Podium Pro Audio Operations Manual – Pp1210

Transcript

Connections: There are two ways for you to hook up your PP1210. There are two ¼” jacks and also two Speakon jacks for connection. The jacks are wired in parallel, which allows you to daisy chain additional speakers. Therefore, you can use one amplifier channel to power multiple speakers. Make sure that the wires you are using are 14 gauge or thicker (the lower the number the thicker the wire) unshielded speaker cable. Do not use shielded instrument cables. Hooking speakers up in parallel decreases the overall impedance, placing a greater load on the amplifier. Check your amplifier’s specifications to ensure that you are not overloading the channel. Caution: DO NOT USE MORE THAN ONE JACK AS AN AMPLIFIER INPUT. DOING SO WILL DAMAGE THE SPEAKER. Technical Parameters: Rated power – 250 watts Max Power – 750 watts Connection: 2XSPK4, 2X ¼” jacks Dimension : 16.75” x 12.75” x 23.6” Net Weight: Approximately 39 pounds Troubleshooting: No Sound: • Check the connections • Try a different speaker cable • Confirm amplifier is getting a signal (check signal LED or use headphone output) PODIUM PRO AUDIO OPERATIONS MANUAL – PP1210 Professional 12” ABS Plastic Speaker System Introduction: Congratulations on your purchase of Podium Pro Audio’s 12” speaker system. This state of the art speaker is designed to give you years of high performance enjoyment. Please read this operations manual in its entirety to maximize your speakers performance. Safety and Maintenance: • Do not expose the speaker to moisture. • Avoid hot and cold temperature extremes. • Clean using a damp cloth. Make sure that no moisture contacts the driver. • Do not attempt to service the unit yourself. Please contact a Podium Pro Audio service technician. Features: 1. High efficiency system with high SPL and low distortion. 2. Extremely rugged low resonance plastic enclosure. 3. Integrated suspension points and socket for pole or stand mounting. 4. 12” long throw woofer with high power motor structure. 5. Signal can be passed through to drive another speaker. 6. 6dB per octave crossover with tweeter protection. Intermittent Output: • Check the connections • Try a different speaker cable Weak Bass response: • Check the polarity of the speaker connection. It may be reversed. • Listen with headphones to confirm the amplifier is being sent a good signal. INPUT SPK4 or 1/4” JACK OUTPUT SPK4 or 1/4” JACK Distorted sound: • Check if the amplifier is overdriven. If so, turn the level down. • Make sure you are not exceeding the RMS rating of your speaker. Audio at its highest level Podium Pro Audio http://www.podiumproaudio.com Podium Pro Audio