Transcript
Part 1273 Bluetooth Adaptor This Bluetooth adaptor has been designed to be used in Aux 1 on the Easi-PLUS, Active-PLUS and the Super-Pro AVi. Aux 1 socket on these units have the power output enabled so the Bluetooth adaptor is powered via the Autocom system itself.
1.5m lead
It is recommended that the Autocom Bluetooth Adaptor is placed in line of sight of the device to be paired. ie. under your seat or to the front of the bike with as little body mass obstructing the two paired devices. For GPS units the 1.5m lead length should be sufficient for the adaptor to be positioned at the front of the bike, routed under the tank. Try to route the cable away from HT leads and coils, as these can lead to interference noises.
1273 The set-up button and L.E.D. are positioned behind the grommets. Once set-up is complete, replace grommets in holes A and B.
3.5mm 4 pole Must be plugged directly in to Aux 1 socket with no splitter boxes
How to Connect the Bluetooth Adaptor G Firstly, the Autocom Bluetooth adaptor must be plugged in to the Aux 1 socket of your Easi-PLUS, Active-PLUS or Super Pro AVi as this socket powers the Autocom Bluetooth Adaptor. Once you have plugged the 3.5mm 4 pole plug into the Aux 1 socket, you must wait about 10 seconds for the Autocom Bluetooth Adaptor to boot up. G To pair your mobile phone or GPS unit to the adaptor you must press the button positioned in the adaptor for around 6 seconds until the light goes out. You must then press the button in for a second time for around 6 seconds until the light flashes rapidly. G Once this sequence has been completed the Autocom Bluetooth adaptor will be ready to pair to your mobile phone or GPS device. You may have to refer to the manufacturers instructions on how to pair your phone or GPS the the Autocom Bluetooth Adaptor. G The Autocom Bluetooth Adaptor will appear in your Bluetooth directory as “Autocom Dongle”. G The Autocom Bluetooth Adaptor will auto power-up and auto connect on restart providing the device you want to connect to it is Bluetooth enabled. G Once the Autocom Bluetooth Adaptor is paired to your phone, it will auto answer and auto connect to any mobile phone or GPS that has Bluetooth device with headset or a handsfree profile. G The pass key to pair your phone or GPS to the Autocom Bluetooth Adaptor is 0000.
G Some old firmware on your mobile phone, GPS or PDA will not connect to the Autocom Bluetooth Adaptor. You may have to upgrade the software on your own phone, GPS or PDA.
G The Autocom Bluetooth Adaptor has an auto answer function built-in, ensure you mobile phone feature for “auto answer” is set to “off” in both headset and handsfree options. G The Tom Tom Rider must be reset to factory defaults, make sure the Tom Tom rider is set to “show all menus”, then go to “change preferences” and on screen 7 of 7 “reset factory settings”.
If your Autocom system is a pre 2007 model and does not have a sticker on the unit (shown right), you will have to have the Aux 1 socket power enabled. To do this you must link the power up connection on the circuit board. If you are not confident of doing this yourself, it would be advisable to contact your dealer or Autocom direct.
ONLY USE 4 POLE PLUGS IN AUX 1
