Preview only show first 10 pages with watermark. For full document please download

Ph-bkt Adjustable Wall/ceiling Mounting Bracket Installation Instructions

   EMBED

Share

Transcript

Installation Instruction Sheet PH-BKT Adjustable Wall/Ceiling Mounting Bracket For use with DSC Series heaters. Contact the factory for instructions for use on the PH Series Patio Heater. Parts List Figure 1 • Basic Assembly • A - (2) Wall Brackets • B - (2) Connecting Arms • C - (10) Bolts, Nuts & Lock Washers Wall Bracket Lock Washer Bolt Nut Connecting Arm A C B Brackets affixed to heater Assemble the mounting hardware as shown in Figure 1. Various mounting configurations can be achieved using the preset mounting bracket. This hardware allows the heater to be installed at an angle between 0° and 30°. This angle must not exceed 30° from horizontal or damage to the eggcrate can occur. All clearances to combustibles must be maintained at all times (see Chart 1.1 on reverse). Figure 2 • Typical Configurations Mounting bracket attached to ceiling. Mounting bracket attached to wall. 30° 30° Max. Mounting Angle 30° 0° Mounting Angle 30° Max. Mounting Angle * Gas and electrical lines must not be located above the path of exhaust. 0° Mounting Angle LSH143-1/14 (DRP) Chart 1.1 • Clearance to Combustibles in Inches (millimeters) Mounting Angle* Sides Back Top Below End(s) Front 0° 18 (458) N/A 13 (331) 48 (1220) 12 (305) N/A 30° N/A 18 (458) 18 (458) 40 (1016) 12 (305) 36 (915) The DSC Series heater must be installed 8 feet above the finished floor. * Heaters mounted on an angle between 1° to 30° must maintain clearances posted for 0° or 30°; whichever is greater. Figure 3 • Side View Figure 4 • End View Top (to ceiling) End End SIDE VIEW Side Top (to ceiling) Side Front Back 30˚ Below Below END VIEW: 0° Mounting Angle END VIEW: 30° Max. Mounting Angle Figure 5 • Mounting Bracket Extension Dimensions The heater’s mounting brackets are adjustable in 1 in. (25.4 mm) intervals when installed with the connecting arms. All clearance to combustibles must be maintained. Refer to the minimum and maximum mounting bracket extensions shown below. 1 Minimum mounting bracket extension to non-combustibles only is 9 in (228.6mm). 2 Minimum 0° mounting bracket extension is 14.8 in (375.9mm). 3 Minimum angle mounting bracket extension (up to 30° max.) is 17.5 in (444.5mm). 4 Maximum mounting bracket extension is 20.5 in (520.7mm). 1 2 3 4 9” 14.8” 17.5” 20.5” No connecting arm