Transcript
Intrusion Alarm Systems | OD850 Series Outdoor TriTech Detectors
OD850 Series Outdoor TriTech Detectors www.boschsecurity.com
The OD850 Series TriTech detectors are for use outdoors and in other harsh environments. They use a combination of passive- infrared (PIR) and microwave detection with advanced signal processing. System overview The detectors process PIR signals with Motion Analyzer II signal processing and microwave signals with Linear Travel Distance (LTD) signal processing. The detectors can distinguish between small, repetitive motions such as tree limbs moving in the wind and the more purposeful motions of intruders. These advanced processing techniques and the detectors' mechanical design combine to provide superior performance in a wide range of weather conditions. Functions Motion Analyzer II Processing This PIR signal processor uses multiple thresholds and timing windows to analyze timing, amplitude, duration, and polarity of signals to make an alarm decision. Extreme levels of thermal and illumination disturbances caused by hot and cold drafts, sunlight, or lightning do not cause an alarm.
u
Motion Analyzer II PIR signal processing
u
Linear travel distance (LTD) microwave signal processing
u
Two sensitivity levels
u
Timed relay output adjustable from two sec to 10 min
u
AND/OR mode
LTD Microwave Signal Processing This microwave signal processor measures the linear travel distance of a target to make an alarm decision. It eliminates alarms for objects that move but do not travel, such as tree limbs and hanging signs. Two Sensitivity Levels The detectors have two user-selectable PIR sensitivity settings: Standard sensitivity is the recommended setting for a minimum of false alarms. The detector tolerates environment extremes on this setting. Intermediate sensitivity is the recommended setting for any location where an intruder is expected to cover only a small portion of the protected area. The detector tolerates normal environments on this setting. This setting identifies intruders more quickly, but may produce more false alarms. Adjustable Timed Relay Output In addition to an alarm relay, there is a Form C, unsupervised, timed relay contact that alternates state 1 sec after an alarm and follows a user-selectable timer. The time expires at the set time after the last alarm (it resets on each new alarm).
Available from A1 Security Cameras www.a1securitycameras.com email:
[email protected]
2 | OD850 Series Outdoor TriTech Detectors
AND/OR Mode This DIP-switch setting specifies whether the detector reports alarm situations in the AND mode (when both technologies simultaneously sense an alarm condition) or in the OR mode (when either the PIR or microwave technology senses an alarm state). OR mode provides faster detection in some conditions as the detector activates the alarm relay based on a single technology input. LEDs The high-efficiency LEDs (one red and one green) use the same technology as traffic lights to make them visible in sunlight. A DIP-switch setting allows the user to disable these LEDs during standard operation to save power. Draft and Insect Immunity The sealed optical chamber prevents drafts and insects from affecting the detector. Certifications and approvals
Installation/configuration notes
0m
15 m
25 ft
7.5 m
0 ft
0m
7.5 m 50 ft
25 ft 0 ft
Top View Standard Broad Coverage: 15 m x 15 m (50 ft x 50 ft)
Region
Certification
Europe
CE
OD850-F1, OD850-F2
CE
OD850-F1, OD850-F2
Belgium
INCERT
OD850-F1
Russia
GOST
DE.AE63.B03457 [OD850-F1]
USA
UL
OD850-F1
Side View Standard Broad Coverage: 15 m x 15 m (50 ft x 50 ft)
UL
UL 639 - Standard for Intrusion Detection Units
Mounting Considerations
FCC
OD850-F1
Australia
CTICK
OD850-F1
Canada
ULC
10 ft
0m
15 m 3m
0 ft
50 ft
0 ft
ULC
ULC-S306-03 - Canadian Standard for Intrusion Detection Units
China
CCC
2009031901000551 [OD850-F1-CHI]
Brazil
ANATEL
OD850-F1
Singapore
iDA
#LPREQ-S0155-2004 [OD850-F1]
0m
• Wall Mounting: The OD850 detectors can be mounted directly on a wall or on the supplied B335 Swivel Mount Bracket. Alternatively, they can be mounted directly on a standard rectangular electrical box. The detectors should be mounted 2.1 m to 2.7 m (7 ft to 9 ft) above the ground. The recommended height is 2.1 m (7 ft); leveled both horizontally and vertically. • Ceiling Mounting: The detectors can be mounted on a ceiling using the optional B338 Ceiling-Mount Bracket.
Power Considerations
• Power Limits: Input power must be provided by an Approved Limited Power Source. All outputs must be connected to SELV (safety extra-low voltage) circuits only. • Standby Power: This detector has no internal standby battery. For UL Listed product installations, 4 hr (248 mAh) of standby power must be supplied by the control unit or by a UL Listed burglary power supply.
Technical specifications Enclosure Design Dimensions:
16.5 cm x 8.25 cm x 6.35 cm (6.5 in. x 3.25 in. x 2.5 in.)
Material:
Polycarbonate
Available from A1 Security Cameras www.a1securitycameras.com email:
[email protected]
3 | OD850 Series Outdoor TriTech Detectors
Properties:
Weather and vandal resistant
Weight:
1.4 oz (40 g)
Environmental Considerations IP Rating:
54
Relative Humidity:
0% to 95% non-condensing
Temperature (Operating):
-35°C to +54°C (-31°F to +130°F)
OD850-F2:
Complies with Environmental Class III (EN50130-5)
Outputs Alarm:
Do not use with capacitive or inductive loads. Form A: Normally-closed contact opens on alarm. Form C: Timed relay contact alternates state on alarm and follows an installer programmable timer. Contact Rating: 3 W, 125 mA maximum, 25 VDC maximum for DC resistive loads; and protected by a 4.7 Ω, ½ W resistor in the common C leg of the relay.
Tamper:
Normally-closed (with cover on) contacts rated 125 mA maximum, 25 VDC maximum
Power Requirements Current:
62 mA maximum
Input Power:
10 VDC to 15 VDC at 22 mA standby.
Ordering information OD850‑F1 Outdoor TriTech Detector (10.525 GHz)
Provides PIR and mircowave, 15 m x 15 m (50 ft x 50 ft) coverage for use outdoors or in harsh environments with two sensitivity levels, draft and insect immunity. Operates at 10.525 GHz. For use in Belgium, Czech Republic, Denmark, Greece, Hungary, Italy, Netherlands, Norway, Poland, Romania, Spain, Sweden, Ukraine, the Americas and the Asia/Pacific Region. Order number OD850-F1 OD850‑F2 Outdoor TriTech Detector (10.588 GHz)
Provides PIR and mircowave, 15 m x 15 m (50 ft x 50 ft) coverage for use outdoors or in harsh environments with two sensitivity levels, draft and insect immunity. Operates at 10.588 GHz. For use in France and the United Kingdom. Order number OD850-F2 Accessories B338 Universal Ceiling‑mount Bracket
Swiveling universal bracket for ceiling mounting. The vertical swivel range is +7° to -16°, while the horizontal swivel range is ±45°. Order number B338
Available from A1 Security Cameras www.a1securitycameras.com email:
[email protected]
4 | OD850 Series Outdoor TriTech Detectors
Represented by: North America: Bosch Security Systems, Inc. 130 Perinton Parkway Fairport, New York, 14450, USA Phone: +1 800 289 0096 Fax: +1 585 223 9180
[email protected] www.boschsecurity.us
Europe, Middle East, Africa: Bosch Security Systems B.V. P.O. Box 80002 5617 BA Eindhoven, The Netherlands Phone: + 31 40 2577 284 Fax: +31 40 2577 330
[email protected] www.boschsecurity.com
Asia-Pacific: Robert Bosch (SEA) Pte Ltd, Security Systems 11 Bishan Street 21 Singapore 573943 Phone: +65 6571 2808 Fax: +65 6571 2699
[email protected] www.boschsecurity.asia
China: Latin America and Caribbean: Bosch (Shanghai) Security Systems Ltd. Robert Bosch Ltda Security Systems Division 203 Building, No. 333 Fuquan Road Via Anhanguera, Km 98 North IBP CEP 13065-900 Changning District, Shanghai Campinas, Sao Paulo, Brazil 200335 China Phone: +55 19 2103 2860 Phone +86 21 22181111 Fax: +55 19 2103 2862 Fax: +86 21 22182398
[email protected] www.boschsecurity.com.cn www.boschsecurity.com
© Bosch Security Systems 2016 | Data subject to change without notice 2626560139 | en, V16, 05. Jul 2016
Available from A1 Security Cameras www.a1securitycameras.com email:
[email protected]
