Preview only show first 10 pages with watermark. For full document please download

Pac141 Installation Instructions

   EMBED

Share

Transcript

INSTALLATION INSTRUCTIONS LARGE FLAT SCREEN DUAL DISPLAY HEAD (PAC-141) The PAC-141 Dual Display Head assembly is compatible with the (PFB-Series) dual post floor stand. PARTS LIST Unpack the shipping carton and check for the contents listed in Table 1 and shown in Figure 1. Table 1. Parts List REF DESCRIPTION QTY 10 PAC-141 Dual Display Head Assembly 1 20 Socket Head Set Screw, 5/16-18 4 30 Hex Key, 5/32” 1 PARTS 20 30 10 Figure 1. Parts CHIEF MANUFACTURING INC. 1-800-582-6480 952-894-6280 FAX 952-894-6918 8401 EAGLE CREEK PARKWAY, STE. 700 SAVAGE, MINNESOTA 55378 USA 8800-000019 (Rev. B) ©2003 Chief Manufacturing www.chiefmfg.com 10/05 Installation Instructions PAC-141 10 TOOLS REQUIRED FOR INSTALLATION • 5/32” Hex wrench (provided) NOTE: Other tools may be required depending on your method of installation. INSTALLATION To install the PAC-141 on the mount, do the following: Assemble the PAC-141 20 20 Assemble the PAC-141, as follows: NOTE: Do not tighten the set screws at this time. 1. Using the 5/32” Hex wrench (30), insert one of the four 5/16-18 socket head set screws (20) into one of the four threaded holes in the screen bracket in back of the PAC-141 (10) as shown in Figure 2. 2. Repeat Step 1 to install the remaining three 5/16-18 socket head set screws (20) in the PAC-141 (10). NOTE: In order to clearly show the set screw (20) locations, Figure 2 shows only one faceplate. Figure 2. Assemble the PAC-141 Mount the PAC-141 Mount the PAC-141, as follows: WARNING: Exercise care when mounting the PAC-141 over the dual poles to avoid personal injury. 10 1. Place the PAC-141 (10) over the dual post on the mount as shown in Figure 3. 2. Adjust the PAC-141 to the desired height on the mount. 3. Tighten the four 5/16-18 socket head set screws (20). Dual Post on Mount Figure 3. Mount the PAC-141 2