Transcript
PC100-IP
10 channel PDU, current/temperature sensor
Overview
Features
PC100-IP is a PDU (Power Distribution Unit) that provides up to ten mains outputs which can be individually switched. The PC100-IP also provides four 5V DC outputs of which two can be switched as a group, and eight 12V DC volt outputs of which four can be switched as a group. The PC100-IP consists of surge and filter protection for mains input and preprogrammed time delays on the mains outputs. The PC100-IP can be controlled by an internal web page, RS-232 or TCP-IP which also provide temperature and true total RMS current. An outlet socket is also provided to remotely perform a preprogrammed time delay power reset.
▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪
All mains outputs are individually switchable Mains surge and filter protection Low output voltage 5 volts and 12V DC Low voltage switchable outputs Internal Web server with multiple accounts Control through RS232 and Telnet DHCP or Static IP Remote power-up reset on 2-pin contact closure Preprogrammed time delay power reset Built-in power current sensor Remote temperature sensor
Model number/ordering code: PC100-IP
Specifications Input:
240V AC
Maximum current:
10 amp
Idle power:
5 watt
Circuit breaker:
Resettable 10A
Clamping:
275VAC (surge protection)
Protection modes:
A-N, A-E, N-E
Mains filter:
2 cascading circuits
Mains output:
Six GPO and four IEC
Low voltage connectors:
2-pin pluggable
Low voltage connectors:
Switched two 5V DC, four 12V DC, Non-switchable two 5V DC, four 12V DC
Low voltage connectors:
12V DC at 8 amp and 5V DC at 2 amp, Total 8.0 amp
Low voltage protection:
Individual 12 volts at 4 amp, individual 5V DC at 2 amp
Control:
Internal Web server, Telnet, RS232, TCP/IP
Users:
Four accounts including: Admin, User, User Outlet and Viewer
Preprogrammed power up:
Individually programmable up to 255 seconds
Remote power up reset:
3.5mm socket: contact closure
Current sensor:
Total current range 0-10 amp +/-5%
Temperature sensor:
Remote sensor using standard 3-wire PT100 probe, supplied, range 0 °c to 85 °c +/-0.5
Network:
10/100Mbps Ethernet socket, DHCP and Static IP support, TCP/UDP
Display:
13 LEDs, mains outlets 1-10, 2 low voltage and power on
Approval:
C-Tick
Enclosure:
1RU, steel powder coated, Inc. brackets for 19-inch rack mount
Dimension:
482mm (W) x 255mm (D) Inc. mounting bracket x 44 (H) mm
Weight:
3.5Kg
Copyright © 2014 M.E. Design (Aust) Pty Ltd All rights reserved Technical Specification subjected to change without notice
Proudly Design and Manufactured in Australia by M.E. Design (Aust) Pty Ltd For further information visit: medesign.com.au or email:
[email protected]
