Transcript
L06/8106B 6.5
50W
Mid-bass
8
SPECIFICATIONS KEY FEATURES: 100 W continuous program power handling 90dB Sensitivity 1w/1m 63Hz ~ 8.0kHz frequency response range 25mm(1 in) copper voice coil Ideal for KTV application
General Specifications Nominal Diameter Rated Impedance Nominal Power handling 1 Program Power 2 Sensitivity(1w/1m) 3 Frequency Range 4 Minimum Impedance(Zmin) Voice Coil Diameter Voice Coil Material Voice Coil Winding Depth Number of layers Magnet gap depth Cone Shape Surround Material Basket Magnet Material/Mass
170/6.5 8 50 100 90 63- 8k 6.5 25/1 Copper 9 2 6 Curved Foam Pressed steel Ceramic/0.52
mm/inch ohm Watts Watts dB Hz ohm mm/inch
Fs Re Qms Qes Qts Cms
63.6 6.4 2.96 0.60 0.50 0.7
Hz ohm
Rms Mms Eff BL Vas Sd Xmax Le1K
1.22 9.0 0.65 6.2 15.6 0.0127 3.5 0.46
mech-ohm gr % T.m liters m2 mm mH
167 157.5 4.8 146 75 1.3
mm mm mm mm mm kg
mm mm
kg
Thiele - Small Parameters Resonance frequency DC resistance Mechanical factor Electrical factor Total factor Mechanical compliance Mechanical resistance of suspension losses Effective Moving Mass Half-space efficiency BL Factor Equivalent Cas air load Effective piston area Max. linear excursion 5 Voice - coil inductance
mm/N
Mounting Information
Frequency response curve of the loudspeaker taken in free-field(4pi) environment and mounted in a closed enclosure with an internal volume of 600 Litres enclosing the rear of driver, 1w/1m.
Overall Diameter Bolt Circle Diameter Bolt Hole Diameter Baffle Cutout Diameter Overall Depth Net Weight
NOTES:
Impedance magnitude curve measured in free air.
1. IEC60268-5 standard 2. Program Power is defined as 3 dB greater than the nominal power handling. 3. Sensitivity is measured at 1W input on rated impedance at 1m on axis and averaged between 100Hz and 1000Hz. 4. Frequency range is defined as the band of frequencies delineated by the lower and upper limits where the output level drops by 10dB below the rated sensitivity. 5. The maxinum linear excursion is calculated as: (Hvc-Hg)/2+Hg/4 where Hvc is the voice coil depth and Hg is the gap depth.
