Transcript
02/20/2006/10:30
PD2-AO-96/16
96-Channel PCI Card for Analog Output Data Acquisition
...................................................................................................................................................................
• 96 analog outputs (16-bit resolution) • 8 digital inputs; 8 digital outputs • Three 24-bit counters/timers; three clock/interrupt lines • User-defined power-on state • Simultaneous channel update; update on external event • 2k samples onboard buffer size (upgradable to 64K samples) Supports UEIDaq Framework Data Acquisition Software Library for Windows. Linux and QNX drivers available. Visit our website for more details.
General Description:
Analog outputs are no afterthought at UEI! In fact, we offer some of the highest-density cards in the industry. For instance, our PD2-AO-96/16 packs 96 analog outputs, each at 16-bit resolution. Even though the maximum per-channel update rate across all channels is 100k samples/sec, you can drive 32 of the outputs at an aggregate update rate of 1.5M samples/sec. In addition to that, it’s possible to update multiple channels simultaneously and use multiple boards in one system. The card calibrates each analog output individually without using trimpots. Instead relies on a special D/A-based scheme that stores calibration coefficients in EEPROM and loads them automatically upon power up. This method also keeps board outputs in a predefined user-programmable state upon system startup. The PD2-AO-96/16 is pin-compatiable with 16-channel analog-output cards from Keithley and Measurement Computing (formerly ComputerBoards).
Technical Specifications: Analog Outputs Number of channels Resolution Update rate
DSP buffer size Type of D/A Data transfer modes Accuracy DNL Monotonicity over temp. Calibrated gain error Calibrated offset error Ranges Output coupling Output impedance Current drive Capacitive loads Settling time Slew rate Gain bandwidth Noise Output protection Power-on state Gain drift
Digital I/O Number of channels Compatibility Power-on state
96 16 bits 100 kS/s per channel; 450kS/s aggregate in non-DMA mode; up to 1100 kS/s aggregate in DMA mode 2k samples (2 buffers x 1k sample) double-buffered DMA, interrupt, software ±3 LSB max ±3 LSB max 15 bits, -40 to 85°C 3mV typ, 6mV max @ ±9.8V 1mV typ, 2mV max @ 0.0V ±10V DC 0.15Ω max ±5 mA min 180 pF min 10µs to 0.003% 10V/µs 1 MHz less than 2 LSB RMS, 0-10000 Hz short to ground, ±15V 0.0000V ±5mV (default), user programmable 25 ppm/°C
8 inputs, 8 outputs CMOS/TTL, 2kV ESD protected logic zero (default), user programmable DMA, interrupt, software 4.7kΩ pull-up to 5V 3.0V typ @ -32mA, 3.4V typ @ -16mA, 4.2V @ -2mA 0.55V max @ 64mA 0.0 - 0.8V 2.0 - 5.0V
Data transfer modes Input termination Output high level Output low level Input low voltage Input high voltage Counter/Timer Number of channels Resolution Max frequency
3 24 bits 16.5 MS/s for external clock, 33 MS/s for internal DSP clock 0.00002 Hz for internal clock, no low limit for external clock 20 ns 2.9V typ @ -4 mA 0.5V min @ 4 mA 7 kV ESD, ±30V over/undershoot 0.0 - 0.8V 2.0 - 5.0V
Min frequency Min pulse width Output high level Output low level Protection Input low voltage Input high voltage
Connection Schemes: Connector On The Board J3 - J8 J3 - J8 J2 J3 - J8 J3 - J8 J2
Cable Required PD-CBL-40 PD-CBL-4037 PD-CBL-37 PD-CBL-4037-INV PD-CBL-4037-INV PD-CBL-3650-8/8
Target Panel PD-STP-40 PD-STP-3716 PD-STP-3716 PD-AO-AMP-100 PD-AO-AMP-115 PD2-DIO-BPLANE16
Description Carries 16 analog output lines to 16-channel terminal panel Carries 16 analog output lines to 16-channel terminal panel* Carries 8 digital input and 8 output lines to 16-channel terminal panel Carries 16 analog output lines to ±100V amplifier Carries 16 analog output lines to ±115V amplifier Carries digital lines to digital isolation panel for adding relays to the DIO lines
* Legacy connection scheme. Use PD-CBL-40 / PD-STP-40 combination instead. United Electronic Industries, Inc. Tel: (781) 821-2890
1
http://www.ueidaq.com Fax: (781) 821-2891
PD2-AO-96/16 - 96-Channel PCI Card for Analog Output Data Acquisition
Block Diagram:
TRIGGER IN CLOCK IN GATE IN
...
AOUT14
Control & Timing Logic
DAC14
AOUT15
DAC15
DAC80
AOUT81
3
Digital Input Buffer Latch
8
Interrupt
DAC81
Control
AOUT80
Counter/ Timers DIn Control
... Address
DOut Control
Digital Output (Driver)
Local Data Bus
8
... AOUT94
DAC94
AOUT95
Voltage Reference
Analog Output Calibration DACs
Configuration & Calibration EEPROM
Motorola 66MHz DSP 56301
DAC95
J4
J2
J6
J3
J8
J5
J7
Addr/Data
J8
AOut Control
DAC1
...
AO Connector
J2
DAC0
AOUT1
36-pin Digital I/O Connector
AOUT0
Control
AO Connector
J3
CLOCK OUT
32-bit PCI Bus
Pinout Diagrams: J2 — IDC-36 (male) 36-pin header: DGND TMR0 DGND DGND TMR1 DIN0 DIN1 DIN2 DIN3 DIN4 DIN5 DIN6 DIN7 GATE IN CLOCK IN TRIGGER IN DGND DGND
1 3 5 7 9 11 13 15 17 19 21 23 25 27 29 31 33 35
2 4 6 8 10 12 14 16 18 20 22 24 26 28 30 32 34 36
J3 — IDC-40 (male) 40-pin connector:
DGND TMR2 DGND DGND +5V 200mA max DGND DOUT0 DOUT1 DOUT2 DOUT3 DOUT4 DOUT5 DOUT6 DOUT7 DGND DGND DGND DGND
CLOCK IN TRIGGER IN DGND AOUT0 AOUT1 AOUT2 AOUT3 AOUT4 AOUT5 AOUT6 AOUT7 AOUT8 AOUT9 AOUT10 AOUT11 AOUT12 AOUT13 AOUT14 AOUT15
1 3 5 7 9 11 13 15 17 19 21 23 25 27 29 31 33 35 37
2 4 6 8 10 12 14 16 18 20 22 24 26 28 30 32 34 36 38
CLOCK OUT GATE IN AGND AGND AGND AGND AGND AGND AGND AGND AGND AGND AGND AGND AGND AGND AGND AGND AGND
J4 — IDC-40 (male) 40-pin connector: NC NC DGND AOUT16 AOUT17 AOUT18 AOUT19 AOUT20 AOUT21 AOUT22 AOUT23 AOUT24 AOUT25 AOUT26 AOUT27 AOUT28 AOUT29 AOUT30 AOUT31
1 3 5 7 9 11 13 15 17 19 21 23 25 27 29 31 33 35 37
2 4 6 8 10 12 14 16 18 20 22 24 26 28 30 32 34 36 38
NC NC AGND AGND AGND AGND AGND AGND AGND AGND AGND AGND AGND AGND AGND AGND AGND AGND AGND
J5 — IDC-40 (male) 40-pin connector: NC NC DGND AOUT32 AOUT33 AOUT34 AOUT35 AOUT36 AOUT37 AOUT38 AOUT39 AOUT40 AOUT41 AOUT42 AOUT43 AOUT44 AOUT45 AOUT46 AOUT47
1 3 5 7 9 11 13 15 17 19 21 23 25 27 29 31 33 35 37
2 4 6 8 10 12 14 16 18 20 22 24 26 28 30 32 34 36 38
J2- Digital I/O signals
NC NC AGND AGND AGND AGND AGND AGND AGND AGND AGND AGND AGND AGND AGND AGND AGND AGND AGND
J6 — IDC-40 (male) 40-pin connector: NC NC DGND AOUT48 AOUT49 AOUT50 AOUT51 AOUT52 AOUT53 AOUT54 AOUT55 AOUT56 AOUT57 AOUT58 AOUT59 AOUT60 AOUT61 AOUT62 AOUT63
1 3 5 7 9 11 13 15 17 19 21 23 25 27 29 31 33 35 37
2 4 6 8 10 12 14 16 18 20 22 24 26 28 30 32 34 36 38
NC NC AGND AGND AGND AGND AGND AGND AGND AGND AGND AGND AGND AGND AGND AGND AGND AGND AGND
J7 — IDC-40 (male) 40-pin connector: NC NC DGND AOUT64 AOUT65 AOUT66 AOUT67 AOUT68 AOUT69 AOUT70 AOUT71 AOUT72 AOUT73 AOUT74 AOUT75 AOUT76 AOUT77 AOUT78 AOUT79
1 3 5 7 9 11 13 15 17 19 21 23 25 27 29 31 33 35 37
2 4 6 8 10 12 14 16 18 20 22 24 26 28 30 32 34 36 38
J8 — IDC-40 (male) 40-pin connector:
NC NC AGND AGND AGND AGND AGND AGND AGND AGND AGND AGND AGND AGND AGND AGND AGND AGND AGND
NC NC DGND AOUT80 AOUT81 AOUT82 AOUT83 AOUT84 AOUT85 AOUT86 AOUT87 AOUT88 AOUT89 AOUT90 AOUT91 AOUT92 AOUT93 AOUT94 AOUT95
1 3 5 7 9 11 13 15 17 19 21 23 25 27 29 31 33 35 37
2 4 6 8 10 12 14 16 18 20 22 24 26 28 30 32 34 36 38
NC NC AGND AGND AGND AGND AGND AGND AGND AGND AGND AGND AGND AGND AGND AGND AGND AGND AGND
J3-J8 - Analog output signals
Pin-to-Pin Mapping Diagrams: Depending on the cable used to connect the board to different terminal panels, pins of J2, J3-J8 connectors may be remapped. Please refer to the diagrams below for detailed information about pin-to-pin mapping for PD-CBL-4037, PD-CBL-4037-INV and PD-CBL-37 cables. Pin
Pin
United Electronic Industries, Inc. Tel: (781) 821-2890
2
1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36
PD-CBL-37 > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > >
Pin 1 20 2 21 3 22 4 23 5 24 6 25 7 26 8 27 9 28 10 29 11 30 12 31 13 32 14 33 15 34 16 35 17 36 18 37 19
Panel-Mating Side
PD-CBL-4037-INV
Pin
37-pin D-Sub Connector (female)
Pin
36-pin IDC Header (female)
PD-CBL-4037
Board-Mating Side
Pin
http://www.ueidaq.com Fax: (781) 821-2891
