Preview only show first 10 pages with watermark. For full document please download

Pass Push Bumper System Installation Instructions 2006 + Newer Chevy Impala

   EMBED

Share

Transcript

Rev. 12/09 PASS® Push Bumper System Installation Instructions 2006 + Newer Chevy Impala 1: Remove the front bumper fascia from the vehicle to reveal the inner bumper. 2: Locate the two semi circle indentations in the black plastic on the front of the inner bumper. The clamp bracket (A) will slide in between the black plastic and the inner bumper at this location. Position the bracket so that it fits around the notch on the bottom of the black plastic. Bracket C Fully assembled mounting bracket: Drivers side Bracket E Bracket F Bracket A Bracket B Bracket D 3: Install bracket B behind the steel bumper and attach to bracket A using 3/8” hardware provided. 4: After Brackets A & B are mounted to both sides of the vehicle, brackets C & D can then be mounted to them on both sides of the vehicle using 3/8” bolts, washers and nuts. 5: Loosely install brackets E & F to test fit the push bumper. Once certain the PASS bumper fits correctly, remove brackets E & F and tighten all remaining hardware. 6: Carefully test fit the fascia to the front of the vehicle. After the fascia is reinstalled, the upper mounting brackets (C) should extend through the bottom slot of the upper portion of the grill. The lower mounting brackets (D) should extend through the third from the bottom slot of the lower portion of the grill. If these brackets do not line up correctly, loosen the bolts and adjust the brackets so they fit correctly before securely fastening the fascia. Bracket C Bracket D 7: After the fascia is reinstalled to the front of the vehicle and secured, with the brackets extending through the proper openings in the grill, the PASS mounting brackets (E & F) can be attached on both sides of the vehicle to brackets C & D with supplied 3/8” bolts and flange nuts. 8: After brackets E & F are loosely attached on both sides of the vehicle, the PASS push bumper can be mounted onto the mounting brackets with 3/8” hardware provided to the holes in the rear of the bumper on the top & the holes on the sides of the bumper on the bottom. Once all of the bolts have been started, level the bumper assembly and then tighten all hardware completely. SPECIALISTS IN EMERGENCY VEHICLE PRODUCTS SINCE 1978 • DESIGN, MANUFACTURING, DISTRIBUTION AND INSTALLATION