Transcript
PiCom intercom unit
C O D R I V E R
RO
A D/S TAG E
/A MAIN UX
D R I V E R
Introduction The PiCom Intercom meets the demanding needs of the World Rally Championship, which makes it highly suitable for all other rallying classes, as well as other forms of motorsport. The PiCom functions are fully configurable via a simple PC interface. The unit has two normal modes of operation: Stage mode and Road mode. In Stage mode the radio and phone inputs are muted so as not to disturb the driver and co-driver. The microphone and headphone levels can be adjusted in Stage mode to any combination which gives the best performance for the driver and co-driver. The unit also has a CAN interface, which can be used for tone based alarms and warnings, instead of the customary dash board warnings. In Road mode the phone and radio are active; the unit also comes with an additional (AUX) input which can be used for connection of CD, MP3 or external radio devices. The intercom has a secondary mode: AUX (or Backup) mode, which can be used in the event of the main intercom failing.
Product Information 29A-071486-1E
1
Specifications Description
Value
Electret Type Microphone
500mV RMS Max into 10Kohms Phantom supply 2.5V @ 2mA
Dynamic Type Microphone
15mV RMS Max into 10Kohms
Headset Speaker Output
7.5V RMS Max into 120ohms (0.5W) 0.15% THD Maximum output 1W Mini. impedance 8ohms, recommended min. 32ohms Outputs short circuit, open circuit, thermal overload protected. Bandwidth 350Hz – 3KHz @ -3dB
Radio Input
8V RMS Max (speaker mode selected via PCsetup) 800mV RMS Max (Line mode selected via PC setup) Input impedance 10Kohms Bandwidth 350Hz – 3KHz @ -3dB
GSM/Phone Input
3V RMS Max (speaker mode selected via PC setup) 300mV RMS Max (Line mode selected via PC setup) Input impedance 10Kohms Bandwidth 350Hz – 3KHz @ -3dB
Auxiliary Input (CD/MD/MP3) 1V RMS Max Stereo input (internally summed to mono) Input impedance >1Mohms Bandwidth 20Hz – 20KHz @-3dB Radio Output
2V RMS Max (Line mode selected via PC setup) 180mV RMS Max (Mic mode selected via PC setup) Output Impedance 20Kohms
GSM/Phone Output
5V RMS Max (Line mode selected via PC setup) 600mV RMS Max (Mic mode selected via PC setup) Output Impedance 20Kohms (Nokia ‘Car mode’ link out) Output Impedance 4Kohms (Nokia ‘Car mode’ link fitted)
TV Camera/Record Output
2V RMS Max Output Impedance 20Kohms
CTCSS Output (TV feed)
50mV RMS Max 60Hz – 253Hz
SELCALL Output (TV feed)
50mV RMS Max 208Hz – 3KHz
Warning Beep (CAN)
500mV RMS Max @ Headset full volume Frequency 400Hz (approx) – 2KHz (approx) selected via CAN
General information
Overall bandwidth (excluding AUX input) 350Hz – 3KHz Overall Total Harmonic Distortion (THD) less than 0.25% (Non Clipping)
Programming Port Settings
PC mode 38400, 8bit, No Parity, 1 Stop bit, No hand shake CAN mode 1Mb/s, 120R termination, PC selectable
2
Product Information 29A-071486-1E
Dimensions
120.00 (4.72)
67.00 (2.63)
C O D R I V E R
RO
A D/S TAG E
/A MAIN UX
Co-driver head set ASL2 06-05 SN HE
PC communications ASL2 06-05 PN HE Driver head set ASL2 06-05 SN HE
13.00 (0.50)
36.00 (1.42)
Pi Intercom AS2 10-35 SN
52.15 (2.05)
D R I V E R
19.50 (0.76) 44.00 (1.73) 72.00 (2.83) 100.50 (3.95)
Dimensions in millimetres and (inches)
Mounting information
140.00 (5.51)
M4 by 12 deep 4 positions
Dimensions of mounting hole positions in base of unit
46.00 (1.81)
46.00 (1.81)
114.00 (4.48)
Dimensions for mounting holes when using mounting bracket kit
Dimensions in millimetres and (inches)
Product Information 29A-071486-1E
3
Mechanical specifications Driver headset (H/S) connector ASL206 05 SN Description
Value
Supply Voltage
Minimum 6V @ 400mA
Pin
Function
Nominal 12V @ 300mA Maximum 30V @ 275mA Over voltage protected @ 35V Protected at 35V
1
Electret Microphone +
2
Dynamic Microphone +
3 4 5
Microphone – Speaker – Speaker +
Operating Temp. Range
–20°C to +70°C
Storage Temp.Range Weight Environmental Mounting OR
–20°C to +80°C 300g IP65 AV mounting brackets on sides 4 M4 holes in base of PiCom
PC comms connector ASL606-05-SN-HE Pin Function Battery +ve
2
RS232 Data
From Intercom Doubles as CAN interface OR AUX input
3
RS232 Data
To Intercom Doubles as CAN interface OR AUX input
4
PC Present
RS232 (GND) AUDIO (12v) CAN (Open)
5
Power Ground
Ordering Information Description
Part Number
PiCom intercom kit
30A-504149
Kit 30A-504149 comprises: Description
Part number
Qty
PiCom intercom unit
01A-504142
1
PiCom to headset loom Mounting bracket kit AUX/MP3/CD Input loom Programming loom PicCom Set-up CD kit PiCom User Guide
60A-504154 13L-405058 60A-504152 60A-504153 01P-099075 29A-071481
2 4 1* 1* 1* 1*
* Quantity 1 per order. All items can be ordered as additional accessories. Connector details Connector
Type
Mating
Driver H/S
ASL206 05 SN
ASL606 05 PN
PC comms ASL606 05 SN HE ASL206 05PN HE Intercom AS210 35 SN AS610 35 SN Co-driver H/S ASL206 05 SN HE ASL606 05 PN When making connections make sure that ALL the polarities listed in ALL of the tables are followed.
4
Product Information 29A-071486-1E
Comment
1
Intercom connector AS210-35-SN Pin Function
Pin Function
1
Battery +
8
Radio Speaker –
2 3 4 5 6 7
Battery – GSM Speaker – Stage/Road Radio Microphone + Radio Microphone – Radio Speaker +
9 10 11 12 13
Camera Speaker + Camera Speaker – GSM Speaker + GSM Microphone + GSM Microphone –
Co-driver headset (H/S) connector ASL206-05-SN-HE
Pin
Function
1
Electret Microphone +
2 3 4 5
Dynamic Microphone + Microphone – Speaker – Speaker +
