Transcript
JEN JANG CO., LTD. Infrared body sensor module specifications for PIR-010 Product image:
Product outline: Automatic control products based on infrared body sensing technology, which is high sensitivity, reliability, ultra-low voltage operation mode. Otherwise it is widely used in various types of human movement automatically detect the induction lighting. Features: 1. Detect automatically: When people enter the sensing range, it will work immediately. This light will be off once the person who leaves the sensing range for several seconds (timer is adjustable). 2. Sensor output mode: Direct Drive 3. Brightness control: When standby mode, this light is slightly. 4. Brightness working time: when the person who leave the sensing range completely, this; lamp could back to standby mode immediately. 5. Power applicability: DC-isolated switching power supply, constant voltage DC switching power supply, adapter, battery, DC power supply. Wiring instructions:
Technical parameters: 1. Input voltage (power output no-load voltage): DC41 ~ 50V. 2. Acceptable power < 30W. 3. Output mode: Direct drive (drive voltage equal to input voltage) 4. Warm-up time: When the power is turned on; it will be shut down after 30 seconds lights and enter the sensor standby. 5. Quiescent Current: <50uA standby current: <500uA.
6. Delay operation: (jumper: Option S1 S2) Delay operation 5 seconds 30 seconds 1 minutes S1
shot
open
shot
S2
shot
shot
open
7. Brightness of LED standby: (jumper: Option S3 S4) Brightness of LED 5 seconds 30 seconds 1 minutes S3
shot
shot
open
S4
shot
open
shot
8. Induction: Repeat triggered. 9. Ceiling induction range: ≤ 140 ° cone angle, within a radius of 3.5 m. Installation height: 2.5M ~ 3M. 10. Working temperature: -20～+70°C 11. PCB Dimension: 600mm*200mm 12. Sensor lens size (diameter): insert plate - 21mm (OD) * 16.5mm (H).
