Transcript
• Technical manual. The te • Step-by-step lifting instructions procedure • Maintenance of the OT200/ OT400; to -bemaintenance carried out by the car - repair procedures
OT200 Ceiling Hoist
- parts lists with order Next to this manual the following documentation is available onnu th • Installation manual. This • Technical manual. The technical manual is developed for the tec Preparations and Guidance - installation of rail and s - maintenance procedures Useof a gate (tr - installation - repair proceduresBefore and During - installation of carousel - parts lists with order numbers - part withthe order num • Installation manual. This manual can be usedlists during installa • Quick Reference. The Qu - installation of rail and supports the to OT200. - installation of a gate (transition from to fixed mobile rails) OT200 User Quick Guide - installation of carousel - part lists with order numbers of all components of the rail syst 1.2guide Symbols • Quick Reference. The Quick Reference deals with the mai Before use to the OT200. • Do NOT attempt to lift a higher load than the SWL (safe Attention • Check that status of the batteries on the cassette s display
peMed
QUICK GUIDE – OPEMED OT200 CEILING HOIST working load) of the hoist. See side of hoist (normally
• Is the emergency stop de-activated? (Red cord)
200kg).
1.2
Symbols
• Check whether the used sling fits the purpose and the transfer
Attention, High V Read the man
Attention • Only trained personnel should use the OT200 Ceiling Hoist • Check the condition of the sling and the clips and whether the whalebones are placed
• Read the User Manual before use. • Carefully place the sling
• Do NOT pull the hoist by the handcontrol.
With this, the OT GQ-quality mark The producer
Attention, High Voltage
• Is the user able and comfortable to be lifted?
• Do NOT wrap the handcontrol chord around the spreader bar and • The cassette will automatically activate when any button on the hand-held is pushed With this,control the OT200 meets the European Standard, IS lower the spreader bar, this will snap the chord.
1.3 GQ-quality mark T-02, cluster UTT.Contents of the Pa
using a standard sling, always place the arms of the user inside the sling on the user’s lap. • • When Always return the hoist to the Charging Station when not in use.
The delivered package mus
• When using a toilet sling alwaysloop make slings sure the arms the slings user are outside sling so is thatfitted). the • upper Only use approved (or of clip if thethe cradle • Cassette slips with clips pass beneath the arms!
• Hand-held control • Charger • Always work in a neat and clean environment HANDCONTROL The delivered package must contain: • Charging station Using the OT200 • Cassette • Spreader Bar Remove the packaging • Hand-held control • User manualfrom • Placehandcontrol the sling behind the of the userthe down to the up seat.and Let thedown user sit (also slightly forward during • The willback operate hoist • Charger • Quick reference this handling. Make sure the sling is placed with the washing instructions facing to the outside • Charging station left/right if you have a 4 function motor or tilting spreader if 1.3
Contents of the Package
• Pull the leg slips slightly forward; this way the user already sits ‘inside’ the sling
2.1
fitted). • • User Manual of Remove the packaging from the OT2004 and •check the contents • Lift one of the user’s legs and bring one leg slip of the sling to the inside of the leg. Use the same For horizontal the white and blue arrow match methodoto apply the other of legthe slipdrive Charging and Life-Span Batteries the white and blue arrow on the hoist. • If pull the head of theof sling to the correct height. The sling willcassette now fit around Innecessary, order to maximize the side life span theup batteries, it is advised to put the into thethe 4 • • • User Manual user like a ‘tank chair’ charging station when the cassette is not being used, but the unique Gravity Powered Charging
on the OT200 will maximise the battery life of the hoist. CHARGING • Whenthe using a toilet slingthe apply the circular (leg-side) Always charge battery when yellow batterybelt indicator is like a belt around the waist of the user. Put the arms of the user through loops on the head-side of the sling blinking. • Raise and Lower the by means of the hand-held control Charge • the batteries according to following procedure: Whenever notuser inthe use the Motor should - Make sure the charger is connected to the electricity supply. • Whilst moving,indicator walk withon the lift.charger Stay as Station. closelight to the as possible be stored at the Charging - The red/amber/green the will upuser depending on the state of the battery. • Approach the bed, chair or toilet and then determine the required height for bringing the user to the - Place the cassette below the charging strips (box on side of rail with final position two metal springs) • If the hoist needs charging the orange - After several seconds charging will start automatically and the yellow indicator on the cassette will light light illuminate Charging Station. when charging andwill go-out when fully when charged.the The hoist light onis theunder chargerthe will either show red/amber/green depending on the state of the batteries. Hoists Ceiling Hoists Changing Tables Showering Tables Shower Chairs Bathing - Allow for a charging time of 6-8 hours. OpeMed (Europe) Ltd www.opemed.net T: +44 (0)1252 758858 Clockhouse, Farnham 2.2 Capacity Guide: OT200QG E:
[email protected] www.opemed.net The GU9 number Surrey. 7UDof lifting cycles that can be done with a fully charged battery depends on the time per lifting cycle, the lifted weight and the age and condition of the battery. The OpeMed Gravity Powered Charging will maximise the lifecycle of the battery.
e:
Figure'1
7" 8"
9"
Figure 1 LIGHTS 1 OT200 Motor Cassette....... Page 15 10" 2 Rail System ...................... Page 10 11" 2 Description 3 X-Y System ...................... Page 10 • Permanent Orange LightThe='OT200' ceiling hoist system consists of a number of components that are discussed in this handboo 4 Gate System ..................... Page 10 In Figure 1 shows the main components. These are described in a separate section. Figure'2 Hoist is Charging 5 Turntable ......................... Page 10 6 Exchange Junction ............ Page 10 1" 2" 6" 5" 3" 4" • Flashing Organe Light = 7 Spreader Bar .................... Page 11 8 Slings............................... Page 12 return to Charge required, 9 Hand Control .................... Page 9
charge
Figure 2 • Green Light = Hoist is on, all functioning OK 10 Emergency Stop and Lowering 11 Control LED. GreenSpanner = Hoist in use. • Red Light = Service or maintenance required. Yellow Flashing = charging. OpeMed 01252 758858 /
[email protected] Yellow Constant = charging. Yellow Off = battery 100% charged. Red Spanner = Fault TROUBLESHOOTING 12 Connection point for handcontrol 13 Handcontrol security hook 13" 12" 14" 14 Powered cradle connection point
Please call
Figure'1
7"
Problem Solution 8" Hoist not working Return hoist to charging station, leave for 2 hours Figure 1 Ref1109 User Manual ••• 7 (no lights on control min. 1 OT200 Motor Cassette....... Page 15 10" 2 Rail System ...................... Page 10 panel) 3 X-Y System ...................... Page 10 4 Gate System ..................... Page 10 Ensure emergency chord hasn’t beenFigure'2 5 Turntable ......................... Page 10 Exchange Junction ............ Page 10 back in) pulled (if6 has push metal button 7 8 9
9"
11"
Spreader Bar .................... Page 11 Slings............................... Page 12 Hand Control .................... Page 9
Charging Light Flashing, Hoist slow to use
Return hoist Figure 2 to charging station, leave for 2 hours 10 Emergency Stop and Lowering min. 11 Control LED. Green = Hoist in use.
Handcontrol chord broken at plug
12 Handcontrol has been wrapped around spreader bar. 13 13" 12" Contact 14OpeMed to purchase a replacement.
Service Light (red spanner) is On but Hoist works OK
Contact OpeMed for a service (01252 758858). The OT200 should be serviced and LOLER inspected every 6 months as per LOLER & ISO10535.
Yellow Flashing = charging. Yellow Constant = charging. Yellow Off = battery 100% charged. Red Spanner = Fault Connection point for handcontrol Handcontrol security hook Powered cradle connection point
Ref1109
14"
User Manual
•••
