Preview only show first 10 pages with watermark. For full document please download

Pairing M-dex With Cellphones, Iphone, Ipod And Ipad

   EMBED

Share

Transcript

QUICK GUIDE to PAIRING M-DEX WITH CELLPHONES; iPhone, iPod AND iPad M-Dex Pairing with Cellphones- General Steps: 1. 2. 3. 4. 5. 6. 7. 8. 9. 10. 11. 12. 13. Turn M-Dex on Press menu key Press right or left arrow key to get to SETTINGS Bluetooth Settings is highlighted (if it is not highlighted use the up/down arrow key to get to Bluetooth Settings) Press menu key Turn BT ON by pressing menu key (check mark indicates BT is on). Press right arrow key to go forward to PAIRING Press menu key to see BEGIN BLUETOOTH PAIRING (do not start pairing yet) On cell phone go to Bluetooth settings Add a device. On M-Dex press the center key again to BEGIN BLUETOOTH PAIRING. A check mark indicates that the pairing is initiated. On the cell phone you should see M-Dex- choose to pair/connect M-Dex will show the pin code If cell phone asks for a pin code, enter “0000”. Some phones will pair without pin code i-Phone/ i-Pod / i-Pad General Instructions: 1. 2. 3. 4. 5. 6. 7. 8. 9. Follow steps 1-7 above. On Phone go to Settings Go to General Bluetooth-Turn On On M-Dex- Press the center key to BEGIN BLUETOOTH PAIRING On phone you should see M-Dex and Not Paired Press ‘Not Paired’ It will search and match. iPhone will then say M-Dex- connected. i-Phone/ i-Pad proximity based pairing Instructions: For proximity based pairing, you have to reset BT on M-Dex. This deletes all pairing of MDex to other devices. Make sure that M-Dex is either not paired to any other BT device or if it is paired, note that you will lose pairing of that device and will have to re-establish the pairing. Steps for proximity based pairing of M-Dex with iPhone/iPad: 1. Choose “SETTINGS\RESET BLUETOOTH\RESET BLUETOOTH PAIRING” on M-DEX 2. Ensure that Bluetooth is turned on at both M-DEX (SETTINGS\BLUETOOTH SETTINGS\BT ON) and the cell phone (Refer to the cell phone’s instruction guide on how to do this) 3. Turn M-DEX off 4. Place M-DEX as close as possible (side-by-side) to the cell phone 5. Ensure that the cell phone’s Bluetooth signal is made “visible” to other Bluetooth devices 6. Turn M-DEX on 7. Within 1 minute M-DEX will send a pairing-request to the cell phone 8. Accept the pairing-request on the cell phone: “MDEX would like to pair with your iPhone: Cancel or Pair,” click on Pair.