles 2" (51mm) Min. to non-combustible Junction Box
1/4" (6mm)
3/4" (19mm) Min. to any material*
Trim frame (accessory)
23 3/4" (603mm) 24" (610mm)
OBSB162 cUTOUT DIMENSIONS SIDE VIEW
Specifications subject to change without notice. Install all appliances according to accompanying installation instructions.
www.Dacor.com
Phone: (800) 793-0093
13.3
