Partner Acs R7 Model 90a Attenuator Installation Instructions

Transcript

CIB 3242 Comcode 700262512 Issue 2 May 2003 Model 90A Attenuator Comcode 107864456 Installation Instructions Copyright 2003, Avaya Inc. All rights reserved. All trademarks identified by the  and  are registered trademarks or trademarks respectively. All other trademarks are properties of their respective owners. The above information is based on knowledge available at the time of publication and is subject to change without notice. Important Safety Instructions Always follow these basic safety precautions when installing the Model 90A Attenuator: 1. Read and understand all instructions. 2. Never touch uninsulated telephone wires or terminals, unless the telephone line has been disconnected at the network interface. Printed in the U.S.A. For the most current versions of product documentation, go to the Avaya Web site: http://www.avaya.com/support/ 3. Use caution when installing this product on telephone lines. CIB 3242 Issue 2 Comcode 700262512 May 2003 5. Never install this product in a wet location. 4. DO NOT install this product on telephone wiring during a lightning storm. Save these instructions Installation Parts Enclosed 1. Refer to the diagram below for placement instructions. Be sure to use the 2-foot 4 conductor (D4BU) modular cord supplied with the Attenuator (Comcode 107864456). Modular jacks 2. Connect one end of the 2-foot D4BU cord to a modular jack on the Attenuator. Connect the other end of the cord to a station jack on the control unit. 3. Connect the modular cord from the modem to the other modular jack on the Attenuator. 2-foot modular cord Telephone cord 2-foot 4 conductor (D4BU) modular cord CO Line 90A Modem Control Unit 2 3 Attenuator Installation Parts Enclosed 1. Refer to the diagram below for placement instructions. Be sure to use the 2-foot 4 conductor (D4BU) modular cord supplied with the Attenuator (Comcode 107864456). Modular jacks 2. Connect one end of the 2-foot D4BU cord to a modular jack on the Attenuator. Connect the other end of the cord to a station jack on the control unit. 3. Connect the modular cord from the modem to the other modular jack on the Attenuator. 2-foot modular cord Telephone cord 2-foot 4 conductor (D4BU) modular cord CO Line 90A Modem Control Unit 2 3 Attenuator CIB 3242 Comcode 700262512 Issue 2 May 2003 Model 90A Attenuator Comcode 107864456 Installation Instructions Copyright 2003, Avaya Inc. All rights reserved. All trademarks identified by the  and  are registered trademarks or trademarks respectively. All other trademarks are properties of their respective owners. The above information is based on knowledge available at the time of publication and is subject to change without notice. Important Safety Instructions Always follow these basic safety precautions when installing the Model 90A Attenuator: 1. Read and understand all instructions. 2. Never touch uninsulated telephone wires or terminals, unless the telephone line has been disconnected at the network interface. Printed in the U.S.A. For the most current versions of product documentation, go to the Avaya Web site: http://www.avaya.com/support/ 3. Use caution when installing this product on telephone lines. CIB 3242 Issue 2 Comcode 700262512 May 2003 5. Never install this product in a wet location. 4. DO NOT install this product on telephone wiring during a lightning storm. Save these instructions