π H-4616, H-4617 Drop Over Cable Protector

Transcript

π H-4616, h-4617 DROP OVER CABLE PROTECTOR 1-800-295-5510 uline.com INSTRUCTIONS Channel Capacity components channel capacity - max. diameter inches Side View 36" Lineal Drop Over Protector NOTE: Drop over protectors do not prevent abrasion to cable from below. assembly Interlock with T-connectors to extend protection length. (See Figure 1) Figure 1 H-4616 1.25" width x 1.25" height H-4617 2.25" width x 2.25" height Load capacity The Drop Over Cable Protector has different load supporting capabilities depending on type of vehicle and temperature. Suitability must be verified by testing under actual conditions. Load-supporting capacity varies by type of loading conditions and environmental conditions. The load capacity decreases in warm environments. Test before use and inspect periodically. model no. load capacity per tire load capacity per axle max load 70°F (21°C) max load 70°F (21°C) H-4616 11,700 lbs. 23,400 lbs. H-4617 8,500 lbs. 17,000 lbs. operating temperature -40° to 120°F (-40° to 48°C) Chemical Resistance • Inspect areas for safety hazards. • Assemble sections by aligning female connectors over male connectors and press with foot to secure. Tested for compatibility with common motor oils, gasoline and diesel fuel. Limited resistance to brake fluids and other chemicals. Material UV-stabilized polyurethane elastomer. • Install cable as required. Place the protector over the top of exposed cable/hose. • Test installation for intended use. • Periodically inspect installation. PAGE 1 OF 2 0214 IH-4616 INSTRUCTIONS continued Maintenance CAUTION: Misuse can cause electrical shock and injury. • Store in a clean dry area. • DO NOT use as work surface. NO CUTTING, NO DRILLING, NO HAMMERING. • Inspect protector for damage and replace it if damaged. • Use with momentary loads only. DO NOT place ladders, scaffolds or any type of structure on the protector. • Remove any foreign materials, solids and liquids. • Keep clean by using a detergent and water solution. • Avoid concentrated loads. • Use only on a stable surface. Inclined surfaces, slippery surfaces and broken ground can cause injury. • This protector can be a trip hazard to pedestrian traffic if they are unaware of its presence. • Keep the Drop Over Cable Protector clean and bright. • Keep various services, communications, fluids and power separated. Limit a protector to one service type. • Polyurethane is attacked by some chemicals. Always test a small amount for chemical compatibility before using and follow maintenance procedure. • Vehicular traffic must pass over the protector slowly and with caution. π CHICAGO • ATLANTA • DALLAS • LOS ANGELES • MINNEAPOLIS • NYC/PHILA • SEATTLE • MEXICO • CANADA 1-800-295-5510 PAGE 2 OF 2 uline.com 0214 IH-4616