Transcript
Teleconnect POE-UTP4- KIT Easy UTPTM Long Range Ethernet Extender The Easy UTP
TM
Series Kits of Ethernet over Cat5e/6/2Wire
Extender is a new generation device that makes installation of powered devices such as IP cameras and other IP devices an easy task with no IP address and network set up required for the installation. Configuration can either be 1:1 or any combination up 1:4 with range to 600 metres depending on power demand, type of UTP cable used and environment. With proprietary technology providing robust immunity against noise and interference and fullduplex Fast Ethernet transmission over UTP cable up to 4 Mega Pixel IP cameras can be supported.
Features Use of existing UTP or new cables for installation IP camera and IP devices such and VOIP phones. One Master Extender can support up to four slave extenders Extremely cost effective to install Range to 600 metres (Note) Full Duplex 10/100 Mbps Data Speed IEEE 802.3 af/at Compliant PoE for IP camera power supply Easy Configuration, No IP address and network setup required LED indicator for Power, Link and Data traffic status Compact size extender - fits inside most camera housings 2 Year Warranty
Application Slaves
Network Switch
HDVR/NVR
Master Splitter
Cat 5e/6 Data & Power 48 VDC Power Injector
PoE IP Cameras
Teleconnect Specifications for POE-UTP4-KIT Electrical Specifications Standard IEEE 802.3af/802.at Mid Span Data Speed 10/100 Mbps Full Duplex UTP Cable Cat 5e/6/2Wire Transmission Method CSMA/CA and TDMA Modulation Method Windowed OFDM Frequency Band 1.8 MHz to 30 MHz PoE Voltage 48 VDC Input 37-48VDC Output Distance/Power Dependent LED Indicators Power On Blue, RJ45 Link On Green, RJ45 Link On Green Interface Ethernet 2 x RJ45 Mechanical and Environment Specifications Power Requirement Dimension Weight Operating Temperature Operating Humidity Enclosure Material Certification
100-240VAC 50-60Hz to 48VDC 1.3A ( Optional) 75 (L) x 40 (W) x 40 (H) mm 120g o -10 ~ 50 C 10 ~ 80% (non-condensing) Extruded Aluminum CE, FCC, C-Tick
Typical Transmission Distance with PoE Total Power of PDs (Watts) 4.5 6 8 10 15 20 25 30 35
Metres (1 Pair) 60W PSE 311 253 202 168 119 92 75 63 53
Metres (4 Pair) 60 W PSE 600 505 404 337 238 184 150 126 109
Metres (1 Pair) 40W PSE 311 253 202 168 119 92 75 x x
Metres (4 Pair) 40 W PSE
600 505 404 337 238 184 150
x x
Metres (1 Pair) 30W PSE 311 253 202 168 119 92
x x x
Metres (4 Pair) 30 W PSE
600 505 404 337 238 184 x x x
Note: Actual Distance depends on type of UTP cable, power source and termination method used and site specific noise environment encountered. Local power can be used for higher power devices to extend range. Specifications subject to change without notice. ORDER INFORMATION
POE-UTP1-KIT POE-UTP2-KIT POE-UTP3-KIT POE-UTP4-KIT POE-UTP4 POE-PWR-60W
1 Master, 1 Slave (includes 1 x Power Supply) 1 Master, 2 Slave (includes 1 x Power Supply) 1 Splitter 1 Master, 3 Slave (includes 1 x Power Supply) 1 Splitter 1 Master, 4 Slave (includes 1 x Power Supply) 1 Splitter Additional UTP4 Unit 60 Watt 48DC Injector
Version 2.2-100812
EQL Teleconnect Unit 20, 13 Swaffham Road Minto NSW 2566 Australia Tel: Web:
+61 2 9824 5680 Fax: +61 2 9824 5685 Email: sales@ teleconnect.com.au www. teleconnect.com.au ABN: 93 098 402 218
